AL-KO AKS 3004 Security Device Instructions User Manual

							OPERATING INSTRUCTIONS FOR 
AL-KO SECURITY DEVICE FOR AKS 2004/3004 STABILISERS
INTRODUCTION
The AL-KO Security Device is effective against the following:
a Uncoupling from the towing vehicle
b Coupling onto another towing vehicle
c Theft of the Coupling/Stabiliser from the trailer/caravan.
The AL-KO Security Device can also remain fitted to the caravan 
whilst the caravan and car are hitched together. This alleviates 
the need to stow the device when travelling as it remains fitted 
to the stabiliser. This ensures that stops, (e.g. at motorway 
service areas) are less stressful, allowing you to enjoy your 
stop without the need to ‘guard’ your caravan.
MAINTENANCE
Clean strain bolt, and the cutaway portion in the locking 
brackets if they become dirty. A little grease may be applied but 
remove excess with a cloth so that only a thin film remains. 
For general lubrication use a Graphite based spray powder.
Operate the locking cylinder periodically, if the cover has not 
been used for a while. If the lock only operates with difficulty, 
spray the cylinder with WD 40 (or similar).
APPROVAL
This product holds full TUV approval.
 
WARRANTY
Product warranty is given in accordance with S10, Clause 1-7 of 
the General Terms of Business and is usually 12 months from 
date of purchase.
Fig 1 AL-KO Security Device 
						

							AL-KO Kober Ltd, South Warwickshire Business Park, Kineton Road, Southam, Warwickshire, CV47 OALE-Mail: [email protected] www.AL-KO.co.uk
Due to a policy of continuous improvement, AL-KO reserves the right to change technical specifications.  Part No. 1389609 Iss. 4 07/12
OPERATION
1 Pull stabiliser lever to the ‘up’ position (Fig 2).
2 Place the AL-KO Security Device over the coupling handle 
and lower into bracket sections keeping the Security Device 
in a horizontal position. Slide the Security Device forward 
until the small ‘lug’ at the front locates into the open slot of 
the Stabiliser.
3 Place the key into the lock and turn to the left and push in. 
4 Remove key and swing the dust cover over the lock to 
protect against dirt.
5 Push stabiliser lever to ‘down’ position - it’s now operational.
6 Removal takes place in reverse order, turning the key to the right.
AL-KO SAFETY BALL
AL-KO recommends the use of the AL-KO Safety Ball to 
complement the AL-KO Security Device. The Safety ball is 
inserted into the coupling area of the Stabiliser, before the 
AL-KO Security Device is locked into position (Fig 3). This 
prevents your caravan from being coupled to any other tow 
hook or smaller towball and being towed away.
OPERATING INSTRUCTIONS FOR 
AL-KO SECURITY DEVICE FOR AKS 2004/3004 STABILISERS
Fig 2 Operating the security device
Fig 3 Safety ball placement