Home > AEM > Analog Performance Gauges > AEM Analog EGT SAE Gauge 305131 User Manual

AEM Analog EGT SAE Gauge 305131 User Manual

Add to Favourites
    Download as PDF

    View the AEM Analog EGT SAE Gauge 305131 User Manual for free. All the AEM manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 AEM Performance Electronics 2205 126th Street Unit A, Hawthorne, CA. 90250 Phone: (310) 484-2322 Fax: (310) 484-0152 http://www.aempower.com Instruction Part Number: 10-5131 Rev 04  2009 AEM Performance Electronics Part Number 30-5131 Analog EGT Gauge Figure 1. Wiring Schematic AEM EGT Gauge Parts 1 x 35-5131(B/W) EGT Gauge Assembly 1 x 30-2065 EGT Sensor Thermocouple w/Mount 1 x 35-4302 Install Kit (6 Butt Connectors) 1 x 10-5131 Installation Instructions 1 x 35-3411 8-Pin Power...
    Page 2 Page 2 INSTALLATION 1. Disconnect the negative battery cable. 2. Secure the gauge in a 2 1/16th” (52MM) mounting hole with the supplied bracket. 3. Plug the 8-wire power harness into the mating connector on the back of the gauge and connect the wires as shown in Figure 1. Note: the locating tabs on the side of the connector should be nearest the center of the gauge. 4. Connect the sensor cable to the gauge. The locating tabs should be closest to the center of the gauge. 5. Mount the...
    Page 3 Page 3 Thermocouple Mounting The thermocouple included in the kit comes with a stainless steel compression style mounting adapter. The mounting adapter consists of three pieces: compression nut, ferrule sleeve, threaded body. The threaded body has 1/8” NPT male threads. To install the sensor, the threaded body can either be threaded into a hole with mating 1/8” NPT threads, or welded to the pipe/manifold. Remove the compression nut, ferrule sleeve, and thermocouple from the threaded body....
    Page 4 Page 4 Changing the Bezel The AEM Analog EGT Gauge comes with the black bezel installed. However, a silver bezel is also included in the gauge kit. To change the bezel, orient the gauge so you are looking at the faceplate. Rotate the bezel counter-clockwise to unscrew it from the gauge cup. The bezel, lens, and rubber spacer are all removable. Reassemble the gauge as shown below in Figure 4. Do not over tighten the bezel when reassembling the gauge....
    Start reading AEM Analog EGT SAE Gauge 305131 User Manual

    Related Manuals for AEM Analog EGT SAE Gauge 305131 User Manual

    All AEM manuals