Zanussi Zba 6230 Instruction Booklet
Here you can view all the pages of manual Zanussi Zba 6230 Instruction Booklet. The Zanussi manuals for Fridge freezer are available online for free. You can easily download all the documents as PDF.
Page 11
11 Door reversal The appliance’s door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove the relevant pins at the top and at the bottom.Attention After completion of the door reversing operation, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by...
Page 12
12 If you fit your own plug, the colours of the wires in the mains lead of your appliance, may not correspond with the markings identifying the terminals in your plug, proceed as follows: Connect the Green and the Yellow (earth) wire to the terminal in the plug which is marked with the letter «E» or the earth symbol , or coloured green and yellow. Connect the blue (neutral) wire to the terminal in the plug which is marked with the letter «N» or coloured black. Connect the brown (live) wire to the...
Page 13
13 Dimensions of the recessZI 9155 AZI 9225 A Height of housing (1) mm 880 1225 Depth of housing (2) mm 550 550 Width of housing (3) mm 560 560 It is necessary that the cabinet has a ventilation recess with the following dimensions: Depth 50 mm Width 540 mm Building in PR0 54050 3 2 1 For appropriate venting, follow indications in the figure. 50 mm min. 200 cm2 200 cm 2 min. D526 2. Press in the joint covers between the appliance and the kitchen furniture. D132 3. Open the door and push the appliance...
Page 14
PR167 Ha Hb 8mm 14 6. Place guide (Ha) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. After having drilled holes, fix the guide with the screws supplied. 8. Open the appliance door and the furniture door at90°. Insert the small square (Hb) into guide (Ha). Put together the appliance door and the furniture door and mark the holes as indicated in the figure. 5. Separate parts Ha, Hb, Hc, Hdas shown in the figure. 7. Fix cover (Hc) on...
Page 15
15 10. Place the small square on the guide again and fixit with the screws supplied. Should the alignment of the furniture door be necessary, use the clearance of slots. At the end of this procedure , it is necessary to check if the door of the furniture closes properly. PR168Hb 11. Fix cover ( Hd) on the small square (Hb) until it clips into place. PR167/1 Hd Hb