Samsung Ht Db750m Instruction Manual

40
435
8
Press RETURNbutton to return to the previous level.
Press MENUbutton to exit the setup screen.
Press MENUbutton.
Press Cursor
button to move to
‘Setup’ and then
press ENTERbutton.Press Cursor
button to move to
‘LOGO’ and then
press ENTERbutton.
Press OPEN/CLOSE
button to open and then
close the disc tray.
DVDVCDJPEGTo Change the Wallpaper
1During playback, press
PLAY/PAUSEbutton when
you see an image you like.Press LOGObutton.
•LOGO COPYING will be displayed
on the TV screen followed by
LOGO...

21
43
Setting the Speaker Mode
Press MENUbutton.
Press Cursor
button to move to
‘Audio’ and then
press ENTERbutton.
In the Speaker
Setup, press the
ENTERbutton again.Press Cursor     ,     , 
,    buttons to move
to the desired
speaker and then
press ENTERbutton.
•For C, LS, and RS, each time the button
is pressed, the mode switches
alternately as follows: SMALL ➝ NONE.
•For L and R, the mode is set to SMALL.
•With           (Dolby Pro Logic II), the delay time may be different for each
mode.
•With AC-3...

Setting the Test Tone
L: Front Speaker (L) C: Center Speaker SW: Subwoofer 
R: Front Speaker (R) LS: Rear Speaker (L) RS: Rear Speaker (R)
Press RETURNbutton to return to the previous level.
Press MENUbutton to exit the setup screen.
42
SETUP
21Press MENUbutton.
Press Cursor
button to move to
‘Audio’ and then
press ENTERbutton.
3
Press Cursor      button
to move to ‘TEST
TONE’ and then press
ENTERbutton.
•The test tone will be sent to L ➝ C ➝
R ➝ RS ➝ LS ➝ SW in that order. 
If the button is pressed...

Setting the Delay Time
43
Setting up the Speaker Delay Time
When 5.1CH Surround Sound is played, you can enjoy the best sound if
the distance between you and each speaker is the same. Since the sounds
arrive at the listening position at different times depending on the
placement of speakers, you can adjust this difference by adding a delay
effect to the sound of the Center Speaker and Surround Speakers.
21Press MENUbutton.
Press Cursor     button
to move to ‘Audio’ and
then press ENTER
button....

44
5.3 ms
10.6 ms 
15.9 ms
• Setting REAR (SURROUND) SPEAKERS
If the distance of Df is equal to the distance of Ds
in the figure, set the mode as 0ms. Otherwise,
change the setting according to the table. • 
Setting CENTER SPEAKER
If the distance of Dc is equal to or longer than
the distance of Df in the figure, set the mode as
0ms. Otherwise, change the setting according to
the table.
Distance between Df and Dc  Delay Time
Delay Time
1.3 ms
2.6 ms 
3.9 ms
5.3 ms
Distance between Ds and Dc
50
100
150...

45
Setting the Audio Quality
You can adjust the balance and level for each speaker.
21
43
Press MENUbutton.
Press Cursor     
button to move to
‘Audio’ and then press
ENTERbutton.
Press Cursor      button
to move to ‘SOUND
EDIT’ and then press
ENTERbutton.Press Cursor      ,      , 
,      buttons to select
the desired item and then
press ENTERbutton.
Method 1When adjusting the audio quality using the setup screen
Press RETURNbutton to return to the previous level.
Press MENUbutton to exit the setup...

Adjusting Front/Rear Speaker Balance
•You can select between 00 and –06 and OFF.
•The volume decreases as you move closer to –6.
Adjusting Center/Rear/Subwoofer Speaker Level
•The volume level can be adjusted in steps from +6dB to –6dB.
•The sound gets louder as you move closer to +6dB and smaller as you get closer to -6dB.
Method 2When manually adjusting with the SOUND EDIT button
21
Adjusting Front Speaker BalanceAdjusting Rear Speaker Balance
Press SOUND
EDITbutton and
then press Cursor    
,     .
3...

47
Setting the DRC (Dynamic Range Compression)
You can use this function to enjoy Dolby Digital sound when watching movies at
low volume at night.
12Press MENU
button.
Press Cursor
button to move to
‘Audio’ and then
press ENTER
button.
 31P~68P(DB750)-GB  2004.9.16  8:44 AM  Page 52
 

48
•The longer the Cursor      button is held
down, the greater the effect, and the
longer Cursor      button is held down,
the smaller the effect.
•Once the setup is complete, you will be
taken to the previous screen.
34
Press Cursor
button to move to
‘DRC’ and then
press ENTER
button.Press Cursor     
,     to adjust
the ‘DRC’.
Press RETURNbutton to return to the previous level.
Press MENUbutton to exit the setup screen.
SETUP
 31P~68P(DB750)-GB  2004.9.16  8:44 AM  Page 53
 

49
Auto Sound Calibration Setup
Auto Sound Calibration
By setting the auto sound calibration function just once when you relocate or install the unit, you can have
the unit automatically recognize the distance between speakers, levels between channels, and frequency
characteristics to create 5.1-channel sound field optimized for the listeners environment.
L: Front Speaker (L) R: Front Speaker (R)
C: Center Speaker  SW: Subwoofer
LS: Rear Speaker (L) RS: Rear Speaker (R)
•S.LOGO ON or S.LOGO OFF appears...