THOMSON Dpl560ht User Manual

18
Operating your Receiver
RDS (Radio Data System) for FM Only
The RDSicon shows on display when RDS data are
received.  The following information may be available on
certain stations:
• Frequency station,
• Station name, 
• Program type, 
• Clock,
• Radio text
Press RDS MENUon the remote control repeatedly to
select the type of information you want to display.
Search Station by Program Type
1.  Press RDS PTYon the remote control repeatedly to dis-
play the desired program type.
2. PressTUNER UPor TUNER...

EN
19
Advanced Sound Control
Sound Enhancement Systems
This receiver is equipped with several built-in sound
enhancement systems.
Dolby Pro Logic 
This surround system reproduces theater-like sur-
round sound from Dolby-encoded software. The Pro
Logic mode uses the built-in circuit to steer the Left,
Center, Right and Surround channel audio signals and
uses all five speakers and an optional subwoofer to
play decoded Dolby Pro Logic program source, such
as TV and VCR. 
Dolby Digital 
The Dolby Digital...

20
Advanced Sound Control
Stereo
The Stereo mode uses the two main channel outputs
from the front speakers. Use this mode if you have
connected the front speakers only.  
DSP (Digital Sound Processor)
These digital sound effects resemble sounds in a real 
environment such as
(STADIUM/CONCERT/THEATRE/ARENA/CHURCH/CLUB/). DSP
automatically converts analog audio signals to digital
ones which enables you to adjust the sound without
degrading the sound quality. Different modes will
give you different feel of...

EN
21
Advanced Sound Control
Fine Setting of the Speakers 
This receiver supports a wide range of speakers and 
subwoofers. For optimal surround sound enjoyment,
you need to register the speaker selection settings of
your audio system. If you buy this receiver with
accompanied speaker package, then this step has
been done for you.
Also, to make the surround sound more effective and
suit the acoustic conditions in your listening room,
you need to delay the signal from some of the speak-
ers. Such channel...

22
Advance Sound Control
Use a subwoofer to enjoy optimum sound.
• Subwoofer Phase: Try both settings and select the
sound preferred.
• Speaker distance:For optimum surround experi-
ence measure the distance between the speaker and
your favorite listening position.
1.  Press SETUPonce.
2. While the VFD display is showing L/R SML, press
UP/DOWN ARROW button to select.
3. Press OKbutton once to move to the next 
speaker setting.
4. Repeat step 3 to set up the next speaker
5. When set up is done, wait for 5...

EN
23
Troubleshooting tips
Troubleshooting Tips
Receiver/Tuner Operation 
ST indicator is off.
•  Adjust the antenna.
•  Press DIGITAL INPUT/ST/MONObutton to insure
you are not outputting in mono.
The signal is Mono. Severe hum or noise.
• The signal is too weak. Connect an external anten-
na.
• Adjust Antenna
• Reposition Antenna away from any electronics.
Remote Control Operation 
The remote control does not operate the unit.
•  Another source mode is selected on the remote.
Press the correct Source...

24
Care and Maintenance
Disconnect the audio system from the power source before
performing any maintenance.
Cleaning
Clean the exterior of the system using a soft dust cloth.
Important battery information
• Remove the batteries to avoid leakage if you do not use
your remote control for more than one month.  
• Discard leaky batteries immediately as leaking batteries
may cause skin burns or other personal injuries. 
• Dispose of batteries in the proper manner, according to
provincial and local...