Home > AEM > Analog Performance Gauges > AEM Analog E85 Wideband UEGO Gauge E85 AFR 305143 User Manual

AEM Analog E85 Wideband UEGO Gauge E85 AFR 305143 User Manual

Add to Favourites
    Download as PDF

    View the AEM Analog E85 Wideband UEGO Gauge E85 AFR 305143 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempower.com Instruction Part Number: 10-5130 Rev 02  2009 AEM Performance Electronics Part Number 30-5143 E85 Analog Wideband Air/Fuel Ratio Gauge Figure 1. Wiring Schematic AEM Gauge-Type UEGO Controller Parts 1 x 35-5143(B/W) E85 UEGO Gauge Assembly 1 x 30-2001 UEGO Sensor 1 x 35-8535 Install Kit (O2 Bung with 6 Butt Connectors) 1 x 10-5143 Installation...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16th” (52MM) mounting hole with the supplied bracket. 3. Plug the 8-wire power harness into the mating connector on the back of the gauge and connect the wires as shown in Figure 1. Note: the locating tabs on the side of the connector should be nearest the center of the gauge. 4. Mount the sensor as shown in figure 2. 5. Connect the sensor to the gauge using the 6-wire sensor cable. The connector with...
    Page 3 Page 3 Sensor Mounting A weld-in M18 X 1.5 boss is supplied for sensor installation. Mount the O2 sensor in the exhaust system at least 18 inches downstream from the exhaust port. If you anticipate high EGTs (over 800C), run a turbocharger, run at high RPM for extended periods of time or plan on running leaded race fuel then you must mount the sensor at least 36 inches or more downstream of the exhaust port as all of these can cause the sensor to overheat. On turbocharged engines the UEGO...
    Page 4 Page 4 Backlighting The Analog Wideband UEGO Gauge has 7 different backlight colors available to the end user, which closely match some of the more common factory dash panels: white, blue, green, red, orange, light blue, and aqua. To change the backlight color, rotate the backlighting switch using a small precision style screwdriver. The backlight switch is accessed through the small hole in the back of the gauge. Status Lights The AEM UEGO gauge has two status lights, see Figure...
    Start reading AEM Analog E85 Wideband UEGO Gauge E85 AFR 305143 User Manual

    Related Manuals for AEM Analog E85 Wideband UEGO Gauge E85 AFR 305143 User Manual

    All AEM manuals