Whirlpool ARG 0910 Manual

NC
MY
TABLE OF CONTENTS GB
DESCRIPTION OF THE APPLIANCE Page 8
BEFORE USING THE REFRIGERATOR Page 8
PRECAUTIONS AND GENERAL SUGGESTIONS Page 9
HOW TO OPERATE YOUR REFRIGERATOR Page 9
HOW TO DEFROST AND CLEAN THE REFRIGERATOR Page 10
TROUBLE SHOOTING GUIDE Page 11
AFTERîSALES SERVICE Page 11
INSTALLATION Page 12
DOOR REVERSIBILITY Page 12
To get full satisfaction of your refrigerator, please read carefully your instruction manual.
7
7
 

NC
MY
DESCRIPTION OF THE APPLIANCE
1.Thermostat control knob
2.Ice cube tray Óif providedØ
3.Ice compartment
4.Defrost tray
5.Shelf6.Feet
7.Rating plate î Service plate
8.Bottle rack
9.Inner door
10.Small bottle rack
BEFORE USING THE REFRIGERATOR
xAfter unpacking, please ensure that the
appliance is undamaged and that the door
closes tightly.
Any damage must be reported to your
dealer within 24 hours of receipt of the
appliance.
xThe package is recyclable and is marked
with the recycling symbol
Ù.
xThe...

NC
MY
PRECAUTIONS AND GENERAL SUGGESTIONS
xOnly use the refrigerator for the storage of
foods.
xAfter installation, please make sure that the
refrigerator does not stand on the supply
cable.
xDo not store glass containers with carbonated
drinks in the ice compartment as they may
explode.
xDo not eat ice cubes or ice lollies immediately
after their removal from the ice compartment,
as they may cause òcoldó burns.
xBefore any cleaning or maintenance operation,
disconnect the refrigerator by switching off...

NC
MY
HOW TO DEFROST AND CLEAN THE REFRIGERATOR
X4
We suggest you defrost your refrigerator once
ice build up reaches about 3 mm in thickness.
1.Check that the defrost tray is still under the
ice compartment.
2.Turn the thermostat control knob to position
defrost.
3.When the ice has melted completely, empty
the water from the defrost tray.
4.Turn back the thermostat control knob to the
desired setting.
Quick defrosting
This function is used to defrost your refrigerator
more quickly.
1.Empty the...

NC
MY
TROUBLE SHOOTING GUIDE
1. The temperature in the compartment is
not cold enough
xIs the door properly closed æ
xIs the refrigerator too close to a heat source æ
xIs the condenser clean æ
xIs the air flow over and around the appliance
restricted æ
xIs the layer of frost in the ice compartment
too thick æ
2. The temperature in the refrigerator is
too cold.
xAre the thermostat and the defrost tray in the
correct position æ
3. The refrigerator is excessively noisy.
xIs the refrigerator in contact with...

NC
MY
INSTALLATION
xDo not install the refrigerator close to any
heat source.
xPlace it in a dry and well ventilated space.
xMake sure that the appliance is well levelled.
xNever cover the plinth. You must leave at
least a 50 mm gap, if the appliance is installed
under a kitchen furniture.
xLet the appliance to stand for 1 hour prior to
connecting it to the electricity supply.
Electrical connection
xCheck that the voltage on the rating plate
corresponds to the voltage in your home.
xThe earthing of the...

NC
MY
FOR GREAT BRITAIN ONLY î ELECTRICAL INFORMATION
òWarning î this appliance must
be earthedó
Fuse replacement.If the mains lead of this appliance is fitted with a BS
1363A 13 amp fused plug, to change a fuse in this
type of plug use an A.S.T.A. approved fuse to BS
1362 type and proceed as follows:
1. Remove the fuse cover ÓAØ and fuse ÓBØ.
2. Fit replacement 13A fuse into fuse cover.
3. Refit both into plug.
Important:The fuse cover must be refitted when
changing a fuse and if the fuse cover is lost...