Vivitar Vivicam 2005 User Manual

 
 
 
   
 
Vivicam 2005  
User Manual 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
041227TP 
 1  

 
Preface 
Thank you for purchasing the Vivicam 2005.  Please read this manual carefully, it covers all 
camera functions and operations. 
 
FCC STATEMENT 
This device complies with Part 15 of the FCC Rules.  Operation is subject to the following two conditions: 
(1) This device may not cause harmful interference, and 
(2) This device must accept any interference received, including interference that may cause undesired operation 
Note: 
This equipment has been tested and found to comply with the limits...

 
SAFETY INSTRUCTIONS AND WARNINGS 
Read and understand all Warnings and Cautions before using this product. 
 If foreign objects or water have entered the camera, turn the power OFF and remove the batteries.  Continued 
use in this state might cause fire or electric shock. 
 If the camera has fallen or its case has been damaged, turn the power OFF and remove the batteries.  Continued 
use in this state might cause fire or electric shock. 
 Do not disassemble, change or repair the camera.  This might...

 
period of time.  The batteries may leak and cause a fire, injury or soiling of the battery compartment. If the batteries leak, 
clean and wipe the battery compartment carefully and install new batteries.  Wash your hands carefully if you touch the 
battery fluid.  When using batteries, carefully read and strictly observe the Safety Instructions and the notes described 
below: 
 
 Ni-MH rechargeable batteries are recommended.  To maximize performance and lifetime, we recommend that 
you fully charge...

 
1. Introduction 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
1.1 Features 
LensFlash lamp
Figure 1 – Vivicam 2005 Features and Controls 
1.2 Display 
AWB
1) Capture mode (still, movie, burst) 
2) Battery level Indicator 
3) Image resolution (Super Fine, Fine, Economy) 
4) Flash mode (Off, Auto, Auto/Red-eye, On) 
5) Self-timer mode 
6) Focus Frame 
7) White balance selection (auto, sunny, cloudy, 
fluorescent, tungsten) 
Figure 2 – Display Icons8) Number of images remaining in available memory 
 
 5  

 
 
 
1.3 Control Buttons 
1. Power button: On/Off 
2. Function switch: To select Capture or Playback modes 
3. Menu button: Start/close menu 
4. OK button:  
 In capture mode:  used to toggle flash mode  
 In playback mode:  no function 
 In menu mode, it is used to confirm menu selections 
5. Arrow buttons: 
z Left arrow (“”) - 
 In capture mode:  no function 
 In playback mode:  used for viewing previous image 
 In menu mode:  used for navigating/selecting menu icons 
z Right arrow (“”) - 
 In...

 
2. Preparation For Use 
 
 
 
2.1 Loading batteries 
1. Open the battery cover as shown in Figure 3. 
2. As indicated inside the battery cover (“+/-”), load three AAA batteries into the compartment 
with the polarity (orientation) as shown in Figure 4. 
 
Note:  Typically, the V2005 will come with alkaline batteries.  Whereas alkaline batteries will 
operate the camera, Nickel-Metal Hydride (Ni-MH) rechargeable batteries are highly 
recommended because they offer superior performance.  Rechargeable...

 
3. Camera Operations 
 
 
 
3.1 Capturing Images and Video Clips 
The Vivicam 2005 features three ways to capture images - 
1) Single Shot mode.  Single-shot mode is the most common mode used for capturing 
individual still images.  Single shot is also the default mode for the V2005.  Whenever 
the camera is turned on, it will be in single-shot mode. 
2) Video mode.  Capture short video clips.  Note that after each video captured, the 
camera will revert to single-shot mode. 
3) Continuous (burst)...

 
4. Operations 
 
 4.1 Power on/off 
Make sure that you have loaded the batteries correctly.  Press and hold the power button for 
two seconds.  The camera will power up.  The LEDs will illuminate and the LCD display 
screen will turn on.  Please press and hold the power button again for two seconds to power 
off.  (Note: If you will not use the camera for a long time remove the batteries to prevent 
damage by potential battery leakage.) 
 
4.2 Battery Level  
 
The battery level indicator icon will...

 
Flash Mode.  Press the “OK/” button to select flash mode: