Panasonic Monitor Bt Lh1760p Owners Manual

							41
Error and Warning Displays
If for any reason an error occurs in this monitor, the LEDs above the picture adjusting knob flash at 1-second
intervals to inform of the error/warning. 
Maintenance
 Clean the cabinet and protection panel by gently wiping it with a soft cloth. 
To remove stubborn soiling, use a cloth dampened in a weak neutral detergent solution and thoroughly wrung
out. Then wipe with a dry cloth. Any moisture entering the monitor could damage it. 
 Do not use benzene, thinner and similar solvents for cleaning. 
They could discolor the surface and cause the paint to peel. 
 Do not directly expose the monitor to spray cleaning. 
Any moisture entering the monitor could damage it. Error and Warning 
displaysSymptom Remedy
Inverter error
If a malfunction occurs in the inverter that 
controls backlight brightness, the 
backlight goes off and the screen turns 
black.Turn off the power and then turn it back 
on. If the problem still persists, consult 
your dealer. 
Warning of drop in 
external DC input 
voltage/low voltageA “LOW VOLTAGE” indication in blue 
flashes on the screen. 
This means that the external DC power 
supply input voltage has dropped to 
approximately 11.3 V or less. If you use a battery pack as an 
external DC power supply, replace it 
with a fully charged battery pack. 
Connect an external DC power supply 
providing 11.0 V or more. Set the 
POWER switch to the off position and 
then set it to the on position again.  The “LOW VOLTAGE” indication flashes 
in red on the screen and the power is 
turned off approximately 4 seconds later. 
This means that the external DC power 
supply input voltage has dropped below 
11.0 V.  
						

							42
Specifications
■General
Input power
is the safety information.
Dimensions:
 Including stand
430 (W) mm × 323.5 (H) mm × 198 (D) mm
[16 15/16 (W) inches × 12 3/4 (H) inches × 7 13/16 (D) inches]
 Main body only, not including stand
430 (W) mm × 309 (H) mm × 81.1 (D) mm
[16 15/16 (W) inches × 12 3/16 (H) inches × 3 3/16 (D) inches]
Mass:
 Including stand
7.1 kg (15.7 lb)
 Main body only, not including stand
6.2 kg (13.7 lb)
Operating temperature:
+5 °C to +35 °C (+41 °F to +95 °F)
Operating humidity:
20 % to 80 % (no condensation)
Storage temperature:
-20 °C to +60 °C (-4 °F to +140 °F)
■Panel
Size: 17.0 type
Aspect ratio:  15:9
Number of pixels:  1280 × 768 (WXGA)
Display colors:  Approx. 16,770,000 colors
View angle:  176° up/down, 176° right/left
■Input/output Connectors
Image signal input:
VIDEO:
1 line, BNC × 2
(1 connector with through-out configuration)
Analog component:
1 line for YP
BPR/RGBS, BNC × 8
(4 connectors with through-out configuration)
However, when input is RGB-COMP. this becomes
BNC × 5 (R, G, B, HD, and VD).
(Through-out is not available)
SDI:
Compliant with SMPTE 274M, 296M, 259M-C and
ITU-R BT.656-4
2 lines, BNC × 3
(1 connector with switched-out configuration)
DVI-D (HDCP compatible): TMDS single link
1 line, DVI-D × 1
Vertical frequency: 50.0 - 60.0 Hz
Horizontal frequency: 31.5 - 67.5 kHz
Dot clock: 25 - 165 MHz
Audio input: Pin jack × 2 (stereo)
Headphone output: Stereo minijack M3 × 1
GPI:  D-SUB, 9 pins × 1
RS-232C:  D-SUB, 9 pins × 1
DC input:  XLR, 4 pins × 1■Signal level
VIDEO
EXT SYNC signal level:  0.3 Vp-p to 4.0 Vp-p
HD/VD signal level:  TTL level
AUDIO
AUDIO input level:  0.5 Vrms
Speaker output:  0.5 W + 0.5 W
Headphone output: 32 Ω, level adjustable
■SDI embedded audio
HD-SDI: SMPTE299M compatible
Sampling rate: 48 kHz, synchronous/asynchronous
8 ch
SD-SDI: SMPTE272M compatible
Sampling rate: 48 kHz, synchronous
4 ch
■Standard accessories

Operationg instructions × 1
Warranty (Card) × 1
Powe r c o r d  × 1
Power cord hook × 1
Screw × 1

