Whirlpool Awe 7729 Programme Chart Manual

							
GB
5019 312 10730
ProgrammeCareLabels
Max.Load
kgType of wash / Notes- for temperature selection, respect the manufacturer's recommendations on the care label
Detergents and AdditivesSpecial optionsMax.Spin Speed
rpm
Pre- washMain 
WashSoftenerEasyironingClean+ Pre-washStartdelayIntensiverinseRinseHoldVariablespin
Cotton /Antibacterial40 - 60 - 95°C40 - 60 - 95°C5.5
Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. made of cotton and linen.
Selecting “Cotton 95”, this programme eliminates bacteria, ensuring sanitization of your laundry
. 
The bacteria removal efficiency has been tested following a similar methodology to the NF EN 
13697 standard of Nov. 2001.Yes 1) 2)max.
Synthetics30 - 40 - 60°C30 - 40 - 60°C3.0Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, T
revira), polyamide 
(Perlon, Nylon). Yes 1) 2)1000 3)
Delicates30 - 40°C30 - 40°C1.5Curtains and delicate clothing, dresses, skirts, shirts and blouses.Yes 1)–– 2)–1000 3)
Daily load40°C40°C3.0Slightly to normally soiled textiles made of cotton and/or synthetics.–
Yes–– 2)max.
Quick wash 15’30°C30°C3.0Refreshes briefly worn outer clothing made of cotton, artificial fibers and blends with cotton.–Yes––– 2)–max.
Wool
Cold - 40°C        - 40°C1.0
Only woollens with a felt-free finish, labelled with the woolmark and identified as machine 
washable.
This programme (40ºC) is tested and approved by The Woolmark Company for machine washable 
wool.
– Yes––– 2)–1000 3)
Handwash40°C40°C1.0Textiles made of linen, silk, wool and viscose marked as “handwashable”.
This programme (40ºC) is tested and approved by The Woolmark Company for handwashable wool. 
A very gentle spin is used in this programme.–Yes––– 2)–400 3)
SuperEco60°C60°C5.5
Slightly to normally soiled bed linen, table linen and underwear , towels, shirts etc. made of cotton and/or linen.Offers highest economy in energy consumption by prolonged wash duration. Ideal to be run 
overnight to additionally profit from the more favourable energy rates. T o avoid noise of spinning at 
night, set spin speed to “0” and start spin programme in the morning, or define programme start 
with “Start Delay ” accordingly. Use with maximum load.
–Yes––– 2)max.
Rinse & Spin–5.5Same as the last rinse and the final spin in the “Cotton” programme.–––––max.
Spin–5.5In this programme spinning is intensive. Same as the spin cycle in the “Cotton ” programme.––––––––max.
Gentle Spin–1.0In this programme spinning is gentle. Same as the spin cycle in the “Wool” programme.––––––––1000 3)
Drain––Drain only - no spinning. Alternative method of terminating programme after “Rinse Hold”.––––––––––
A.  Programme selector
B.  Time display
C.  “Start delay ” button
D.  “ Variable spin” button
E.  “Start/Pause” button
F.  Programme sequence indicator
G.  “Reset” button
H.  “Door open” indication
Whirlpool is a registered trademark of Whirlpool USA.
This washing machine is equipped with automatic safety functions which detect and diagnose faults at an early stage and react appropriately:
I.  “Service” indication
J.  “Water tap closed” indication
K.  “Clean pump” indication
1)  Do not use liquid detergent for main wash if you
  have activated prewash option.
2)  Do not use liquid detergent.3)  For improved garment care, spin speed is restricted
  in these programmes.
PROGRAMME CHART
A
BHF
E
G
CD
J
IK
The wool and handwash cycles of this machine have been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash”provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart.                           M0703
Yes = dosing required /  = optional
 
						

