Zenoah Blower HB2302 HBZ2601 Owners Manual

GB-1
G
B
HB2302 / HBZ2601
HB2302
HBZ2601
G
B
OWNER’S MANUAL
BLOWERS 

GB-2
HB2302 / HBZ2601
EXPLANATION OF SYMBOLS AND SAFETY WARNINGS
WARNING!!!
RISK OF DAMAGING HEARING
IN NORMAL CONDITIONS OF USE, THIS MACHINE
MAY INVOLVE A DAILY LEVEL OF PERSONAL EXPOSURE TO NOISE
FOR THE OPERATOR EQUAL TO OR GREATER THAN
85 dB(A)
SOUND LEVEL VIBRATION LEVEL
ON HANDLE
ISO 11094
LwA
measuredguaranteedISO 7916
racingMODEL
idling
HB2302 22.5cm3104dB(A) 106dB(A) 4.7m/s211.1m/s2
HBZ2601 25.4cm3104dB(A) 106dB(A) 4.7m/s211.1m/s2
APPROVAL NUMBER OF CE EXHAUST EMISSION REGULATION (2002/88/EC)...

GB-3
G
B
HB2302 / HBZ2601
1. Parts location
1. Stop Switch
2. Throttle Lever
3. Air Intake Screen (Air inlet net)
4. Spark Plug Cap
5. Recoil Starter Knob
6. Air Cleaner
7.Fuel Tank
8. Blower Pipe
9. Screw
SAFETY FIRST
Instructions contained in warnings within this manual marked
with a  
symbol concern critical points which must be taken
into consideration to prevent possible serious bodily injury, and
for this reason you are requested to read all such instructions
carefully and follow them without...

GB-4
HB2302 / HBZ2601
Model HB2302 HBZ2601
Dimensions (LxWxH) mm 325 x 230 x 360 327 x 268 x 360
Dry weight (w/o tube and nozzle) kg 3.7 3.9
Fuel tank capacity liter 0.75 0.65
Engine TypeAir cooled 2-cycle gasoline engin
Displacement cm322.5 25.4
Carburetor Diaphragm type (Walbro)
Ignition system T.C.I. C.D.I.
Spark plug Champion RCJ6Y (noise proof) NGK CMR7A
Muffler Spark arrester equipped
Operating Engine Speed rpm 2300 to 7500 2800 to 7890
Idle speed rpm 2300 2800
Average Air Volume cu.m/min. 10 10...

GB-5
G
B
HB2302 / HBZ2601
1. Read this manual carefully until
you completely understand and
follow all safety and operating
instructions.
2.Keep this manual handy so that
you may refer to it later when-
ever any questions arise. Also
note, if you have any questions
which cannot be answered
herein, contact the dealer from
whom you purchased the prod-
uct.
3.Always be sure to include this
manual when selling, lending, or
otherwise transferring the own-
ership of this product.
4. Do not lend or rent your...

GB-6
HB2302 / HBZ2601
morning or late at night when
people might be disturbed. Com-
ply with times listed in local ordi-
nances.
2. To reduce sound levels, limit the
number of pieces of equipment
used at any one time.
3.Operate power blowers at the
lowest possible throttle speed to
do the job.
4.Check your equipment before op-
eration, especially the muffler, air
intakes and air filters.
WORKING PLAN
 •When planning your work sched-
ule, allow plenty of time to rest.
Limit the amount of time over
which...

GB-7
G
B
HB2302 / HBZ2601
c)Do not allow bystanders in work
area.
d) Do not point the blower nozzle in
the direction of people or pets.
e)Always check to be sure that no
debris has been blown onto
someone else’s property.
f)Pay attention to the direction of
the wind, do not work against the
wind.
3. To minimize blowing time.
a) Use rakes and brooms to loosen
debris before blowing.
b)In dusty conditions, slightly
dampen surfaces or use mister
attachment when water is avail-
able.
c)Conserve water by using...

GB-8
HB2302 / HBZ2601
6. Set up
BLOWER PIPE
•Align groove in blower pipe with projection on blower
housing (or another blower pipe) and slide the pipe
onto the blower housing (or another blower pipe).
Rotate the pipe clockwise to lock it into place. 

GB-9
G
B
HB2302 / HBZ2601
■ RECOMMENDED MIXING RATIO
    GASOLINE 50 : OIL 1
•Exhaust emission are controlled by the funda-
mental engine parameters and components (eq.,
carburation, ignition timing and port timing) with-
out addition of any major hardware or the intro-
duction of an inert material during combustion.
•These engines are certified to operate on unleaded
gasoline.
•Make sure to use gasoline with a minimum octane
number of 89RON (USA/Canada: 87AL).
•If you use a gasoline of a lower octane...

GB-10
HB2302 / HBZ2601
RESTARTING ENGINE WHILE ENGINE IS HOT
1. When restarting the engine immediately after stop-
ping it, leave the choke open.
2. If the engine won’t start after several attempts, close
the choke and repeat pulling the rope or remove the
spark plug and dry it.
ADJUSTING IDLE SPEED
1. When the engine tends to stop frequently at an idle
mode, turn the adjusting screw clockwise.
 
NOTE
•Warm up the engine before adjusting the idle speed.
STOPPING ENGINE
•Move the throttle lever to the...