Sharp Xv Z10e Projector User Manual

-59
Appendix
Computer Compatibility Chart
Note
•This projector may not be able to display images from notebook computers in simultaneous (CRT/LCD)
mode. Should this occur, turn off the LCD display on the notebook computer and output the display data in
“CRT only” mode. Details on how to change display modes can be found in your notebook computer’s
operation manual.
•When this projector receives 640 × 350 VESA format VGA signals, “640 × 400” appears on the screen.
•When projecting the RGB interlace signal...

-60
Cleaning the projector

Be sure to unplug the power cord before cleaning
the projector.

The cabinet as well as the operation panel is made
of plastic. Avoid using benzene or thinner, as these
can damage the finish on the cabinet.

Do not use volatile agents such as insecticides on
the projector.
Do not attach rubber or plastic items to the projec-
tor for a long time.
The effects of some of the agents in the plastic may
cause damage to the quality or finish of the projector.

Wipe off dirt gently...

-61
Appendix
1
2
STANDBY 
button
" "" "
" Bottom view
" "" "
" Front view
Air filter
(not removable)
STANDBY
button
User service screw
(for filter cover)
Ta bAir filterAir filter
Replacing the Air Filter
Cleaning and Replacing
the Air Filter
1Put the projector into the standby
mode, and disconnect the power
cord.
•Press  on the projector or  on
the remote control, and wait until the cool-
ing fan stops.
2Remove the filter cover on the
bottom of the projector.
•Turn...

-62
1
2
Replacing the Air Filter
4Clean the air filter.
•Clean the dust off the air filter and cover
with a vacuum cleaner extension hose.
5Replace the air filter.
•Place the air filter underneath the tabs
on the filter cover.
6Replace the filter cover.
•Align the tab on the filter cover and place
it while pressing the tab to close it (1).
Then tighten the user service screw (for
filter cover) (2) to secure the filter cover.
Note
•Be sure the filter cover is securely installed.
The power will not turn on...

-63
Appendix
Troubleshooting
Check
•Projector power cord is not plugged into the wall outlet.
•Power to the external connected devices is off.
•The selected input mode is wrong.
•The MUTE function is working.
•Cables incorrectly connected to rear panel of the projector.
•Remote control batteries have run out.
•The filter cover or the lamp unit cover is not installed correctly.
•Cables incorrectly connected to the rear panel of the projector.
•“Bright” is set to minimum position.
•“OSD Display” is set to...

-64
Troubleshooting
CheckProblemPage
Picture is green on
INPUT 1 COMPONENT.
Picture is pink (no green)
on INPUT 1 RGB.
Picture is dark.
Picture is too bright and
whitish.•Change the input signal type setting.•The lamp indicator is illuminating in red. Replace the lamp.
•Picture adjustments are incorrectly set.4452
42
XV_Z10E_E_p63_71.p6503.11.7, 4:19 PM 64 

-65
Appendix
Specifications
Projector
XV-Z10E
NTSC3.58/NTSC4.43/PAL/PAL-M/PAL-N/PAL-60/SECAM/
DTV480I/DTV480P/DTV540P/DTV580I/DTV580P/DTV720P/DTV1035I/DTV1080I/
DTV1080I-50
LCD panel × 3, RGB optical shutter method
Panel size: 0.54 (6.766 [H] × 12.012 [W] mm)
No. of dots:  409,920 dots (854 [H] × 480 [V])
1–1.25 × zoom lens, F1.6–1.9, f = 16.8–20.9 mm
130 W AC lamp
15-pin mini D-sub connector
Y: 1.0 Vp-p, sync negative, 75 Ω terminated
P
B: 0.7 Vp-p, 75 Ω terminated
PR: 0.7 Vp-p, 75 Ω terminated
520 TV...

-66
234.5
25
30.1
92
62
20720248.8 
49.7
5743.2
2.5
294
60.4
207.486.6
28.5
65
45
64.2195.6
647129
219
11 2
12.5
51
Side ViewSide View
Top View
Rear View
Front View
Bottom View
Dimensions
Units: mm
XV_Z10E_E_p63_71.p6503.11.7, 4:19 PM 66 

-67
Appendix
Glossary
Aspect Ratio
Width and height ratio of an image. The normal
aspect ratio of a computer and video image is 4:3.
There are also wide images with an aspect ratio
of 16:9 and 21:9.
Auto Sync
Optimises projected computer images by auto-
matically adjusting certain characteristics.
Background
Initial setting image projected when no signal is
being output.
CINEMA ZOOM
Mode that cuts out the top/bottom blank bands
and projects a wide screen image.
Clock
Clock adjustment is used to adjust...

-68 3 RCA to 15-pin D-sub cable ............................... 22
21 pin RCA conversion adapter .......................... 14
AC socket ............................................................ 20
Adjustment buttons .............................................. 29
Air filter ................................................................. 61
Aspect ratio .......................................................... 35
AUDIO INPUT terminal ........................................ 21
Auto Power Off...