Home > Runco > Projector > Runco Cl 510 Projector User Manual

Runco Cl 510 Projector User Manual

Here you can view all the pages of manual Runco Cl 510 Projector User Manual. The Runco manuals for Projector are available online for free. You can easily download all the documents as PDF.

Page 31

6. Additional Information Runco CL-510/ CL-510LT User’s Manual28
Troubleshooting
7. Put on the front 
lamp cover.8. Tighten the screw of 
front lamp cover.
9.  Turn on the power and 
go into the Set Up menu 
to reset the Lamp 
Timer item.
Problem Possible Cause Remedy
This unit does not 
turn on.There is no power from power cable. Plug the power cord into the AC inlet on the 
rear of this unit, and plug the power cord into 
to the power inlet.
The power switch is not turned on. Turn on the power switch....

Page 32

6. Additional Information Runco CL-510/ CL-510LT User’s Manual29
Specifications 
CL-510/ CL-510LT Specifications
Projector Type:  Digital Light Processing™ (DLP™), Single Matterhorn DMD™ Chip
Native Resolution:  1024 x 576, (16:9)
Aspect Ratios:4:3, Letterbox, 16:9, Anamorphic, Virtual Wide
Video Standards:NTSC, PAL
DTV Compatibility:480p, 720p, 1080i
Scan Frequency:Horizontal: 15-80 kHz
Vertical: 50-100 Hz
Picture Size (16:9 Screen):Recommended Width: 72-96 in.            
Maximum Width:  200 in. 
Throw...

Page 33

6. Additional Information Runco CL-510/ CL-510LT User’s Manual30*ANSI Lumen specification:
This is the typical projector luminosity (brightness) specification found in most sales literature.  This measurement is 
included in RUNCO literature to allow for direct comparison with other manufacturers projectors.  These 
measurements can be taken at 9,000 to 13,000 degree Kelvin to get expected performance data when the projector is 
used in professional, commercial, and industrial displays.
**CSMS Home...

Page 34

6. Additional Information Runco CL-510/ CL-510LT User’s Manual31
Dimensions 
Unit: in. (mm) 

Page 35

6. Additional Information Runco CL-510/ CL-510LT User’s Manual32
RS-232 Setup
Baud Rate: 115200 or 9600
Parity: None
Data Bits: 8 Bits
Stop Bits: 1 Bit
Flow Control: None
RS-232C Control Codes 
Code Function
X01 Power On
X02 Power Off
X03 Message On
X04 Message Off
X10 Menu (arrow key)
X11 Enter (arrow key)
X12 Exit (arrow key)
X13 Up (arrow key)
X14 Down (arrow key)
X15 Left (arrow key)
X16 Right (arrow key)
X20 Switch to Composite input
X21 Switch to S-Video input
X22 Switch to Component input
X23...

Page 36

Runco International .2900 Faber Street .Union City, CA 94587 .ph (510) 324-7777 .fax (510) 324-9300 .www.runco.com
RUMA-010300 rev 7-03 
Start reading Runco Cl 510 Projector User Manual

Related Manuals for Runco Cl 510 Projector User Manual

All Runco manuals