Whirlpool Adp 4108 1 Wh Quick User Guide

							WH/II/B/GB
How to use the appliance
Further indications are given in the single chapters and in the user instructions.
Press the 
ON / OFF button.
Compartment
 A:
With each wash cycle.
Compartment
 B:
For programmes with pre-wash only.
If using combined action dishwasher 
tabs, follow the user instructions!
Mechanical indicator 
C.
Electric indicator on control panel (if provided).
On models with water softener 
system only.
Mechanical indicator 
D. Electric 
indicator on control panel (if provided).
Refer to the dishwasher loading instructions.
The last programme selected will light up.
Select the desired programme (using the specific button or knob). 
The corresponding indicator lamp lights up.
If necessary (and if provided).
The corresponding indicator lamp lights up.
The selected programme is 
then memorised (even in the 
event of power failure).
- Only open the dishwasher if necessary 
(Warning: beware of hot steam).
- If the appliance is switched off during a 
wash cycle, when switched on again it 
will resume the cycle from where it was 
interrupted.
Only after the START button has switched off: Press the ON / 
OFF button. 
All the indicator lamps switch off.
Warning: When the door is opened steam comes out! 
Unload the appliance, starting from the lower rack.
Switch on the appliance
Fill the detergent dispenser
ABC
Check the rinse aid level
Check the 
regeneration salt level
Load the racks
Close the dishwasher door, 
turn on the water tap
Select a programme
Select additional options
Press the Start button
“Change programme in progress”
Press the START button for 2 sec. until the 
Start indicator lamp switches off.
Select another programme and press the 
START button again.
Wash cycle
Switch off the appliance
Turn off the water tap,
unload the racks
 
						

							WH/III/GB
Dishwasher loading instructions and racks provided
Upper rack:depending on the model
Multi-purpose support (A): 1)
Depending on the position, for long-
handles utensils, cups and glasses. May 
be used in three different positions.
Crockery holders (B):
Depending on the position, for example 
plates, cups and long-stemmed glasses.
Revolving glass support (C): 
2)
Depending on the position, for example 
small or long-stemmed glasses.
Long-handled utensils (e.g. 
carving forks, knives) must be 
arranged with the sharp end 
facing in towards the appliance
.
Half Load:Load the upper rack (see description 
of Options).
Place the cutlery basket (D) in the 
upper rack.
Rack height adjustment 
(also when loaded):
•Lower adjustment: pull out the 
two rack handles outwards (E) 
and lower the rack.
Upper adjustment: pull the two 
handles (E) upwards until the rack 
clicks into place (Factory setting).
The rack must be level on both 
sides.
Removing the top rack to provide 
clearance for large items of 
crockery in the bottom rack:
Open the rack guide retainers (F) on 
the right and left and remove the top 
rack.
When the upper rack is in place the 
retainers must always be closed.
Lower rack:
Depending on the model with fixed or 
tilting plate holders (G).
Half Load:Load the lower rack (see description 
of Options).
Greater washing power, particularly 
for plates and saucepans.
Cutlery basket (J) or (H):Some models are provided with a grid 
(I) that can be fitted onto the cutlery 
basket to keep items separated. 
Cutlery basket (D), if provided, for 
appliances with half load only.
Sharp knives and forks that might 
cause injury must be placed in the 
cutlery basket with the sharp end 
facing downwards.
Only use dishwasher-proof crockery and dishes. Do not use the appliance for items not suitable for washing in a 
dishwasher, for example wooden items, aluminium, plastic utensils, tin, hand-decorated crockery (unglazed), silver cutlery.
Spare parts which are sold separately:
1) Multi-purpose support (A) - N. AMH 369 series.2) Revolving glass support (C) - N. WGH 1000 series.
FF
Retainer
closedRetainer
open
 
						

