Home > Alarm Lock > Alarm Lock > Alarm Lock Door Alarms PG21 Series Installation Instructions

Alarm Lock Door Alarms PG21 Series Installation Instructions

Add to Favourites
    Download as PDF

    View the Alarm Lock Door Alarms PG21 Series Installation Instructions for free. All the Alarm Lock manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 1 PG21 Series Pilfergard Door Alarms INSTALLATION INSTRUCTIONS WI738F 1/06 345 Bayview Avenue Amityville, New York 11701 For Sales and Repairs, (800) 645-9445 For Technical Service, (800) 645-9440 © ALARM LOCK 2006 AL ARM LOCK DESCRIPTION The PG21 is a microprocessor-controlled door alarm for sur- face mounting on a door or door frame. Typical applications include emergency fire escape doors, nursing home stairwell doors, rear restaurant and theater doors. The PG21 is de- signed to...
    Page 2 2 7. Position the Magnetic Actuator as indicated by the red sticker on the side of the Housing Cover. If stickers were removed, use the Magnet Alignment Mode (see page 3) or place the Magnetic Actuator 1½ from the bottom edge of the Baseplate. Mark holes and (as with the Baseplate) use a 1/8 (0.125) bit, and drill the hole 1 deep. 8. Install the Magnetic Actuator with the supplied #8 sheet- metal screws (1). Be sure to insert the Magnet (P1358) and Magnet Cover (P0291) into the Magnet...
    Page 3 3 2. Reed selection jumper W1 is located in the center of the PCB. The jumper should be set to the side of the unit that will have the magnet installed. (See Figure 5 below). 3. Select jumper options (J1- J9) as follows. (Refer to the Jumper Options table, below and page 5). Important: The jumpers are only read at startup and when- ever the unit is armed. If the jumpers are changed after power up, the unit must be rearmed before the jumper changes take effect....
    Page 4 4 D. MOUNTING Before mounting, install a mortise cylinder into the Housing Cover (H354-28) as follows: 1. Referring to the Figure 5 at right, (a) install mortise cylinder (Alarm Lock Model CEM, optional) into the Housing Cover from the outside with the key slot at the 6 oclock position; (b) install the Locking Arm (HW1154). Be sure to route the strobe wire under the Locking Arm to avoid interfer- ence (see Fig 5b), then screw the Lock Ring (P1267) onto...
    Start reading Alarm Lock Door Alarms PG21 Series Installation Instructions

    Related Manuals for Alarm Lock Door Alarms PG21 Series Installation Instructions

    All Alarm Lock manuals