Sony Kdl 22ex310 Operating Instructions

4-288-091-11(2)
LCD 
Digital Colour TV
Operating Instructions
KDL-42EX410 / 32EX310 / 22EX310
 

2 GB
NOTICE FOR 
CUSTOMERS IN 
THE UNITED 
KINGDOM
A moulded plug complying with BS1363 
is fitted to this equipment for your safety 
and convenience.
Should the fuse in the plug supplied need 
to be replaced with the same rating of fuse 
approved by ASTA or BSI to BS 1362 (i.e., 
marked with   or  ) must be used.
When an alternative type of plug is used it 
should be fitted with the same rating of 
fuse, otherwise the circuit should be 
protected by a 10 AMP FUSE at the 
distribution board.
If the plug...

3 GB
Start-up Guide 4
Safety Information...........................................................................................................10
Precautions......................................................................................................................11
Overview of the remote ..................................................................................................13
Overview of the TV buttons and indicators...

4 GB
Start-up Guide
1: Checking the 
accessories
Table-Top Stand (1)*
Fixing screws for Table-Top Stand (M5 × 16) (3)  (for 
KDL-42EX410/KDL-32EX310)
Fixing screws for Table-Top Stand (M4 × 14) (2)  (for 
KDL-22EX310)
Assembling screws for Table-Top Stand (M6 × 14) 
(3)  (for KDL-42EX410/KDL-32EX310)
Assembling screws for Table-Top Stand (M5 × 8) (2) 
(for KDL-22EX310)
Hexagon wrench (1)  (for KDL-42EX410/KDL-
32EX310)
Stand rear cover (1)  (for KDL-22EX310)
Remote RM-ED046 (1)
Size AA batteries (2)
*...

5 GB
Start-up Guide
For KDL-22EX310
After all the screws are tightened, attach the 
supplied stand rear cover to the Table-Top 
Stand.
~ If using an electric screwdriver, set the tightening torque 
at approximately 1.5 N·m (15 kgf·cm).
3: Connecting an 
aerial/cable/VCR/DVD 
recorder
Stand rear cover
Coaxial cable
Connecting an aerial/cable only
Terrestrial signal
or cable
Connecting an aerial/cable/VCR/DVD recorder with 
SCART
Scart lead
VCR/DVD recorderCoaxial cableCoaxial cable
Terrestrial 
signal or...

6 GB
4: Preventing the TV 
from toppling over 
(KDL-42EX410/KDL-
32EX310 only)
1Install a wood screw (4 mm in diameter, 
not supplied) in the TV stand.
2Install a machine screw (M4×10, not 
supplied) into the screw hole of the TV.
3Tie the wood screw and the machine 
screw with a strong cord (not supplied).
5: Bundling the cables
~
 Before bundling the cables, remove the cable holder 
from the mains lead cover (see step 1 and 2).
Reuse the cable holder (see step 3) to bundle the other 
cables (see step...

7 GB
Start-up Guide6: Selecting the 
language, country/region 
and location
1Connect the TV to your mains socket 
(220-240V AC, 50Hz).
2Press 1 on the side of the TV.
When you turn on the TV for the first time, the 
Language menu appears on the screen.
~ 
 When you turn on the TV, the power indicator lights 
up in green.
3Press F/f/G/g to select the language 
displayed on the menu screens, then
press
 .
4Follow the on-screen instructions to 
select the country/region in which you will 
operate the TV.
If...

8 GB
7: Auto-tuning the TV
1Press G/g to select “Start”, then press  .
2Press F/f to select “Antenna” or “Cable”, 
then press  .
If you select “Cable”, the screen for selecting the 
scan type appears. See “To tune the TV for 
Cable connection” (page 8).
The TV then starts searching for all available 
digital channels, followed by all available 
analogue channels. This may take some time, so 
do not press any buttons on the TV or remote 
while proceeding.
If a message appears for you to confirm the...

9 GB
Start-up GuideAdjusting the viewing 
angle of the TV (KDL-
42EX410/KDL-
32EX310 only)
This TV can be adjusted within the angles 
shown below.
~ 
 When adjusting the angle, hold the stand with one hand 
to avoid having the stand slip or TV tip over.
Detaching the Table-
Top Stand from the TV
~ 
 Do not remove the Table-Top Stand for any reason other 
than to wall-mount the TV.
For KDL-42EX410/KDL-32EX310
For KDL-22EX310
z 
 Be sure the TV is on the vertical position before 
switching on. TV set must...

10 GB
Safety 
Information
Installation/Set-upInstall and use the TV set in accordance 
with the instructions below in order to 
avoid any risk of fire, electrical shock or 
damage and/or injuries.
Installation The TV set should be installed near an 
easily accessible mains socket.
 Place the TV set on a stable, level 
surface.
 Only qualified service personnel should 
carry out wall installations.
 For safety reasons, it is strongly 
recommended that you use Sony 
accessories, including:
– Wall-mount...