Siemens Se 25m250 Instructions For Use

en
21
Additional functions
* on  some models additional functions
5 can be set with the buttons.
 Half load*
If  you have only a few items to wash (e.g.
glasses, cups, plates), you can switch to ªHalf loadº. The ªhalf loadº additional function saves water , energy and time. It is
recommended to put a little less detergentin the detergent dispenser than for a full load.
Maintenance  and care
A regular inspection and maintenance
of your machine will help to prevent faults. This saves time and prevents...

en
22
Filters The filters 
25
 prevent larger remnants of
food or other objects from getting inside the pump. This residue can occasionally clog up the filters. The filter system consists of a filter cylinder , a flat fine filter and, depending on
the model, a microfilter (*).
Inspect the filters for obstructions every time the dishwasher has been used.
By unscrewing the filter cylinder , you
can remove the filter system. Remove any food remnants and clean the filtersunder running water .
Reassembly:...

en23
Spray
 arms
Lime  and remnants of food in the washing
water can block the nozzles in the spray arms 
22  and 23 and the arm
mountings .
Inspect the nozzles in the spray arms for blocked holes due to remnants offood.
If necessary , pull the lower arm 23
upwards and lift it of f.
Unscrew the upper spray arm 22.
Clean both spray arms under running 
water.
0
1
2
3
Refit the spray arms. Ensure that the lower arm has locked into place and the upper one is screwed tight. Pump
 *
*  on applicable models...

en
24 Fault
 finding
Resolving  minor problems
yourself Experience  has shown that you can
resolve most problems that arise during normal daily usage yourself, without having to call out a service engineer . Not
only does this save costs, but it alsomeans that the appliance is available for use again that much sooner . The following
list of common occurrences and their remedies should help you identify the causes of most problems. Problems  ...
Attention
Remember:  Repairs may be carried out by
a...

en25
Refill display does not light up.
Rinse aid refill indicator switched off. (see auto 3in1 chapter)
Salt refill indicator switched of f.
(see auto 3in1 chapter)
W ater remains inside appliance
after programme has ended
Blockage or kink in drainage hose.
Pump is jammed.
Filters are blocked.
The programme is still running. W ait for the programme to end
(numerical display will indicate 0).
Perform ªResetº function.
...  during washing
Unusual  amount of foam is created
Normal washing up liquid has been...

en
26
Glasses have a dull appearance
Amount of rinse-aid was set too 
low.
T ea stains or traces of lipstick have
not been completely removed
Detergent does not have a suf ficient bleaching ef fect.
Washing temperature was set too
low.
T races of rust on cutlery
Cutlery is not suf ficiently rustproof.
Salt content in washing water is too high.
Lid on salt container is not screwed tight.
Too much salt was spilt while
filling container .
Glasses become clouded and discoloured; coating cannot be wiped off...

en27
Information
Notes  on comparison tests
You  will find details of the conditions for
the comparison tests on the additional ºNotes on comparison testsº sheet. The consumption values for the relevant programmes are given in the introduction. General
Built-under and integrated appliances which are subsequently installed as free-standing appliances must be secured to prevent them from falling over , e.g. by screwing them to the wall
or by installing them under a continuous worktop which is screwed to...

en
28
Fresh
 water connection
Using  the enclosed parts, connect the
fresh water connection to the tap according to the installation instructions. Ensure that the fresh water connection isnot kinked, crushed or twisted. When replacing the appliance, always connect a new water supply hose to the water supply . The old supply hose must
not be re-used. W ater pressure:
Minimum 0,05 MPa (0,5 bar) ± maximum 1 MPa (10 bar). If the water pressure is higher , install a
pressure reducing valve. Flow rate: Minimum...

en29
Waste
 disposal
Disposal Old  appliances are not worthless rubbish.
V aluable raw materials can be reclaimed
by recycling old appliances. Pull out the mains plug of the redundant appliance. Cut of f the power cord and
discard with mains plug.T o prevent children from locking
themselves in the appliance andsuf focating, destroy the door lock
and childproof lock (if fitted). Y ou received your new appliance in
a protective shipping carton. All packaging materials are environmentally friendly and...

en
30
en Subjekt to modification