Stihl Fc 56 C Manual

FC 56 C
English
29
Maintenance and Care
The following intervals apply to normal operating conditions only. If your daily work-
ing time is longer or operating conditions are difficult (very dusty work area, etc.), 
shorten the specified intervals accordingly.
before starting work
after finishing work or daily
after each refueling stop
weekly
monthly
every 12 months
if problem
if damaged
as required
Complete machineVisual inspection (condition, leaks)XX
CleanX
Control handle Check operationXX
Air...

FC 56 C
English
30
Blade Visual inspectionXX
ReplaceX
Check tightness of bladeXX
Safety labels  ReplaceX
1)STIHL recommends an authorized STIHL servicing dealer. The following intervals apply to normal operating conditions only. If your daily work-
ing time is longer or operating conditions are difficult (very dusty work area, etc.), 
shorten the specified intervals accordingly.
before starting work
after finishing work or daily
after each refueling stop
weekly
monthly
every 12 months
if problem
if...

FC 56 C
English
31 1Loop Handle
2Wing Screw
3Carrying Ring
4Stop Switch
5Throttle Trigger Lockout
6Throttle Trigger
7Carburetor Adjusting Screws
8Choke Lever
9Air Filter Cover
10Spark Plug Boot
11Machine Support
12Fuel Tank
13Fuel Filler Cap
14Manual Fuel Pump
15Starter Grip
16Muffler with Spark Arresting Screen
17Cutting Blade
18Deflector
19Drive Tube
20Wheel
21Wingnut
22Gearbox
23Wear Guard
24Skirt
#Serial Number
Main Parts
22
23
24
17
19
20
21 
16
13
12
1514
8
7
11
3
6
549
101
2
#
545BA006 KN
18 

FC 56 C
English
32
Definitions
1 Loop Handle
For easy control of machine during 
cutting work.
2 Wing Screw (optional)
Locks loop handle in selected 
position.
3 Carrying Ring
Connects the edger to the harness.
4 Stop Switch
Switches the engine's ignition off 
and stops the running engine.
5 Throttle Trigger Lockout
Must be depressed before the 
throttle trigger can be activated.
6 Throttle Trigger
Controls the speed of the engine.
7 Carburetor Adjusting Screws
For tuning the carburetor.
8 Choke...

FC 56 C
English
33
EPA / CEPA
The Emission Compliance Period 
referred to on the Emissions 
Compliance Label indicates the number 
of operating hours for which the engine 
has been shown to meet Federal 
emission requirements.
Category
CARB
The Emission Compliance Period used 
on the CARB-Air Index Label indicates 
the terms:
Engine
Ignition System
Electronic magneto ignition
Fuel System
All position diaphragm carburetor with 
integral fuel pump
WeightUsers of this unit should carry out only 
the...

FC 56 C
English
34 Observe all country-specific waste 
disposal rules and regulations.
STIHL products must not be thrown in 
the garbage can. Take the product, 
accessories and packaging to an 
approved disposal site for environment-
friendly recycling.
Contact your STIHL servicing dealer for 
the latest information on waste disposal.STIHL Incorporated Limited Warranty 
Policy for Non-Emission-Related Parts 
and Components
This product is sold subject to the STIHL 
Incorporated Limited Warranty Policy,...

FC 56 C
English
35 Manufacturer's Warranty Coverage
In the U.S., 1997 and later model year 
small off-road equipment engines are 
warranted for two years. If any emission-
related part on your engine is defective, 
the part will be repaired or replaced by 
STIHL Incorporated free of charge.
Owner's Warranty Responsibilities
As the small off-road equipment engine 
owner, you are responsible for the 
performance of the required 
maintenance listed in your instruction 
manual. STIHL Incorporated...

FC 56 C
English
36 The following list specifically defines the 
emission-related warranted parts:
–Air Filter
–Carburetor (if applicable)
–Fuel Pump
–Choke (Cold Start Enrichment 
System) (if applicable)
–Control Linkages
–Intake Manifold
–Magneto or Electronic Ignition 
System (Ignition Module or 
Electronic Control Unit)
–Flywheel
–Spark Plug
–Solenoid Valve (if applicable)
–Injection Valve (if applicable)
–Injection Pump (if applicable)
–Throttle Housing (if applicable)
–Cylinder
–Muffler
–Catalytic...

FC 56 C
English
37 Manufacturer’s Warranty 
Responsibilities
This emissions control system is 
warranted for two years in California. If 
any emissions-related part on your 
equipment is defective, the part will be 
repaired or replaced by STIHL 
Incorporated free of charge.
Owner’s Warranty Responsibilities
As the small off-road equipment engine 
owner, you are responsible for 
performance of the required 
maintenance listed in your instruction 
manual. STIHL Incorporated 
recommends that you retain all...

FC 56 C
English
38that part. If the part fails prior to the 
first scheduled replacement, the 
part must be repaired or replaced by 
the engine manufacturer according 
to Subsection (4) below. Any such 
part repaired or replaced under 
warranty must be warranted for the 
remainder of the period prior to the 
first scheduled replacement point 
for the part.
4.Repair or replacement of any 
warranted part under the warranty 
must be performed at a warranty 
station at no charge to the owner....