Advidia Encoder Vp 8 V2 Vp 16 V2 Quick Start Guide

							 VP-8-V2 and VP-16-V2 Series Encoder · Quick Start Guide 11   Table 2. 1 Icon Description Icon Description   Select the split window mode / Start/Stop live view   Capture pictures in live view mode / Manually start/stop recording   Enable e-PTZ   Previous page  Next page / Audio on/off / Start/Stop two-way audio   Switch to full-screen live view mode.   Before  using  two-way  audio  function  or  recording  with  audio,  please  select  the Video Type to Video  &  Audio under Remote Configuration > Camera Settings >Video Settings.  2.5 Operating PTZ Control Before you start: 1. Make  sure  the  encoder  is  connected  with  the  camera/dome  which  supports  PTZ  function.  Connect  the R+ and R- terminals of the pan/tilt unit or speed dome to RS-485 T+ and RS-485 T- terminals of the V2 ENCODER respectively. 2. The baud rate, PTZ control and address configured in the RS-485 Settings interface (Remote Configuration > Serial Port Settings > 485 Serial Port) must be the same with the parameters of the connected pan/tilt unit or speed dome.    Operating PTZ Control In live view mode, you can use the PTZ control buttons to realize pan/tilt/zoom control of the camera lens.  There will be 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the display window when the mouse is located in the relative positions. Click on the directional buttons to control the pan/tilt movement.  
						

							 VP-8-V2 and VP-16-V2 Series Encoder · Quick Start Guide 12  Figure 2. 4 PTZ Click the zoom/iris/focus buttons to realize lens control. Refer to the following table for description of PTZ control buttons:  Table 2. 2  Button Description Button Description  Zoom in/out  Focus near/far   Iris open/close  Light on/off  Wiper on/off   Adjust speed of pan/tilt movement  (level 1to 7 is selectable)  1) Alarm. 2) Check the checkbox of Select All and click Copy to copy settings of this day to the whole week. You can also check any of the checkboxes before the date and click Copy. 3) Click OK to save the settings and exit the Edit Schedule interface. 1. On the Schedule Settings interface, click Advanced to configure advanced record parameters. 2. Click Save to validate the above settings.