Sunbeam Ylr2590hz3 Manual

Toll Free Tel / Tél. sans frais / Tel sin cargo: 
1 - 8 7 7 - 3 8 3 - 6 3 9 9
(8:30am-5:30pm E.S.T. / 8h30 à 17h30 H.N.E. / 8:30am-5:30pm E.S.T. E . )
s e rv i c e @ l i m a g e h o m e p roducts.com 
©2005 Sunbeam Products, Inc.All rights reserved.
is a registered trademark of Sunbeam Products, Inc.used under license.
Manufactured for Prestige Home Comfort, a subsidiary of the Elite Group Inc., Montreal, Canada, H3B 3X9.
©2005 Sunbeam Products, Inc.Tous droits réservés.
est une marque déposée de Sunbeam...

Congratulations on purchasing your new 
S u n b e a m
®
Water Dispenser!
Warnings & Precautions:
1 .Your water dispenser must be left upright for at least ten (10) hours, unplugged.During delivery and/or storage, the fluid 
inside the compressor will move.To avoid any damage to the unit, you must allow adequate time for the fluid to settle.
2 .B e fore placing water bottle on unit, be sure that the drain plug on the back is tightly fa s t e n e d .
3 .This unit should be placed with at least 4”/10cm...

ÍNDICE
TABLE DES MATIÈRES
TABLE OF CONTENTS
Electrical Safety ........................................2
Unpacking your water dispenser................3
Getting to know your water dispenser........3
Preparing your water dispenser for use......4
How your cooling compartment works..........4
Water dispenser maintenance....................5
Trouble-shooting guide..............................6
Specifications............................................7
Electrical...

- 2 -
ELECTRICAL SAFETY
When using electrical appliances, basic safety precautions should be followed to reduce the risk of
f i re, electric shock, and injury to persons or pro p e rt y. Read all instructions before using any appliance.
Do not let hot water touch bare skin. Keep combustible materials such as furniture, bedding,
pillows, clothes, and/or papers away from the back of the unit. 
Do not operate this, or any other appliance with a damaged cord. No other appliance should be
plugged into the...

1)Remove the water dispenser from the cardboard 
box without turning it upside down,or laying it 
on its side.
a.Remove the strapping.
b.Lift box from base.
c .Remove the styrofoam packing inserts from the box .
d.Pull the water dispenser straight up from 
sytrofoam base.
e.Remove the plastic bag.
The refrigeration compressor has very sensitive 
mounts inside of its welded shell in order to
provide quiet running.Improper handling may
damage the compressor.
2)Wipe it clean if necessary.
3)Find a location...

- 4 -
No. 0101
P R E PARING YOUR WATER DISPENSER FOR USE
HOW YOUR COOLING COMPA RTMENT WORKS
THE COOLING COMPARTMENT IS DESIGNED FOR EVEN COOLING.
Your water dispenser has two thermostats located at the back of the unit.
One thermostat controls the water and the other controls the cooling compartment.To start
the compressor,a signal from either of the two thermostats is required.
Your water dispenser also has three power switches located at the back of the unit.One
switch controls the hot water,one...

- 5 -
No. 0101
WATER DISPENSER MAINTENANCE
COOLING COMPA RTMENT 
CLEANING INSTRUCTIONS
1)To clean the unit,first unplug the power cord.
2)Allow the ice build-up to melt naturally.
NOTE:Do not use sharp objects or knives to remove ice buildup.
Do not use boiling water to remove ice.
3)The water will accumulate in the tray at the bottom of the compartment.
4)Remove the tray from the compartment and empty the water.
5)Wipe the compartment and the tray with a soft cloth dampened with liquid 
dishwashing...

- 6 -
No. 0101
TROUBLE-SHOOTING GUIDE
1 )The power switch for 
the cold & cooling 
compartment are 
turned on,but the 
c o m p ressor is not 
starting up.
1a)The power cord is plugged in properly.
1b)If the water dispenser is brought in from outside in the winter time,give it a few hours to warm up to room
t e m p e rature before plugging it in.The thermostat setting may be affected by the coldness of the water dispenser
itself or the bottled wa t e r.If the ambient (room) temperature is lower than the...

No. 0101
SPECIFICATIONS 
ELECTRICAL DIAGRAM
1.Protection diode for the LED indicator light
2.Cooling on LED indicator light
3.Diode for the LED indicator light
4.Resistor for the LED indicator light
5.Cold water & refrigeration power switch
6.Refrigeration thermostat for the cold water 
7.PTC starter for the compressor
8.Refrigeration Compressor
9.Fridge power switch
10.Refrigeration thermostat for the fridge 
11.Thermal protector for the refrigeration compressor
12.Protection diode for the LED indicator...

WARRANTY CONTROL CENTER
PLEASE PRINT LEGIBLY
SERIAL & MODEL NUMBER INFORMATION CAN BE FOUND ON (SILVER) UL
LABEL
PURCHASE DATE:DAY _______     MONTH _______     YEAR _______  
SERIAL NUMBER:___________________  MODEL NUMBER:___________
CUSTOMER NAME:____________________________________________________
ADDRESS:___________________________________________________________
CITY:______________________________ STATE/PROVINCE:_________________
POSTAL CODE / ZIP:____________ PHONE NUMBER:( _____ ) _____ -...