Smeg Se210x 1 Manual

 Contents 
 
1. INSTRUCTIONS FOR SAFE AND PROPER USE _______________ 29 
2. INSTALLATION _________________________________________ 31 
3. DESCRIPTION OF CONTROLS ____________________________ 35 
4. USE OF THE OVEN ______________________________________ 41 
5. AVAILABLE ACCESSORIES _______________________________ 43 
6. COOKING HINTS ________________________________________ 44 
7. CLEANING AND MAINTENANCE ___________________________ 49 
8. ADDITIONAL MAINTENANCE ______________________________ 51...

Introduction   
1. INSTRUCTIONS FOR SAFE AND PROPER USE 
 
 
THIS MANUAL IS  AN INTEGRAL PART OF THE APPLIANCE AND 
THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE 
PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE 
CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS 
THEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED 
OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE 
REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC 
USES AND CONFORMS TO CURRENT  REGULATIONS...

 Introduction 
 
  
ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF) 
POSITION WHEN YOU FINISH USING THE OVEN. 
 
  
NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE 
ACCIDENTALLY CATCH LIGHT AND CAUSE FIRES. 
  
DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO 
TOUCH THE HEATING ELEMENTS INSIDE THE OVEN. 
  
THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND 
BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR FRAME. 
THE PLATE MUST NOT BE REMOVED.  
  
THE OVEN IS...

 
Instructions for the installer 
 
 
 31 
2. INSTALLATION 
 
2.1  Electrical connection 
 
Check that the mains voltage and power cable ratings are as per the 
information provided on the label attached to the oven door frame.   
This label must never be removed. 
 
 
It is obligatory for the electrical system to be earthed according to the 
methods required by safety rules. 
 
 
If a plug and socket connection is being used make sure that the plug 
and socket are compatible. Avoid use of adapters and...

 
 Instructions for the installer 
 
32 
         
  
 For operation on 220-240V ∼: use an 
H05RR-F / H05RN-F type three-core cable 
(3 x 4 mm2). 
 
 
 
For operation on 380-415V2N∼: use an 
H05RR-F / H05RN-F type four-core cable 
(4 x 2.5 mm2). 
 
 
 
 
For operation on 380-415V3N∼: use an 
H05RRF / H05RN-F type five-core cable  
(5 x 1.5 mm2). 
 
 
The cable end to be connected to the 
appliance must be provided with an earth 
wire (yellow-green) at least 20 mm longer.  
 
  
 
 The manufacturer...

 
Instructions for the installer 
 
 
 33 
2.2 Installing the oven 
The oven is designed for installation into any piece of furniture as long as 
it is heat-resistant. Proceed according to the dimensions shown in Figures 
1,  2 and 3 . For installing under a work top, follow the dimensions given in 
Figure  3. For installing under a work top beneath a hob with controls 
connected to the oven, ensure a minimum clearance from any side walls 
of at least 110 mm as shown in Figure  1.  
For installing in a...

 
 Instructions for the installer 
 
34 
  
  
 Never use the oven door to lever the oven into 
place when fitting. 
Avoid exerting too much pressure on the oven door 
when open. 
  
2.3  Connecting the hob to the oven 
Once installed, the hob must be con nected to the oven. Install the oven 
allowing enough room for the following operations to take place.
 
•   Connect the earth wire (yellow-green)  of the hob to the earth terminal 
A  of the oven (see figure). 
•  Fit the hob connectors into the...

 
Instructions for the user 
 
 
 35 
3. DESCRIPTION OF CONTROLS 
 
3.1  Front control panel 
All the oven controls are grou ped together on the front panel. 
 
5- FUNCTION MODEL  
  
6- FUNCTION MODEL  
  
  
8- FUNCTION MODEL  
  
  
10- FUNCTION MODEL  
   

 
 Instructions for the user 
 
36 
5- FUNCTION MODEL + HOB CONTROLS 
 
  
8- FUNCTION MODEL + HOB CONTROLS  
  
 
FUNCTION CONTROL KNOB  
(5/6/8/10 functions) 
Rotate the knob in either direction to select 
desired function from the following:  
 
 
  
NO FUNCTION SET 
  
DEFROSTING 
  
OVEN LIGHT (NO ELEMENT 
ENGAGED) 
  
UPPER AND LOWER 
HEATING ELEMENT + 
VENTILATION 
 
  
UPPER AND LOWER  HEATING ELEMENT   
FULL GRILL ELEMENT + 
VENTILATION 
  
GRILL ELEMENT 
 
VENTILATED  HEATING ELEMENT 
  
LOWER...

 
Instructions for the user 
 
 
 37 
THERMOSTAT CONTROL KNOB  
(multifunction oven) 
 
                        
Cooking temperature is selected by turning the knob clockwise to the 
desired setting, between 50° and 250°C. 
Maximum temperature in models with front glass panel is  260°C.   
THERMOSTAT INDICATOR LIGHT 
When this light comes on, the oven is heating up.  
When this light goes out, the preset heating 
temperature has been reached.  
When the light flashes, the temperature inside the 
oven is...