							WH/IV/GB
What to do if...
If a fault occurs, before contacting our After-Sales Service, make the following checks to try and remedy the problem (* see 
also the corresponding chapter in the user instructions).
ProblemCauseRemedy
The appliance is not 
working No water supply. Open the tap.
 The appliance does not load sufficient 
water. Clean the water supply tap filter.
 Ensure there are no kinks in the water hose.
 There is a power failure. Insert the plug into the mains socket.
 Press the Start button.
 Close the door.
 Check the safety circuit breaker.
 Starting the selected programme. The programme can be set to “0” to start.
If crockery is not 
perfectly dry Insufficient rinse aid.Increase dosage *.
 Residual water in cavities. Load crockery at an angle.
If crockery is not 
perfectly clean The water jet does not reach the 
crockery. Arrange crockery so that items do not touch each 
other. Load crockery upside down.
 Insufficient detergent. Follow recommended detergent dosage.
 Unsuitable programme. Select a more intense wash cycle.
 Spray arms blocked. The spray arms must be able to turn freely.
 Spray arm nozzles clogged. Remove any impurities obstructing the water flow *.
 Incorrect detergent/detergent too old. Use a good quality detergent.
Sandy or grainy 
residues Clogged filters. Check filters regularly/if necessary clean *.
 Filters incorrectly assembled. Insert the filter correctly *.
Colour of plastic parts 
faded Tomato/carrot juice, ... Depending on the material, if necessary use a 
detergent with a greater whitening power.
Deposits on crockery
Removable Streaks on the crockery/glasses. Increase the rinse aid dosage *.
 Streaks on glasses. Reduce the rinse aid dosage *.
 Layer of salt on crockery/glasses. Close the salt container lid properly *.
 Not removable Insufficient water softening, calcium 
deposits. Change water hardness setting, if necessary add salt *.
Opaque glasses/ glasses 
not sparkling Cannot be washed in the dishwasher. Use suitable glasses.
Rust on cutlery Not made of stainless steel.Use suitable cutlery.
Identifying appliance 
faults The START indicator lamp flashes.
 Indicator F... (if provided). Ensure the filter assembly is not clogged and that 
there is no interruption to the water supply 
(if necessary, clean the filters *). Start the programme 
again. Press the START button for 2 seconds, until the 
START indicator lamp switches off. Select a new 
programme and press the Start button again.
If after carrying out the above checks the malfunction persists or appears again, turn the appliance off and turn off the water 
supply tap, then call our After-Sales Service (see guarantee).
Before contacting our After-Sales Service, take note of the following:
 The nature of the fault
 The appliance type and model
 The service code (the number indicated on the adhesive rating plate) 
inside the door on the right-hand side.
 
						

							Whirlpool is a registered trademark of Whirlpool USA 5019 396 01764
GB
ADP 4108/1Quick Reference Guide
Before using the dishwasher, read the user instructions!
WH/I/B/GB
(We reserve the right to ma ke technical modifications)
1) Reference programme for energy label EN 50242;
2) Refer to “User instructions”;
3) The data relevant to programmes are values obtained in the 
laboratory in conformity with  Standard EN 50242. In practice 
there may be time variations or leaps depending on different 
loads, function options, sensor  calibration (only for sensor-
controlled programmes) water temperatures or hardness and 
different power supply voltages. 4) The bacteria removal efficiency 
has been tested by the Institut 
Pasteur de Lille (France), base d on the NF EN 13697 standard 
of November 2001.
5) Programme interruption (e.g. the door being opened) may  compromise the result of the antibacterial rinse.
Programme selector knob
On / Off button
Start button
Switches “on” when the dishwasher is 
operating. Flashes when a fault occurs. 
Switches off at the end of the programme.
Programme chartDetergent2)Consumption3)
ProgrammesLoading instructionsABLitreskWhMinutes
Pre-RinsecoldCrockery to be washed later.--5.00.0210
Glasses40°CLight soiling, for example glasses and 
cups.X-13,00,9097
Quickwash40°CLightly soiled crockery with no dried-on 
food.X-13.00.7030
Eco1)50°CNormally soiled crockery.XX15.01.05150
Antibacterial4) 5)Normally or heavily soiled crockery, 
with additional antibacterial action.XX16.01.75120
Intensive70°CRecommended programme for heavily 
soiled crockery, especially suitable for 
pans and saucepans.XX17.01.65145
Half Load50°CIdeal for washing a half load of lightly or 
normally soiled crockery.XX13.01.00130
Important information for Test Laboratories:
For detailed information on the EN comparis on test and other tests, contact the following address: “[email protected]”.