Zanussi Zdf 501 User Manual

21
The wash results are not satisfactory
The dishes are not cleanThe wrong washing programme has been selected.
The dishes were arranged in such a way as to stop water reaching all parts 
of the surface. The baskets must not be overloaded.
The spray arm do not rotate freely due to incorrect arrangement of the load.
The filters in the base of the washing compartment are dirty or incorrectly 
positioned.
Too little or no detergent has been used.
Where there are limescale deposits on the dishes; the...

22
Technical data
Consumption values
Dimensions Width 60 cm
Height  85 cm
Depth. 61 cm
Water supply pressure Minimum 0,05 MPa (0.5 bar)
Maximum 0,8 MPa (8 bar)
Electrical connection Information on the electrical connection is given on the rating plate on
Voltage - Overall power - Fuse the inner edge of the dishwasher’s door.
Capacity 12 place settings
Noise level 47 dB (A)
Max. weight41 kg
The consumption values are intended as a
guide and depends on the pressure and the
temperature of the water and also...

23
Testing in accordance with EN 60704must be
carried out with appliance fully loaded and
using the test programme (see "Consumption
values").Test in accordance with EN 50242must be
carried out when the salt container and rinse
aid dispenser have been filled with salt and
rinse aid respectively and using the test
programme (see "Consumption values").
Hints for test institutes
Full load:
12 standard place settings
Amount of detergent required: 5 g + 25 g (Type B)
Rinse aid setting:...

24
CAUTION!
If the machine is connected to new pipes or pipes which have not been used for a long time, you
should run the water for a few minutes before connecting the inlet hose.
Inlet hose
Connect the inlet hose to a water tap with an
external thread of 3/4”.
The inlet hose can be turned either to the left or the
right to suit the installation by means of the locknut.
The locknut must be correctly fitted to avoid water
leaks.
Drain hose
- Connect drain hose to the sink. Secure it with the
supplied...

25
Ensure that the hoses
are not kinked, crushed
or entangled.
CAUTION!
Always be sure, that there is no water leakage
from hoses and their connections after the
installation.
WARNING!
Multi-way plugs, connectors and extension
cables must not be used. This could constitute
a fire hazard through overheating.
If necessary, have the domestic wiring system
socket replaced. In case that the electrical
cable has to be replaced, contact your local
Service Force centre.
The plug must be accessible after the...

26
Fitting under a counter
By removing the dishwasher’s worktop, you
can install it under a close fitting sink unit or a
pre-existing top.Be sure that once the appliance has been
installed, it is easily accessible for the service
engineer in the event that a repair is required.
Unscrew the two screws
at the rear.Push the top backwards
about 1 cm.Lift top at the front and
remove it.
Check if the dishwasher
is levelled.If not, loosen or tighten
the adjustable feet until
the appliance is
perfectly...

27
Service and spare parts
In the event of your appliance requiring
service, or if you wish to purchase spare parts
please contact your local Service Force Centre
by telephoning:
08705 929929
Your telephone call will be automatically routed
to the Service Force Centre covering your post
code area. 
For the address of your local Service Force
Centre and further information about Service
Force, please visit the website at
www
.serviceforce.co.uk
Before calling out an engineer, please ensure
you read the...

28
Guarantee conditions
Standard Guarantee Conditions
We, Zanussi-Electrolux, undertake that if within
12 months of the date of purchase this
ZANUSSI-ELECTROLUX appliance or any part
thereof is proved to be defective by reason
only of faulty workmanship or materials, we
will, at our option repair or replace the same
FREE OF CHARGE for labour, materials or
carriage on condition that:
The appliance has been correctly installed
and used only on the electricity supply stated
on the rating plate.
The...

29
This appliance is guaranteed by Electrolux, in
each of the countries listed in the following
page, for the period specified in the appliance
guarantee or otherwise by law. If you move
from one of these countries to another of these
countries the appliance guarantee will move
with you subject to the following qualifications:
The appliance guarantee starts from the date
you first purchased the appliance which will
be evidenced by production of a valid
purchase document issued by seller of the...

30
www.electrolux.com
Albania +35 5 4 261 450 Rr. Pjeter Bogdani Nr. 7 Tirane
Belgique/België/Belgien +32 2 363 04 44 Bergensesteenweg 719, 1502 Lembeek
Danmark +45 70 11 74 00 Sjællandsgade 2, 7000 Fredericia
Eesti +37 2 66 50 030 Mustamäe tee 24, 10621 Tallinn
France www.electrolux.fr
Hellas +30 23 10 56 19 70 4 Limnou Str., 54627 Thessaloniki
Ireland +353 1 40 90 753 Longmile Road Dublin 12
Latvija +37 17 84 59 34 Kr. Barona iela 130/2, LV-1012, Riga
Hrvatska +385 1 63 23 338 Slavonska avenija 3,...