Whirlpool Adp 750 Ix Instruction Manual

14
For best performance of the dishwasher, follow these loading guidelines. Features and appearance of
baskets and cutlery baskets may vary from your model.
Attention before or after Loading the Dishwasher Baskets
Scrape off any large amounts of leftover food. Soften remnants of burnt food in pans.
It is not necessary to rinse the dishes under running water.
Place objects in the dishwasher in following way:
1.Items such as cups, glasses, pots/pans, etc. are faced downwards.
2.Curved items, or ones with...

15
Loading the Lower Basket
We recommend that you place large items which are most difficult to clean into the lower basket: pots,
pans, lids, serving dishes and bowls, as shown in the figure to the right.
It is preferable to place serving dishes and lids on the side of the racks in order to avoid blocking the
rotation of the top spray arm.
Pots, serving bowls, etc. must always be placed top down.
Deep pots should be slanted to allow water to flow out.
The bottom basket feature fold down tine rows so...

16
 Do not leave any item extend through bottom. Knives and other utensils with
sharp points must be loaded in the basket with their points down or placed in
an horizontal position.
 Always load sharp utensils with the sharp point down!
WARNING:
Cutlery Basket
Cutlery should be placed in the cutlery basket with the handles at the bottom. If the rack has side baskets,
the spoons should be loaded separately into the appropriate slots, especially long utensils should be placed
in the horizontal position at...

17
Wash Cycle Table
NOTE

Meaning: need to fill rinse into the Rinse-Aid Dispenser.
 * En50242: This program is the test cycle, the rinse-aid dispenser setting is recommended to be set
to position 6.
The power consumption of off-mode is 0W,left-on model is 0.73W.
STARTING A WASHING PROGRAMME
ProgramCycle selection
informationDescription
of cycleDetergent
pre/mainRunning
time
(min)Energy
(kWh)Water
(l)Rinse
Intensive
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have...

18
Turning On the Appliance
Starting a cycle wash
Draw out the lower and upper basket, load the dishes and push them back.
It is commended to load the lower basket first, then the upper one (see the section entitled Loading
the Dishwasher).
Pour in the detergent (see the section entitled Salt, Detergent and Rinse Aid).
Insert the plug into the socket. The power supply is 220-240 VAC /50 HZ, the specification of the
socket is 10A 250VAC. Make sure that the water supply is turned on to full pressure.
Close...

19
Filtering System
The filter prevents larger remnants of food or other objects from getting inside the pum.
The residues may block the filter, in this case they must be removed.
The filter system consists of a coarse filter,a flat (Main filter).
And a microfilter(Fine filter).
Main filter 1
Food and soil particles trapped in this filter are
pulverized by a special jet on the lower spray arm and
washed down to drain.
Coarse filter 2
Larger items, such as pieces of bones or glass, that could
block the...

20
Remarks:
 Inspect the filters for blocking after every time the dishwasher has been used.
 By unscrewing the coarse filter, you can remove the filter system. Remove any food remnants and
clean the filters under running water.
NOTE:The entire filter assembly should be cleaned once a week.
Cleaning the Filter
To clean the coarse filter and the fine filter, use a cleaning brush. Reassemble the filter parts as shown in
the figures on the last page and reinsert the entire assembly in the dishwasher,...

21
Cleaning the Spray Arms 
It is necessary to clean the spray arms regularly in
order to remove the accumulation of scale from
the hard water and thus prevent blocking of spray
arm jets and bearings.
We Suggest to poke the blocked spray arm jets
with a needle to ensure good washing effect.
How to keep your dishwasher in shape
 After Every Wash
After every wash, turn off the water supply to the appliance and leave the door slightly open so that
moisture and odours are not trapped inside.
 Remove the...

22
INSTALLATION INSTRUCTIONS
About electrical connection
For personal safety:
 DO NOT USE AN EXTENSION CORD OR AN ADAPTER PLUG WITH THIS APPLIANCE.
 DO NOT, UNDERANY CIRCUMSTANCES, CUT OR REMOVE THE EARTHING
CONNECTION FROM THE POWER CORD.
Electrical Requirements
Please look at the rating label to know the rating voltage and connect the dishwasher to the appropriate
power supply. Use the required fuse 10 amp, time delay fuse or circuit breaker recommended and
provide separate circuit serving only this...

23
Water ConnectionCold water connection
Connect the cold water supply hose to a threaded 3/4 (inch) connector and
make sure that it is fastened tightly in place.
If the water pipes are new or have not been used for an extended period of
time, let the water run to make sure that the water is clear. This precaution
is needed to avoid the risk of the water inlet to be blocked and damage the
appliance.
Hot water connection
The water supply to the appliance can also be connected to the household hot water...