AEG Heat pump dryer T88595IS User Manual

							2.Move the plastic connection out and
drain the water into a basin or
equivalent receptacle.
3. Move plastic connection in and install
water container.
4. To continue the programme press
the Start/Pause button.
12.3  Cleaning the heat
exchanger
If the symbol  Condenser flashes on
the display, do the inspection of the heat exchanger and its compartment. If there
is a dirt, clean it.
To do the inspection:
1. Open the door. Pull the filter.
2.Move the release button on the
bottom of the door to open the heat
exchanger door.
3. Turn the blockage to unlock the heat
exchanger cover.
4. Lower the heat exchanger cover.
5.If necessary clean the small water
filter from the bottom of the
compartment. Put the small water
filter back.
ENGLISH21        
						

							6.If necessary, remove the fluff from
the heat exchanger and its
compartment. You can use wet cloth and/or a vacuum cleaner with the
brush.
7. Close the heat exchanger cover.
8. Lock the blockage until it snaps.
9. Put the filter back.
12.4  Cleaning the steam
system filterCAUTION!
Do not use the steam
programmes without the
steam system filter or with
damaged or blocked filter.
If the symbol  (clean the steam system
filter is on the display you must clean the
filter.
To clean the steam system filter:
1. Pull the water container. Keep it in
horizontal position.
2. Pull the filter.
3.Clean the filter with warm water
using a brush.
4. Put the filter inside the filter socket.
5. Put the water container.
12.5  How to drain the water
from the steam system
containerThe quality of the water in
the container can get worse.
If you will not use the
appliance for long period
drain the water from the
container.
To drain the water:
1. Open the door.
2. Move the release button on the
bottom of the door to open the heat
exchanger door.
www.aeg.com22     FILTER FILTER   
						

							3.Turn the blockage to unlock the heat
exchanger cover.
4. Lower the heat exchanger filter
cover.
5. Lift the primary filter. Hold the heat
exchanger filter and pull it out from
the bottom compartment.
6. Open the cap from the pipe and
drain the water.
7. Close the cap.
8.Put the heat exchanger filter back.
9. Close the heat exchanger filter cover.
10. Lock the blockage until it snaps.
11. Close the heat exchanger filter door.
12. Put the primary filter back.
12.6  Cleaning the drumWARNING!
Disconnect the appliance
before you clean it.
Use a standard neutral soap detergent to
clean the inner surface of the drum and
drum ribs. Dry the cleaned surfaces with a soft cloth.
CAUTION!
Do not use abrasive
materials or steel wool to
clean the drum.ENGLISH23         
						

							12.7 Cleaning the control
panel and housing
Use a standard neutral soap detergent to
clean the control panel and housing.
Use a moist cloth to clean. Dry the
cleaned surfaces with a soft cloth.CAUTION!
Do not use furniture
cleaning agents or cleaning
agents which can cause
corrosion to clean the
appliance.12.8  Cleaning the airflow slots
Use a vacuum cleaner to remove the fluff from the airflow slots.13.  TROUBLESHOOTINGProblem 1)Possible causeRemedy
The tumble dry-
er does not op-
erate.
The tumble dryer is not connected
to mains supply.Connect in at mains socket. Check
fuse in fuse box (domestic installa-
tion).The loading door is opened.Close the loading door.The On/Off button was not push-
ed.Push the On/Off button.The Start/Pause button was not
pushed.Push the Start/Pause button.The appliance is in the standby
mode.Push the On/Off button.
Unsatisfactory
drying result.
Incorrect programme selection.Do the selection of the applicable
programme. 2)The filter is clogged.Clean the filter. 3)The Dry Plus option was in mini-
mum level. 4)Change the Dry Plus option to the
moderate or maximum level. 4)Too high volume of the load.Obey the maximum load volume.The airflow grill is clogged.Clean the airflow grill in the bot-
tom of the appliance.Dirt on the humidity sensor in the
drum.Clean the front surface of the
drum.Incorrect remaining laundry mois-
ture degree.Adjust remaining laundry moisture
degree. 5)The heat exchanger is clogged.Clean the heat exchanger. 3)www.aeg.com24  
						

