Acer Aspire 5741g Service Guide

							Chapter 391
Removing the Antennas 
1.See “Removing the LCD Panel” on page 84.
2.Remove the black antenna from the cable channel.
3.Peel back the foil tabs and remove the cable from the cable channel.
4.Pry the antenna assembly clear of the device. 
						

							92Chapter 3
5.Remove the white antenna from the hinge channel.
6.Peel back the foil tabs and remove the cable from the cable channel.
7.Pry the antenna assembly clear of the device. 
						

							Chapter 393
LCD Module Reassembly Procedure
Replacing the Antennas
1.Adhere the white antenna assembly to the LCD cover.
2.Run the cable along the cable channel and fold over the foil tabs to secure the cable in place.
3.Run the white antenna along the hinge channel. 
						

							94Chapter 3
4.Adhere the black antenna assembly on the LCD cover.
5.Run the cable along the cable channel and fold over the foil tabs to secure the cable in place.
6.Run the black antenna cable along the cable channel. 
						

							Chapter 395
Replacing the Microphone Cable
1.Place the microphone set in the panel.2.Run the cable along the cable channel. 
3.Fold over the foil tabs and continue running the 
microphone cable along the cable channel 
indicated between the red callouts.4.Run the cable bundle along the hinge channel.
IMPORTANT: Ensure that the LCD cable runs between the callouts to avoid trapping when the panel is replaced 
in the LCD Module. 
						

							96Chapter 3
Replacing the LCD Brackets and FPC Cable
1.Connect the LVDS cable to the LCD panel.
2.Adhere the LVDS mylar to the LCD panel.
3.Adhere the LVDS cable to the panel by running it between the callouts as shown. 
						

							Chapter 397
4.Attach the LCD brackets to the LCD Panel.
5.Replace six (6) securing screws (three on each side) of the LCD Panel brackets. 
						

							98Chapter 3
Replacing the LCD Panel
1.Place the LCD Panel in the module.2.Run the cable along the channel in the LCD 
Module as shown.
3.Apply the adhesive strip to hold the cable in place.4.Secure the panel using two (2) securing screws. 
						

							Chapter 399
Replacing the Camera Module
1.Place the Camera in the module.2.Connect the camera cable. 
						

							100Chapter 3
Replacing the LCD Bezel
1.Replace the bezel and press down until there are no gaps between the bezel and the LCD Module.
IMPORTANT: Ensure that the LCD cables pass through the hinge wells and are not trapped by the bezel.
2.Replace the two (2) screws and screw caps.