Surefire 310r, 610r Tactical Light User Manual

							Model 310R
610R
Colt Tactical Light
Users Manual
Colt Pistols
 
Government Model  45ACP
Revision A    4_1_99 
						

							Model 310R & 610R Tactical Light
Introduction
The Model 310R & 610R Tactical Lights provide a rugged and reliable source of high intensity
light mounted below the barrel of the weapon. There are two switches that can be used to
activated the light. Press on the SlimLine® Momentary Switch positioned on the handgrip and the
light will come ON and stay ON as long as pressure is applied. Operate the ON/OFF switch on
the left side of the Housing and the light will come ON and stay ON until the OFF switch is
pressed
Kit Contents
! H10R Housing & Slide Stop
! L30 or L60 Lamp Module
! DL123A or DL223AC Battery
! Extra Set Screw
!  Grip Screw (2)
! Hex Wrench
! Users Manual
* Additional set screws are available in a Ten Pack, order P/N 12010-11.
Installation
 1. Remove the magazine from the weapon and inspect the weapon to be certain it is not loaded.
 2. Disassemble weapon far enough to remove slide stop.
 3. With the left hand position H10R Housing so that hole in side is aligned with slide stop hole on
     the frame, With the right hand squeeze the SlimLine Switch around the hand grip being careful
     no to bend the switch wire at the attaching points.
 4. Install new Slide Stop provided in the Kit.
 5. Reassemble weapon as necessary.
 6. Using the Hex Wrench provided in the Kit, tighten the Set Screw in the base of the Housing
     until it contacts the trigger guard then turn the set screw out 1/8 turn so as not to puttension
     on the Slide Stop. After firing 500 rounds the Set Screw may loosen, remove it and install the
     extra Set Screw provided in the Kit.*
 7. Move the SlimLine Switch enough to expose grip screws. Using the appropriate screwdriver
     remove the grip screws from the left and right side of the handgrips.
 8. Install a screw from the Kit into the left side of the SlimLine Switch part way. (Caution, do
     not cross thread the screw). Then install a screw into the right side part way.
 9. Tighten the screws until snug. DO NOT OVER TIGHTEN.
10. Install the battery into the H10R Housing with the + terminal facing the Lamp.
11. Install the Lamp Module Assembly. Unit is now ready for use.
      Note:
      SlimLine Switches are for weapons with Factory Hand Grips only.
Lamp Replacement
 1. Unscrew Bezel from Lamp Module. Lift Lamp assembly out of Bezel.
 2. Install replacement Lamp Assembly in Bezel and reassemble by screwing onto Lamp Housing
     until it is fully seated.
Battery Replacement
 1. Unscrew Lamp Module from Housing and shake out old battery.
 2. Install new battery with the + terminal facing the lamp.
 3. Reinstall Lamp Module. 
						

							Sure-Fire LLC
WARNING
Lithium batteries can explode or cause burns if disassembled,
shorted, recharged or exposed to fire or high temperatures.
Please handle with care. 
						

							Model 310R & 610R Tactical Light
Repairs & Replacements
     To obtain repair or replacement call Customer Service at 800-828-8809 (toll free) or 714-545-
9444 and obtain a Return Authorization number (RA). Then pack the unit carefully and return (no
COD’s please) to:
     SureFire LLC
     Repairs Department, RA# ___
     18300 Mt. Baldy Circle
     Fountain Valley, CA 92708
Surefire will pay any reasonable shipping costs to return the unit to you.
Warranty
     SureFire LLC warrants that its products will be free from defects in materials and
workmanship. SureFire LLC will repair or replace (at its option), without charge, any
product or part which is found to be defective under normal use and service. Such
repair or replacement shall be the purchaser’s sole and exclusive remedy under this
warranty. This warranty does not include normal maintenance and services and does
not apply to any products or parts which have been subject to modification, misuse,
negligence, accident, improper maintenance or repair by anyone other than SureFire.
“Fine Print” Warranty Limitation
     There is no other express warranty. SureFire LLC hereby disclaims any and all
implied warranties, including, but not limited to fitness for a particular purpose.
SureFire LLC shall not be liable for incidental, consequential, or special damages
arising out of, or in connection with product use or performance.
um_H10R_9.401
18300 Mt. Baldy Circle, Fountain Valley, CA 92708                 (714) 545-9444Caution
   The battery used in the light is very powerful. Be sure that the switch is not touching
anything when the light is stored. If the lamp is turned on while in a case or other container,
the lamp can overheat and damage the light or surrounding materials. Remove the battery or
unscrew the bezel far enough to prevent the lamp from turning on when stored.
   Do not use a 3 Volt Lamp Assembly in a 6 Volt system. The lamp will burn out Immedi-
ately!!! To identify a lamp assembly:  the 3 volt lamp has a Red label and is marked R30, the
6 volt has a Blue or Green label and is marked R60 or P60.
   If  it is necessary to dispose of any batteries, do not do so by fire, mutilation or by
disassembly, as this may cause toxic chemicals to be released.
WARNING
Lithium batteries can explode or cause burns if disassembled,
shorted, recharged or exposed to fire or high temperatures.
Please handle with care.