Xerox Phaser 3117 User Manual

USING PRINT MATERIALS3.10
3Adjust the side guide to the edge of the material. 
4When you print on special material, you must select 
Manual Feed for Source from the software application, 
and then select the correct paper size and type. For details, 
see 
Software User Guide. 
5Press the   button to start feeding. 
Canceling a Print Job
There are two ways to cancel a print job.
To stop a print job from the Control Panel
Press the   button on the control panel. 
The printer will finish printing the page...

USING PRINT MATERIALS3.11
3
To stop a print job from the Printers folder
1From the windows Start menu, select Settings.
2Select Printers to open the Printers window, and double-
click the 
your printer icon. 
3From the Document menu, select Cancel Printing 
(Windows 98/Me) or 
Cancel (Windows 2000/XP).
In Manual Feed mode, you can’t cancel a print job by pressing 
the  button. 
To cancel a print job in Manual Feed mode:
1Turn the printer off. 
2Double-click the   icon at right bottom of the window....

4
This chapter provides suggestions for maintaining the toner 
cartridge and the printer. 
This chapter includes:
• Maintaining the Toner Cartridge
• Using the Toner Save Mode
• Cleaning the Printer
• Consumables and Replacement Parts
Maintaining Your Printer 
Downloaded From ManualsPrinter.com Manuals 

MAINTAINING YOUR PRINTER4.2
4
Maintaining the Toner Cartridge
Toner cartridge storage
To get the maximum results from the toner cartridge, keep the 
following guidelines in mind.
• Do not remove the toner cartridge from its package until 
ready for use. 
• Do not refill the toner cartridge. 
The printer warranty does 
not cover damage caused by using a refilled cartridge.
• Store toner cartridges in the same environment as the 
printer.
• To prevent damage to the toner cartridge, do not expose it to...

MAINTAINING YOUR PRINTER4.3
Redistributing Toner
When toner is low, faded or light areas may appear on a printed 
page. You may be able to temporarily improve the print quality 
by redistributing the toner. The following procedures may allow 
you to finish the current print job before replacing the toner 
cartridge.
1Open the front cover. 
2Pull the toner cartridge out and remove it from the printer.
Cautions: 
• Avoid reaching too far into the printer. The fusing area may be 
hot.
• To prevent damage to...

MAINTAINING YOUR PRINTER4.4
4
3Gently shake the toner cartridge from side to side five or six 
times to redistribute the toner.  
Note: If the toner gets on your clothing, wipe it off with a dry 
cloth and wash clothing in cold water. Hot water sets toner into 
fabric.
4Reinsert the toner cartridge into the printer. Ensure that the 
toner cartridge snaps into place.
5Close the front cover. Make sure that the cover is securely 
closed. If it is not fir
mly closed, printing errors may occur 
when you...

MAINTAINING YOUR PRINTER4.5
Replacing the Toner Cartridge
If the print remains light after redistributing toner (see 
page 4.3), replace the toner cartridge. 
Remove the old cartridge and install a new toner cartridge. See 
“Installing the Toner Cartridge” on page 2.4. 
Using the Toner Save Mode
The Toner Save mode allows the printer to use less toner on 
each page. Selecting this option will extend the life of your toner 
cartridge and reduce your cost per page, but will reduce print 
quality. 
There...

MAINTAINING YOUR PRINTER4.6
4
Cleaning the Printer
To maintain the print quality, follow the cleaning procedures 
below each time the toner cartridge is replaced or if print quality 
problems occur.
Note: While cleaning the inside of the printer, be careful not to 
touch the transfer roller (located underneath the toner cartridge). 
Oil from your fingers can cause print quality problems.
Caution: Cleaning the cabinet of the printer with surfactants 
containing large amounts of alcohol, solvent or other...

MAINTAINING YOUR PRINTER4.7
3Pull the toner cartridge out and remove it from the printer..
4With a dry, lint-free cloth, wipe away any dust and spilled 
toner from the toner cartridge area and the toner cartridge 
cavity.
Note: To prevent damage to the toner cartridge, do not expose it 
to light for more than few minute. Cover it with a piece of paper, if 
necessary. Also, do not touch the black transfer roller inside the 
printer. 
5Locate the long strip of glass (LSU) inside the top of the 
cartridge...

MAINTAINING YOUR PRINTER4.8
4
6Reinsert the toner cartridge and close the cover.  Make sure 
that the cover is securely closed. If it is not firmly closed, 
printing errors may occur when you print. 
7Plug in the power cord, and turn the printer on.
Downloaded From ManualsPrinter.com Manuals