Whirlpool Awm 1000 Programme Chart Manual

							GB AWM 1000 PROGRAMME CHART
5019 301 151951)
For improved garment care spin speed is restricted to 1000 rpm in this programme.
2)
For improved garment care spin speed is restricted to 400 rpm in this programme.
Whirlpool is a registered trademark of Whirlpool USA
The wool wash cycle for this machine has been tested and approved by The Woolmark Company for 
the washing of Woolmark garments labelled as “machine wash” provided that the garments are washed 
according to the instructions on the garment label and those issued in this programme chart. M0301
Programme
Care
labels
Type of wash/Notes
- For temperature selection, respect the manufacturer’s 
recommendation on the care label.
Max.
Load
kg
Detergents and additives
Special Options
Max.
Spin
Speed
rpm
Te m p e -
rature
°C
Pre-
wash
Main
wash
Softener
Start
delay
Easy
ironing
Pre-
wash
Extra
rinse
Rinse
hold
Va r i a b l e
spin
Cotton /
Antibacterial
 
 
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. 
made of cotton and linen.
At a temperature of 80°C or more, this programme eliminates bacteria, ensuring 
sanitization of your laundry. The bacteria removal efficiency has been tested 
following a similar methodology to the NF EN 13697 standard of Nov. 2001.
With heavily soiled laundry the additional “Prewash” option can be selected as well.
10.0
❉
Ye s
❉❉ ❉❉❉ ❉ ❉
1200 20 to 95
Colours
 
 
Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. 
made of cotton and linen.
10.0
❉
Ye s
❉❉ ❉❉❉ ❉ ❉
1200 20 to 60
Synthetics
 
 
Slightly to normally soiled blouses, shirts etc. made of polyester (Diolen, Trevira), 
polyamide (Perlon, Nylon) or blends with cotton.
4.5
❉
Ye s
❉❉ ❉❉❉ ❉ ❉
1000
1)
20 to 60
Daily load
 
 
Programme for slightly to normally soiled fabrics made of cotton and/or synthetic 
fibres.
4.5
—
Ye s
❉❉ ❉—
❉❉ ❉
1200 20 to 60
Rapid plus
 
 
Slightly soiled overalls and sports wear made of cotton, polyester, polyamide and 
blends with cotton.
4.5
—
Ye s
❉❉ ❉—
❉❉ ❉
1200 20 to 30
Delicate
 
Curtains and delicate dresses, skirts, shirts and blouses.
3.0
❉
Ye s
❉❉ ❉❉❉ ❉ ❉
1000
1)
20 to 40
Wool
Only woollens, labelled with the Woolmark and identified as machine washable.
This programme (40°C) is approved by The Woolmark Company for the washing 
of Woolmark garments labelled as “machine wash” provided that they are 
washed according to the instructions on the garment label and those issued in 
this programme chart.
If you select “Rinse Hold” do not leave items to soak for too long.
2.0
—
Ye s
❉❉ ❉——
❉❉
1000
1)
20 to 40
Handwash
Textiles made of silk, linen, wool and viscose marked as “handwashable”.
If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is 
used in this programme.
2.5
—
Ye s
❉❉ ❉——
❉❉
400
2)
20 to 40
Big items
 
 
Blankets made of synthetic fibres, bedcovers filled with polyester or other 
artificial fibres, sleeping bags, bathmats and similar items.
3.0
❉
Ye s
❉❉—
❉❉ ❉ ❉
1000
1)
20 to 95
Gentle spin
—
In this programme spinning is gentle. Same as the spin cycle in the “Wool” 
programme.
4.5
———
❉——— —
❉
1000
1)
—
Spin
—
In this programme spinning is intensive. Same as the spin cycle in the “Colours” 
programme.
10.0
———
❉——— —
❉
1200
—
Rinse & Spin
—
Same as the last rinse and the final spin in the “Colours” programme.
10.0
——
❉❉——
❉❉ ❉
1200
—


A. “Door locked” indication
B. “Aquastop” indication
C. “Water tap closed” indication
D. Temperature selection buttons
E. Programme selector
F. “Start delay” button
G. “Reset/Unlock door” button
H. “Child lock” button
I. “Variable spin” button
J. Programme sequence indicator
K. “Start/Pause” button
Selecting any option the indication lights up.
When the combination of programme, 
additional options and temperature is not 
possible, the indication lights switch off 
automatically and a signal sounds.❉ : optional / yes: dosing required.
E
D
I F
B
C
H K
G
A
J
}
 
						

