Acer Aspire 5741g Service Guide

							Chapter 381
8.Remove four (4) screws from the LCD assembly.
9.Remove the LCD assembly from the lower cover.
StepSizeQuantityScrew Type
LCD assembly M2.5*8 4 
						

							82Chapter 3
Removing the LCD Bezel
1.See “Removing the LCD Assembly” on page 79.
2.Remove the two bezel screw caps and screws.
3. Starting from the bottom edge of the bezel, pry the bezel upwards and away from the panel. Work along the 
right side toward the top of the bezel, prying the covers apart. Continue along the top edge and down the left 
side to remove the bezel.
NOTE: If necessary, use a pry to lift up the outside edges of the bezel. 
StepSizeQuantityScrew Type
LCD Bezel M2.5*6 2 
						

							Chapter 383
Removing the Camera Module
1.See “Removing the LCD Assembly” on page 79.
2.Locate the Camera Module at the top of the LCD Module and disconnect the camera cable.
3.Remove the Camera from the module. 
						

							84Chapter 3
Removing the LCD Panel
1.See “Removing the Camera Module” on page 83.
2.Remove the two (2) securing screws from the LCD Panel.
3.Remove the adhesive strip holding the cables in place.
4.Remove the cable from the LCD Module as shown.
StepSizeQuantityScrew Type
LCD Panel M2.5*6 2 
						

							Chapter 385
5.Lift the LCD Panel clear of the module. 
						

							86Chapter 3
Removing the LCD Brackets and FPC Cable
1.See “Removing the LCD Panel” on page 84.
2.Remove the six (6) securing screws (three on each side) from the LCD Panel brackets.
3.Remove the LCD brackets by pulling away from the LCD Panel.
StepSizeQuantityScrew Type
LCD Brackets M2*3 6 
						

							Chapter 387
4.Turn the LCD panel over to expose the rear. Pull the cable up as shown.
5.Remove the adhesive tape from the cable.
6.Peel back the mylar securing the LVDS cable. 
						

							88Chapter 3
7.Disconnect the LVDS cable from the panel. 
						

							Chapter 389
Removing the Microphone Cable 
1.See “Removing the LCD Panel” on page 84.
2.Remove the cable bundle from the hinge channel. 
3.Peel back the foil tabs and remove the microphone cable from the cable channel.
4.Continue removing the cable from the cable channel.  
						

							90Chapter 3
5.Lift the microphone set clear of the panel.