Surefire 308r, 608r Tactical Light User Manual

							Model 308R
608R
S & W Sigma Tactical Light
Users Manual
S & W Sigma Pistol
Protected by US. Patents 4,777,754,  4,856,218, & 5,654,594
Revision N/C    5_1_97 
						

							Model 308R & 608R Tactical Light
Introduction
   The Model 308R & 608R Tactical Light provides a rugged and reliable source of high intensity light
mounted below the barrel of the weapon. The light can be activated by pressing on the Slimline®
Momentary Switch positioned on the handgrip.
Kit Contents
! H08R Housing
! L30 or L60 Lamp Module
! DL123A or DL223AC Battery
! Hex Wrench
! Users Manual
Installation
1. Remove the magazine from the weapon and inspect the weapon to be certain it is not loaded.
2. Position the H08R Housing below the frame, forward of the trigger guard and the Slimline
     Switch against  the hand grip.
3. Position the Clamp Plate inside the trigger guard with the four holes aligned with the holes in
      the Housing.
4. Install four socket head screws through the Clamp Plate into the Housing. Insure that the spacing
     between the housing and the Clamp Plate is even on  each side of the trigger guard.
5. Tighten the four screws with the Hex Wrench provided in the Kit until the Housing is secure
     to the weapon. DO NOT OVER TIGHTEN THE SCREWS. The frame will distort and may
     impair the function of the weapon.
6. Install the Battery with the + terminal facing out.
7. Install the Lamp Module. The Tactical Light is now ready for use.
Lamp Replacement
1. Unscrew Bezel from Lamp Module. Lift Lamp assembly out of Bezel.
2. Install replacement Lamp Assembly in Bezel and reassemble by screwing onto Lamp Housing
     until it is fully seated.
Battery Replacement
1. Unscrew Lamp Module from Housing and shake out old battery.
2. Install new battery with the + terminal facing out.
3. Reinstall Lamp Module.
WARNING
Lithium batteries can explode or cause burns if disassembled,
shorted, recharged or exposed to fire or high temperatures.
Please handle with care. 
						

							SureFire LLC 
						

							Model 308R & 608R Tactical Light
Repairs & Replacements
     To obtain repair or replacement call Customer Service at 800-828-8809 (toll free) or 714-545-
9444 and obtain a Return Authorization number (RA). Then pack the unit carefully and return (no
COD’s please) to:
     SureFire LLC
     Repairs Department, RA# ___
     18300 Mt. Baldy Circle
     Fountain Valley, CA 92708
Surefire will pay any reasonable shipping costs to return the unit to you.
Warranty
     SureFire warrants that its products will be free from defects in materials and
workmanship. SureFire will repair or replace (at its option), without charge, any
product or part which is found to be defective under normal use and service. Such
repair or replacement shall be the purchaser’s sole and exclusive remedy under this
warranty. This warranty does not include normal maintenance and services and does
not apply to any products or parts which have been subject to modification, misuse,
negligence, accident, improper maintenance or repair by anyone other than SureFire.
“Fine Print” Warranty Limitation
     There is no other express warranty. SureFire hereby disclaims any and all implied
warranties, including, but not limited to fitness for a particular purpose. SureFire shall
not be liable for incidental, consequential, or special damages arising out of, or in
connection with product use or performance.
 Protected by US. Patents 4,777,754,  4,856,218,  & 5,654,594
               um_H08R_7.501 71-01-276
18300 Mt. Baldy Circle, Fountain Valley, CA 92708                 (714) 545-9444Caution
   The battery used in the light is very powerful. Be sure that the switch is not touching
anything when the light is stored. If the lamp is turned on while in a case or other container,
the lamp can overheat and damage the light or surrounding materials. Remove the battery or
unscrew the bezel far enough to prevent the lamp from turning on when stored.
   Do not use a 3 Volt Lamp Assembly in a 6 Volt system. The lamp will burn out Immedi-
ately!!! To identify a lamp assembly:  the 3 volt lamp has a Red label and is marked R30, the
6 volt has a Blue or Green label and is marked R60 or P60.
   If  it is necessary to dispose of any batteries, do not do so by fire, mutilation or by
disassembly, as this may cause toxic chemicals to be released.
WARNING
Lithium batteries can explode or cause burns if disassembled,
shorted, recharged or exposed to fire or high temperatures.
Please handle with care.