							Problem 1)Possible causeRemedyThe loading
door does not
closedThe filter not locked in the posi-
tion.Put the filter in the correct posi-
tion.The laundry is locked between the
door and the seal.Put the load correctly in the drum.
Err (Error) on
the display.
You try to change the programme
or the option after the start of the
cycle.Turn the tumble dryer off and on.
Make the new selection.The option you try to activate is
not applicable with the selected
programme.Turn the tumble dryer off and on.
Make the new selection.No drum lightDefective drum lamp.Contact the service centre to re-
place the drum lamp.Abnormally
elapsing time on
the display.The time to end is calculated on
the basis of the volume and damp-
ness of the laundry.The automatic procedure — this is
not the appliance malfunction.Programme in-
active.The water container is full.Drain the water container, push
the Start/Pause button. 3)
Drying cycle too
short.
Too small laundry volume.Do the selection of time pro-
gramme. The time value must be
related to the load. To dry 1 item
or small quantities of the laundry
we recommend to use short times.The laundry is too dry.Do the selection of time pro-
gramme or higher drying level
(e.g. Extra Dry)
Drying cycle too
long 
6)The filter is clogged.Clean the filter.Too high volume of the load.Obey the maximum load volume.The laundry not spun sufficiently.Spin correctly the laundry.Very high room temperature - this
is not the appliance malfunction.If possible, lower the room tem-
perature.Steam functionSteam pro-
gramme does
not start.There is no water in the container
for the steam system. Indicator is
on.Fill the container with the distilled
or demineralized water.ENGLISH25 
						

							Problem 1)Possible causeRemedy
Unsatisfactory
drying result.
Steam load too low.Extend the steam load.Incorrect programme selection.Do the selection of the applicable
programme. 7)Incorrect load/type of the cloths.Use applicable load/type of
clothes.1)  If there is an error message on the display (e.g.  E51): Turn the tumble dryer off and on. Make a selec-
tion of the new programme. Push the Start/Pause button. Does not operate? - contact the service centre and give the error code.
2)  Follow the programme description — see PROGRAMME TABLE
3)  See chapter CARE AND CLEANING
4)  Only dryers with the Dry Plus option
5)  See HINTS AND TIPS chapter
6)  Note: After maximum 5 hours the drying cycle ends automatically.
7)  Follow the steam programme description.14.  TECHNICAL DATAHeight x Width x Depth850 x 600 x 600 mm (maximal 640 mm)Max. depth with the appliance door open1090 mmMax. width with the appliance door open950 mmAdjustable height850 mm (+ 15 mm - feet regulation)Drum volume118 lMaximum load volume9 kgVoltage230-240 VFrequency50 HzNecessary fuse13 ATotal power1650 WEnergy efficiency classA++Energy consumption1)2,28  kWhAnnual energy consumption2)259 kWhLeft—on mode power absorption0,50 WOff mode power absorption0,50 WType of useHouseholdPermitted ambient temperature+ 5°C to + 35°Cwww.aeg.com26 
						

							Level of protection against ingress of solid
particles and moisture ensured by the pro-
tective cover, except where the low voltage
equipment has no protection against mois-
tureIPX41)  With reference to EN 61121. 9kg of cotton centrifuged at 1000 rpm.
2)  Energy consumption per year in kWh, based on 160 drying cycles of the standard cotton programme
at full and partial load, and the consumption of the low-power modes. Actual energy consumption per
cycle will depend on how the appliance is used (REGULATION (EU) No 392/2012).15.  INSTALLATION15.1  UnpackingCAUTION!
Before use all parts of the
transport packaging must be
removed.
To remove the polystyrene blockages:
1. Open the door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
15.2  Feet regulation
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet.
15.3  Installation under a
counter
The appliance can be installed as
freestanding or below the kitchen
counter with correct space (see picture).ENGLISH27  15mm > 850 mm600 mm600 mm  
						

							16. ENVIRONMENTAL CONCERNSRecycle the materials with the symbol .
Put the packaging in applicable
containers to recycle it. Help protect the
environment and human health and to recycle waste of electrical and electronic
appliances. Do not dispose appliances
marked with the symbol 
 with the
household waste. Return the product to
your local recycling facility or contact
your municipal office.
*
www.aeg.com28   
						

							ENGLISH29 
						

							www.aeg.com30