Sharp Oz 290 Wizard Personal Organizer Instructions Manual

29
Synchronization SoftwareAfter the Serial Port Setup is
complete, the Settings window will
appear.
To bring up the Settings window
manually, right-click on the
Synchronization icon on the
Windows
® system tray, then select
Settings... in the menu.
General tabThis tab allows you to select the application that you want to
synchronize with the PC.
•   Click on the checkbox for each application to enable synchroni-
zation.
•   Use the Option... button, or double-click the desired settings
row to configure...

30
Desktop UtilitiesLaunch Desktop Utilities from the
Start menu, or right-click on the
Synchronization icon on the Windows
®
system tray, then select Desktop
Utilities... in the menu. Utilize the
Desktop Utilities via the following
graphic interface:Backup/RestoreThe Backup/Restore menu of the Desktop Utilities allows you to make a
backup file of the unit data, or to restore it back to the internal memory of
the unit. Be noted that the setup parameters wont be backed up.•Backup: Select “Backup...” from...

31
Battery ReplacementBatteries used
Type Model Quantity       UseLithium battery CR2032 2Unit operation
and backlighting
•Be sure to write down any important information stored in the
memory before replacing the batteries.PrecautionsSince improper use of the batteries may cause leakage or
explosion, strictly observe the following instructions:
•If fluid from a leaking battery accidentally gets into your eyes, it
may result in serious injury. Should this occur, flush your eyes
with clean water and...

32Replacing the batteries•Make sure the power is turned off before replacing the batteries.
•Do not press 
o
 until the battery replacement procedure is
completed.
•Do not remove all of the batteries at once. Remove and replace
batteries one by one.
1. Press 
o
 to turn the power off.
2. Loosen the screw (turn counterclockwise) and
remove the battery holder cover on the back
of the unit.
3. Remove one used battery using a ball-point
pen or similar object.
•Do not use a mechanical pencil or sharp
pointed...

33
Anniversary mode:Entry and recall of month, day and description
of anniversaries
To Do mode:Entry and recall of To Do listings (Due Date,
Priority and Description)
Memo mode:Entry and recall of memo listings
Expense mode:Entry and recall of Expense listings (Date,
Category, Amount, Payment, Receipt and
Memo) and Summary Report during a specified
period to display the total amount spent in a
preset category, Meals, Hotel, Car, Phone,
Fares, Entertainment, Tips and Miscellaneous,
that can be changed...

34AppendixNames and zone numbers of the cities in the clockZone No. City
0 TONGA
1 AUCKLAND
WELLINGTON
2 NOUMEA
3 GUAM
SYDNEY
3. 3 ADELAIDE4 TOKYO
5 SINGAPORE
HONG KONG
BEIJING
6 BANGKOK6. 3 YANGON7 DHAKA7. 3 DELHI8 KARACHI8. 3 KABUL9 DUBAI9. 3 TEHRAN
10 RIYADH
MOSCOW
Zone No. City
11 CAIRO
HELSINKI
12 BARCELONA
AMSTERDAM
ROME
BERLINPARIS
13 LISBONLONDON
14 AZORES ISLANDS
15––––––
MID ATLANTIC
16 RIO DE JANEIRO17 CARACAS
18 TORONTO
NEW YORK
19 CHICAGO20 DENVER21 LOS ANGELES22 ANCHORAGE23 HONOLULU
24...

35
Declaration of Conformity
Electronic Organizer : OZ-290
This device complies with Part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Responsible Party:
SHARP ELECTRONICS CORPORATION
Sharp Plaza, Mahwah, New Jersey 07430-1163
TEL: 1-800-BE-SHARP
Tested To Comply With FCC Standards
FOR HOME OR OFFICE USE...

36MEMO
OZ-290(En).pm6503.7.9, 0:20 PM 36 

S-1
Empleo del Organizador por primera vezAsegúrese de realizar las operaciones siguientes antes de emplear el
Organizador por primera vez.
1. Saque las hojas de aislamiento de las
pilas del compartimiento de las pilas
situado en la parte posterior de la
unidad.
El Organizador empieza a funcionar.
(Las hojas de aislamiento de las pilas
fueron insertadas en la fábrica para
impedir que se agoten las pilas.)
2. Pulse el interruptor RESET.
Se visualizará el mensaje “RESET?”.
3. Pulse 
f
, y luego 
x
.
Para...

S-2
2.  Utilizando 
k o m, seleccione un intervalo de tiempo deseado
(10, 20 o 30 segundos) y pulse 
x
.
Ajuste del contraste de LCD1. Pulse 
CLOCK/ALARM
 MENU
, seleccione “LCD CONTRAST”
utilizando 
k o m, y pulse 
x
.
2. Pulse 
k o m para oscurecer/iluminar el visualizador (entre 1 y
8).
3. Cuando termine, pulse 
x
.
Activación y desactivación del sonido de las teclas1. Pulse 
CLOCK/ALARM
 MENU
, seleccione “KEY TONE” utilizando
k o m, y pulse 
x
.
2. Seleccione la activación/desactivación de la...