Stiga PARK UNLIMITED, PRESIDENT, POWER, EXCELLENT Swedish Version Manual

51
DEUTSCHDE
5.8.3 Demontage/Montage
Die Batterie befindet sich unter der Motorhaube. 
Bei einer Demontage/Montage gilt Folgendes für 
den Anschluss der Kabel:
• Bei der Demontage: Trennen Sie zuerst das 
schwarze Kabel vom Batterieminuspol (-). 
Trennen Sie danach das rote Kabel vom Batter-
iepluspol (+).
• Bei der Montage: Verbinden Sie zuerst das rote 
Kabel mit dem Batteriepluspol (+). Verbinden 
Sie danach das schwarze Kabel mit dem Batter-
ieminuspol (-).
Wenn die Kabel in der umgekehrten...

52
DEUTSCHDE
5.12 SchmierungSämtliche Schmierpunkte entsprechend der fol-
genden Tabelle sind alle 50 Betriebsstunden sowie 
nach jedem Waschen zu schmieren. 
5.13 SicherungenWenn einer der unten aufgeführten Fehler auftritt, 
ist die entsprechende Sicherung auszuwechseln. 
Siehe Abb. 13.
6 PATENT- UND MUSTER-SCHUTZ
Dieses Gerät oder Teile von ihm unterliegen fol-
gendem Patent- und Musterschutz:
SE9901091-0, SE9901730-3, SE9401745-6, 
US595 7497, FR772384, DE69520215.4, 
GB772384, SE0301072-5,...

53
ENGLISHEN
1 GENERAL
This symbol indicates WARNING. Seri-
ous personal injury and/or damage to 
property may result if the instructions 
are not followed carefully.
You must read these instructions for use 
and the accompanying pamphlet 
“SAFETY INSTRUCTIONS” careful-
ly, before starting up the machine.
1.1 SYMBOLSThe following symbols appear on the machine. 
They are there to remind you of the care and atten-
tion required during use and maintenance.
This is what the symbols mean:
Warning!
Read the...

54
ENGLISHEN
2.4.3 Inhibitor, parking brake (3:A)
The inhibitor locks the “clutch-brake” 
pedal in the depressed position. This func-
tion is used to lock the machine on slopes, 
during transport, etc., when the engine is 
not running.
The parking brake must always be re-
leased during operation.
Locking:
1. Depress the pedal (3:B) fully. 
2. Move the inhibitor (3:A) to the right.
3. Release the pedal (3:B).
4. Release the inhibitor (3:A).
Unlocking:
Press and release the pedal (3:B).
2.4.4...

55
ENGLISHEN
2.4.10 Power take-off (4, 5, 6:K)
A lever for engaging and disengaging the power 
take-off for operating front-mounted accessories. 
Two positions:
1. Lever in forward position – power take-
off disengaged.
2. Lever in backward position - power 
take-off engaged. 
2.4.11 Hour meter (2:P)
Indicates the number of working hours. Only 
works when the engine is running.
2.4.12 Cutting height adjustment 
(6:J)(Excellent)
The machine is equipped with a control for using 
the cutting deck with...

56
ENGLISHEN
The maximum over-run load on the towing hitch 
from towed accessories must not exceed 500 N.
NOTE! Before using a trailer – contact your insur-
ance company.
NOTE! This machine is not intended to be driven 
on public roads.
4 STARTING AND OPERATION
The machine may not be operated un-
less the engine casing is closed and 
locked. Risk of burns and crushing in-
juries.
4.1 Filling with petrolAlways use lead-free petrol. You must never use 2-
stroke petrol mixed with oil.
The tank holds 12...

57
ENGLISHEN
4.4.2 Electrical safety check
The operation of the safety system 
should always be checked every time 
before use.
4.5 Start1.  Open the fuel cock. See 14.
2.  Check that the spark plug cable(s) is/are in-
stalled on the spark plug(s).
3.  Check to make sure that the power take-off is 
disengaged. 
4.  Do not keep your foot on the drive pedal. 
5. Unlimited, President:
Starting cold engine – put the throttle control in 
the choke position. 
Starting warm engine – put the throttle control 
at...

58
ENGLISHEN
4.8 Cleaning
To reduce the risk of fire, keep the en-
gine, silencer, battery and fuel tank free 
from grass, leaves and oil.
To reduce the risk of fire, regularly 
check the machine for oil and/or fuel 
leakage. 
Clean the machine after each use. The following 
instructions apply for cleaning:
• When washing the machine with water under 
high pressure, do not point the jet directly at 
axle seals, electrical components or hydraulic 
valves.
• Do not spray water directly at the engine. 
•...

59
ENGLISHEN
Do not fill with too much oil. This can cause the 
engine to overheat. 
Change oil when the engine is warm.
The engine oil may be very hot if it is 
drained off directly after the engine is 
shut off. Therefore allow the engine to 
cool a few minutes before draining the 
oil.
1.  Attach the clamp on the oil drainage hose. Use 
a polygrip or similar. See fig. 15-17:Y.
2.  Move the clamp up 3-4 cm on the oil drainage 
hose and pull out the plug.
3. Collect the oil in a collection vessel.
NOTE!...

60
ENGLISHEN
5.8 Battery
If acid comes into contact with the eyes 
or skin, this can cause serious injuries. 
If any part of the body has come into 
contact with acid, rinse immediately 
with copious amounts of water and seek 
medical assistance as soon as possible.
The battery is a valve-regulated battery with 12 V 
nominal voltage. The battery fluid does not need to 
and cannot be checked or topped up. The only 
maintenance that is required is charging, for exam-
ple after extended storage.
The battery...