							5019 301 15195
Whirlpool is a registered trademark of Whirlpool USA
Add the detergent as described in the programme 
table or in the chapter “Detergent and Additives” of 
the Instructions for Use.
1. Turn the 
programme selector to the desired 
programme.
2. The remaining time display shows the duration 
of the chosen programme (in hours and 
minutes) and the lamp of the 
“Start/Pause” 
button  flashes.
3. The indicator of the predefined spin speed 
corresponding to the selected programme lights 
up; it can be altered by pressing the “Variable 
spin” button. The recommended temperature 
(see indicator) can be altered by pressing the 
“
+” or “
–” button.
Selecting any option the indication lights up.
When the combination of programme, 
additional options and temperature is not 
possible, the indication lights switch off 
automatically and a signal sounds.
“Easy ironing” button
 Can be selected to reduce creasing.
 Increases the water quantity and the clothes are 
spun very gently.“Prewash” button
 Only for heavily soiled laundry (e.g. sand, 
granular dirt). The cycle time increases by 
approx. 15 minutes.
 Do not use liquid detergent for the main wash 
when activating the “Prewash” button.
“Extra rinse” button
 More water and a longer time in rinse cycle is 
added.
 This option is particularly suitable for areas with 
very soft water, for baby clothes and to help 
people with allergies.
“Rinse hold” button
 The laundry remains in the last rinse water 
without being spun: this prevents creasing and 
colours from changing.
 This option is particularly recommended for the 
programme “Synthetics” or “Delicate”.
 It is particularly useful if you want to postpone 
spinning to a later time, or if you want to drain 
only.
Note: The programme stops to “Rinse hold” as 
soon as the “Rinse hold” light in the programme 
sequence indicator lights up.
Terminate the “Rinse hold” option  :
 Press the “Rinse hold” button again; the 
programme will terminate automatically with the 
final spin cycle for the present wash programme.CONSUMPTION DATA
Programme
Temperature 
Selector
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Approximate programme
duration
*
(hours : minutes)
Cotton / Antibacterial 95 10.0 99
**3.15 2:45
Colours
***60 10.0 92 1.70 2:45
Colours 60 4.0 50 1.10 1:35
Colours 40 10.0 92 0.96 2:35
Synthetics 40 4.5 58 0.65 1:30
Daily load 40 4.5 58 0.65 1:00
Rapid plus 30 4.5 38 0.40 0:30
Delicate 30 3.0 70 0.45 0:50
Wool 40 2.0 60 0.50 0:35
Handwash 30 2.5 60 0.30 0:31
Big items 40 3.0 85 0.80 1:30
Prewash cycle increases programme duration by approximately 15 min. Consumption values were measured in normalized conditions in 
compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the 
water supply pressure and temperature, the load and the type of wash.
*The remaining time indicator can deviate from the values in the table, because it takes into account the operating conditions 
applicable at that time.
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out.
***  Reference programme for energy label.ADD DETERGENT, CLOSE THE DOOR 
AND SELECT THE PROGRAMMESELECT ANY DESIRED OPTION
 If you do not wish to spin the clothes, press the 
“Reset/Unlock door” button. The water is 
drained out then, before the door can be opened.
“ Variable spin” button
 Every programme has an automatic predefined 
spin speed.
 Press the button to set another spin speed.
 If spin speed “0” is selected, the final spinning is 
cancelled but intermediate spin peaks remain 
during rinse. The water is drained out only.
The “Start delay” allows to run the machine at the 
consumer’s convenience, for example at night when 
electricity is cheaper. Do not use liquid detergent 
when activating the “Start delay”.
 Select programme, temperature and options.
 Press the “Start delay ” button to select the delay 
time by 1 to 23 hours;
 Press the 
“Start/Pause” button  .
 The time delay indication disappears when the 
programme starts and it is replaced by the 
remaining time.
 The number of hours preselected can later be 
reduced pressing again the “Start delay ” button.
To cancel the “Start delay” .
 Turn the programme selector to the “ ” position.
 Reselect the desired programme and options 
and press the
 “Start/Pause” button  .
Turn on the tap and press the 
“Start/Pause” 
button  . The pilot lamp of the 
“Start/Pause” 
button  lights up.
The indicator lamps show the sequence reached in 
the programme. After starting the programme, the 
sequence indication runs from top to bottom 
through Prewash, Wash, Rinse, Spin.
When a sequence of the programme is finished the 
corresponding lamp goes out.
Each time a programme starts the door is locked, the 
“Door locked” indication light comes on and approx. 
0.5 litres of water enters the machine. In the 
programmes Cotton / Antibacterial, Colours, 
Synthetics, Daily load and Rapid plus, for 10 minutes at 
the beginning of the Main Wash the programme can be 
interrupted by pressing the 
“Start/Pause” button   
and the door can be opened again, e.g. to add more 
washing. After this time, the door remains locked until 
the end of the programme and must on no account be 
forced open. You will find more information about 
door locking in the Instructions for Use. The time remaining is “0:00” and the “End” light 
is on.
1. Turn the programme selector knob to the “ ” 
position.
2. Turn the tap off and leave the door ajar to allow 
the drum to dry.
1. Press the 
“Start/Pause” button   to 
interrupt the programme. The light flashes.
2. Select the new programme (with temperature), 
any options and another spin speed if you want.
3. Press the
 “Start/Pause” button   again. The 
new programme continues at the same position 
where the previous programme was interrupted. 
Do not add detergent for this programme.
Press the “Reset/Unlock door” button   for at 
least 3 seconds. Any existing water is drained out 
before the door can be opened. Caution, the 
washing could still be hot!
Detailed information can be found in the 
instructions for use.
The controls can be locked to avoid interference by 
children.
1. If the machine is off:
Turn the programme selector knob from the 
OFF position “ ” to any programme. Do not 
press the 
“Start/Pause” button  . Press the 
“Child lock” button for 5 seconds. The “Child 
lock” indicator lights up. Turn the programme 
selector knob to the OFF position “ ” again.
2. While a programme is running: 
Press the “Child lock” button   for 5 
seconds. The child lock indicator will light up.
Now, in spite of the programme selector knob being 
turned, no programme can be started or altered. 
However, a running programme can be stopped at 
any time (e.g. in an emergency), by turning the 
programme selector knob to “ ”. Attempts at 
changing during the running programme are signalled 
by the lamp of the accidentally chosen programme 
flashing. The indicator light for the actual programme 
running is on.
To unlock the controls, the machine must either have 
a programme running or be in select mode. Press the 
“Child lock” button   for 5 seconds. The child 
lock lamp will go out.START DELAYPROGRAMME STARTADD WASHING/DOOR LOCK
PROGRAMME ENDCHANGE THE PROGRAMME, 
TEMPERATURE, OPTIONS AFTER 
PROGRAMME STARTCANCEL (RESET) A RUNNING 
PROGRAMME BEFORE THE ENDCHILD LOCK