ADT Security Services GD00Z2Garage Door Opener Controller Installation Guide

9
Controller Mounting
Mounting the Controller in the Garage
The Garage Door Controller mounts in the garage near the garage door opener. It will need 
to be near a power outlet and where its warning lamp can be seen, regardless of the door 
position. Un-plug the garage door opener before continuing.
The Garage Door Controller can be screw mounted directly, or by using the supplied 
adjustable mounting bracket.
1. Use the four anchors and screws to directly mount the Controller (use a 3/16” drill for 
the...

10
Wiring the Controller to the Opener
The Garage Door Controller wires to the garage door opener with a two wire connection.
1. Connect the GD00Z-2 connection wires to the two pushbutton terminals on the garage 
door opener. The terminals on various models may have different names. Either wire 
can connect to either terminal.
  ✓IMPORTANT! Be sure the wires clear all moving parts of the door and opener.
Connecting the Power Supply
2. Plug the Power Supply’s cord into the jack on the Garage Door...

11
Opening and Closing the Garage Door
After the installation is complete, the garage door opener can be activated by the ADT 
Pulse system and the door’s status can be viewed through the system.
1. Restore power to the garage door opener.
2. Cycle the door open and closed using the wall pushbutton to synchronize the system.
3. Command the ADT Pulse system to activate the garage door.
4. Verify that the Garage Door Controller  ashes for  ve seconds before the door moves.
5. The door should open or...

12
Operation Notes
Indications and Operation Notes
  ◆The warning light will  ash and the warning beeper will sound for  ve seconds before the 
door opener is activated. STAY CLEAR OF THE DOOR, AND DOOR OPENER. THEY ARE 
ABOUT TO MOVE!
  ◆If the door does not completely open or close after remote activation, the Controller 
will allow user to try to operate the door one more time. If the second attempt fails, the 
Controller will go into lock-out mode. See next paragraph.
  ◆If the GD00Z-2 is in lock-out...

13
If Something is not Working
Refer to the following table for information regarding possible problems and solutions if the 
Garage Door Controller is not operating as expected.
PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The Controller does not  ash or 
beep when activated.No power to the 
Controller1. Make sure the power supply 
is plugged in securely to a live 
outlet.
2. Make sure the power cord 
is plugged in securely to the 
Controller
The Controller  ashes and beeps 
when activated but the door does...

Copyright © 2014 Linear LLC235971 X22
®