Home > Teac > CD/DVD/Blu-Ray Drive > TeacCD Rewritable Drive W512S Owners Manual

TeacCD Rewritable Drive W512S Owners Manual

Add to Favourites
    Download as PDF

    View the TeacCD Rewritable Drive W512S Owners Manual for free. All the Teac manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Introduction TEAC CD-RW Installation Guide 1 Introduction The TEAC CD-RW drive can write to CD-R discs at a maximum of 12X speed, re- write to CD-RW discs at 10X speed, and read CD-ROM discs at 32X speed. (It is also capable of operating at slower speeds, if preferred.) CD-R discs enable you to create audio or data discs for permanent archival storage. They cannot be overwritten. You can overwrite CD-Rewritable (CD-RW) discs, typically up to 1,000 times. The TEAC CD-RW drive is a SCSI device...
    Page 2 Recommended System Requirements TEAC CD-RW Installation Guide 2 Front Panel disc tray: Use the disc tray to load CDs into the drive. You can open the tray by pressing the eject button or by using the emergency eject mechanism. You can close the tray by pressing the eject button. headphone jack: You can connect headphones or external speakers to this jack to listen to an audio CD being played on your TEAC drive. Use a 3.5 mm stereo mini-plug. For external speakers, connect a stereo...
    Page 3 Rear Panel TEAC CD-RW Installation Guide 3 Rear Panel analog audio output connector: You can use an audio cable to connect this connector to the audio input connector on a sound card. Pin assignments are described below: jumper pin configuration jumper: The CD-RW drive includes seven pairs of jumper pins on the rear panel that allow you to set the SCSI ID number, termination, and parity. interface connector: Use a standard 50-pin SCSI interface cable to connect the CD-RW drive to a SCSI...
    Page 4 Setting the SCSI ID Number TEAC CD-RW Installation Guide 4 Configuring the CD-RW Drive Before you can install and operate the TEAC CD-W512S CD-RW drive, you need to do the following: ❑ Install a SCSI adapter card in the host computer. For optimum performance, a PCI bus master SCSI adapter card (such as an Adaptec 2940 or equivalent) is recommended. Please refer to the SCSI adapter card documentation for installation instructions. ❑ Set the SCSI ID number on the rear panel of the CD-RW drive...
    Start reading TeacCD Rewritable Drive W512S Owners Manual
    All Teac manuals