							
5019 312 10730
ProgrammeTemperature(°C)
Load
(kg)Water(l)
Energy
(kWh)Approx. ProgrammeDuration***(hours : minutes)
Cotton / Antibacterial955.555*1.701:55    Cotton**605.5490.932:35Cotton405.5530.552:00Synthetics603.054*0.901:40Synthetics403.0480.551:25Delicates401.5510.500:45Daily load403.0430.481:00Quick wash 15’303.0300.150:15
Wool401.0530.500:45Handwash401.0430.500:35SuperEco605.5490.734:00
CONSUMPTION DATA
Whirlpool is a registered trademark of Whirlpool USA.
1.  Load the machine, close the drum doors and check
  that they are properly locked.
2.  Add detergent and additives into the dispenser to
  no more than the 
“MAX” level mark, as follows:•  Programme with pre and main wash•  Main wash programme without prewash•  Fabric softeners and conditioners•  Stain remover agents•  Anti-scale agents (if necessary)
3.  Close the lid.
4.  Turn the 
programme selector to the desired
  programme and temperature. The time display
  shows the duration of the chosen programme (in
  hours and minutes), and the lamp next to the 
“Start
  Pause” button flashes. The indication lamp of the
  predefined spin speed lights up.
Prewash cycle increases programme duration by aproximately 20 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash.
*  To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water
  out.
**  Reference Programme for Energy Label.
***  The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions
  applicable at that time.
PREPARATION OF THE WASH CYCLE
“DOOR OPEN” INDICATION
Before starting and after end of a programme, the lamp lights to show the the lid can be opened. As long as a wash programme is running, the lid remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, 
refer to “Cancel (Reset) a running programme before 
the end”.
RED INDICATIONS
“Service”Lighting up of the “Service” indication can be caused 
by a fault in an electrical component. Refer to the 
“Troubleshooting Guide” in your “Instructions for Use”; 
if the fault persists, contact our After Sales Service.
“Water tap closed”
The appliance has no or insufficient water supply. Open the water tap: if the indications still lights up, refer to the 
“Troubleshooting Guide” in the Instructions for Use.
“Clean pump”
Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the 
latter case refer to the Instructions for Use (“Removing 
the Filter”).
  use with maximum load.
•  Add an appropriate amount of in-wash additive for
  stain removal (powder) to the main wash chamber,
  together with your detergent (only use powder
  detergent with this option). Respect the
  manufacturer’s dosing instructions.
•  Prolongs the programme by approx. 10 to 15 minutes.
•  Appropriate for use of stain removers and bleaches
  on oxygen basis. 
Chlorine or perborate bleaches
  must not be used!
“Prewash” button
•  Only for heavily soiled loads (for example sand,
  granular dirt) sensible. Increases the cycle time by
  approximately 20 min.
“Intensive Rinse” button•  The amount of water is increased to ensure a more
  intensive rinse.
•  This option is particularly suitable for areas with very
  soft water, washing baby linen and people with skin
  allergies.
“Rinse Hold” button•  The laundry remains in the last rinse water without
  progressing to the final spin cycle to avoid creasing
  and prevent colours from changing.
•  This option is particularly recommended for the
  “Synthetics”, “Daily load” and  “Delicates”
  programmes.
• It is useful if you want to postpone spinning to a later
  time, or if you want to drain out only.• If you select “Rinse Hold”, do not leave items to
  soak for too long.• As soon as the appliance stops in the rinse hold, the
  “Rinse hold” lamp of the sequence indicator lights up
  and the lamp next to the  “Start/Pause” button flashes.
Terminate the “Rinse Hold” option:
•  Press the  “Start/Pause” button; the programme
  will terminate automatically with the final spin cycle
  for the present wash programme.
PROGRAMME START
Open the tap and press the  “Start/Pause” button. The indication lamp next to the  “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right 
through Wash, Rinse, Spin/Drain. When the programme 
phrase is finised, the corresponding indication goes out.
• Note: If there is a power interruption or if the
  appliance is disconnected during the cycle, the
  programme will run again from the point where it
  was interrupted.
PROGRAMME END
• All the lights of the programme sequence indicator
  are off, and the “Door open” indication lights up.
1.  Turn the programme selector to the “Off/O”
  position.
2.  Close the water tap.3.  Open lid and drum and unload the machine.4.  Leave the lid open for some time to allow the
  interior of the machine to dry.
CHANGE PROGRAMME AND/OR OPTIONS 
AFTER PROGRAMME START
1.  Press the  “Start/Pause” button to pause the
  programme. The light flashes.
2.  Select the new programme, any options and another
  spin speed if you want.
3.  Press the  “Start/Pause” button again. The new
  programme continues at the same position where
  the previous programme was interrupted. Do not
  add detergent for this programme.
CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END
The  “Reset” button cancels a programme before the 
end. Press the  “Reset” button for at least 3 seconds. Any existing water is drained out before the lid can be opened.
SELECT THE DESIRED OPTION(S)
Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme 
phase has not been executed yet.
“Easy ironing” button•  Can be used together with “Cotton”, “Synthetics”
  and “Daily load” programmes to make ironing easier.
•  Increases the water quantity and the clothes are spun
  very gently.
“Clean+” button
•  Choose this option if you use an in-wash additive for
  stain removal (powder, for example “Vanish”) - it
  will optimize the additive’s efficiency to get better
  wash performance and stain removal.
•  Selectable for programmes “Cotton” and
  “Synthetics”; choose temperature of 30 or 40°C and
START DELAY
The “Start delay ” button allows the user to run the machine at his convenience, for example at night when 
electricity is cheaper.
•  Select programme, spin speed and options.•  Press the “Start Delay ” button several times to
  select a delay time by 1 to 23 hours.
•  Start the programme (see “Progremme Start”).
  The indication lamp over the “Start delay ” button
  lights up and goes off when the programme starts.
•  Once having pressed the  “Start/Pause” button,
  the countdown of the time delay begins. The time
  delay indication on the display disappears when the
  programme starts and is replaced by the remaining time.•  After the  “Start/Pause” button has been pressed,
  the number of hours preselected can be reduced by
  pressing again the “Start delay ” button.
To cancel  the “Start delay ”
..before you press the “Start/Pause” button:
•  Turn the programme selector to another position
  or press the  “Reset” button.
..after having pressed the “Start/Pause” button:
•  Press the “Reset” button for at least 3 second. The
  start delay indicator light goes off.
•  If you do not wish to spin the clothes, turn the
  programme selector knob to the “Drain”
  programme and press the  “Start/Pause”
 button.
“ Variable spin” button
•  Every programme has a predefined spin speed.•  Press the button to set another spin speed.•  If spin speed “0” is selected, the final spinning is
  cancelled but intermediate spin peaks remain during
  the rinse. The water is drained out only.