Operationg instructions × 1
AC mains lead × 2
AC mains lead hook × 1
Screw × 1
■Optional units
Rack Mount Adaptor
BT-MA1710G
Wall Mount Adaptor
BT-WMA17G
Protection Panel
BT-PRP17G AC:
DC:Power supply:
100 V - 240 V, 50/60 Hz
12 V (11 V - 17 V)Power consumption:
0.6 A - 0.3 A
4.0 A
Inrush current, measured according to European standard
EN55103-1: 5.62A 
						

							43
Specifications (continued)
■ List of compatible signal formats ( : Compatible,  : Limited compatibility)
*1 When 1035/59.94I signal is input, displayed as 1080/59.94I. Other various marker displays will use the 1080/
59.94I marker.
*2 When 1035/60I signal is input, displayed as 1080/60I. Other various marker displays will use the 1080/60I
marker.
Weight and dimensions when shown are approximately. 
Specifications are subject to change without notice.
Input signal formats VIDEO SDI1 SDI2 YPBPRRGB-VIDEO RGB-COMP. DVI VIDEO DVI COMP.
NTSC
PA L
480/59.94I
480/59.94P
576/50I
576/50P
720/50P
720/59.94P
720/60P
1035/59.94I
*1 *1 *1 *1
1035/60I*2 *2 *2 *2
1080/23.98PsF
1080/24PsF
1080/23.98P
1080/24P
1080/25P
1080/29.97P
1080/30P
1080/50I
1080/50P
1080/59.94I
1080/60I
1080/59.94P
1080/60P
640 × 400 (70 Hz)
640 × 480 (60 Hz)
640 × 480 (75 Hz)
640 × 480 (85 Hz)
800 × 600 (60 Hz)
800 × 600 (70 Hz)
800 × 600 (75 Hz)
800 × 600 (85 Hz)
1024 × 768 (60 Hz)
1024 × 768 (70 Hz)
1024 × 768 (75 Hz)
1024 × 768 (85 Hz)
1280 × 768 (50 Hz)
1280 × 768 (60 Hz)
1280 × 768 (75 Hz)
1280 × 1024 (60 Hz) 
						

							© 2008 Matsushita Electric Industrial Co., Ltd. All Rights Reserved.
EP
Panasonic Broadcast & Television Systems Company
Unit Company of Panasonic Corporation of North America
Executive Office:
One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7000
EASTERN ZONE:
One Panasonic Way 4E-7, Secaucus, NJ 07094 (201) 348-7196
Southeast Region: (201) 348-7162
WESTERN ZONE:
3330 Cahuenga Blvd W., Los Angeles, CA 90068 (323) 436-3500
Government Marketing Department:
One Panasonic Way 2E-10, Secaucus, NJ 07094 (201) 348-7587
Broadcast PARTS INFORMATION & ORDERING:
9:00 a.m. – 5:00 p.m. (EST) (800) 334-4881/24 Hr. Fax (800) 334-4880
Emergency after hour par ts orders (800) 334-4881
TECHNICAL SUPPORT:
Emergency 24 Hour Service (800) 222-0741
Panasonic Canada Inc.
5770 Ambler Drive, Mississauga, Ontario L4W 2T3 (905) 624-5010
Panasonic de Mexico S.A. de C.V.
Av angel Urraza Num. 1209 Col. de Valle 03100 Mexico, D.F. (52) 1 951 2127
Panasonic Puerto Rico Inc.
San Gabriel Industrial Park, 65th Infantry Ave., Km. 9.5, Carolina, Puerto Rico 00630 (787) 750-4300 Information on Disposal for Users of Waste Electrical & Electronic Equipment (private households)
This symbol on the products and/or accompanying documents means that used electrical and electronic products 
should not be mixed with general household waste.
For proper treatment, recovery and recycling, please take these products to designated collection points, where they will 
be accepted on a free of charge basis. Alternatively, in some countries you may be able to return your products to your 
local retailer upon the purchase of an equivalent new product.
Disposing of this product correctly will help to save valuable resources and prevent any potential negative effects on 
human health and the environment which could otherwise arise from inappropriate waste handling. Please contact your 
local authority for further details of your nearest designated collection point.
Penalties may be applicable for incorrect disposal of this waste, in accordance with national legislation.
For business users in the European Union
If you wish to discard electrical and electronic equipment, please contact your dealer or supplier for further information.
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for the correct method of disposal.
Professional & Broadcast IT Systems Business Unit Europe
Panasonic AVC Systems Europe a Division of Panasonic Marketing Europe GmbH
Hagenauer Str. 43, 65203 Wiesbaden-Biebrich Deutschland Tel: 49-611-235-481