Aleratec DVD CD Disc Repair Plus User Manual

USER GUIDE
Aleratec
DVD/CD Disc Repair Plus™
Part No.’s  240131
  240132  

www.aleratec.com
Copyright/Model Identification
The content of this manual is for informational purposes only and is sub\
ject 
to change without notice. 
This manual is copyright with all rights reserved. Under copyright laws,\
 
this manual may not be copied, except in the normal use of the product(\
s) 
described within or to make a backup copy.Copyright© 2008
Aleratec, Inc.
9851 Owensmouth Avenue
Chatsworth, CA 91311 U.S.A.
www.aleratec.com
Aleratec™, DVD/CD Disc Repair Plus™ are trademarks of...

www.aleratec.com
Table of Contents
Introduction ........................................................................\
............... 1
Product Features  ........................................................................\
............. 1
Disc Types Supported  ........................................................................\
..... 1
Precautions  ........................................................................\
...................... 1
Key Items – DVD/CD Disc Repair Plus...

www.aleratec.com 

www.aleratec.com1
Introduction
Thank you for purchasing the DVD/CD Disc Repair Plus. Please read this 
User Guide thoroughly before using this product.
Product Features
Repairs minor scratches, scrapes, and abrasions
•	
Removes	fingerprints,	dust,	and	stains
•	
Forms a protective layer on the disc
•	
Hands-free operation during cleaning/repairing process
•	
Supports 12 cm and 8 cm discs
•	
User-friendly operation with automatic timer
•	
Disc Types Supported
Standard sized (5 inch/12 cm) and Mini (3...

www.aleratec.com
2
Introduction
Key Items – DVD/CD Disc Repair Plus
Note: Choose a Good Location
Allow adequate clearance for moving parts.
1. 
Do not place near heat sources such as radiators or air ducts, or in a p\
lace 
2. 
subject to direct sunlight, excessive dust, mechanical vibration or shoc\
k.
Good care will help assure maximum product life. Improper operating 
3. 
environment and misuse may void the warranty. 
Top Cover
Clean Button Repair Button LED Indicator Open Button Cleaning Kit
Repair...

www.aleratec.com3
Technical Tips
Before starting any procedure, inspect the disc to be repaired to determ\
ine 
the type of procedure needed. It is generally recommended to begin with \
the 
Disc	Cleaning	procedure	first,	and	if	necessary	move	to	the	more	intensive	
procedures.
Use the following as general guidelines for using your DVD/CD Disc 
Repair Plus system:
Minor Damage
The following symptoms may indicate minor damage: scrambled screen, 
signal	skipping,	abnormal	noise,	unstable	signal,	or	cannot...

www.aleratec.com
4
Disc Cleaning Procedure
The Disc Cleaning procedure removes surface contaminants such as dust, 
dirt,	finger	prints,	smudges,	smears	and	stains.	
Open the kit and remove the cleaning head marked “WET”.
1. 
Remove the cleaning head cover and then use the plastic 
2. 
end of the brush to remove the cleaning head and the 
spring.
Remove	the	cleaning	solution	from	the	kit.	 Then,	fill	the	
3. 
cleaning unit with solution until 80% full.
Note: Upon initial use, a sharp object such as a...

www.aleratec.com5
Disc Cleaning Procedure
Insert the disc (data-side facing downward) and then close 
6. 
the top cover.
Press the CLEAN button to begin the cleaning process, 
7. 
which lasts approximately 20 seconds. The machine will 
automatically	stop	when	the	cleaning	process	has	finished.
Once the disc is cleaned, press the OPEN button and 
8. 
remove the disc.
Re-attach the cleaning head cover.
9. 
Note: During continuous usage, the “Dry” cleaning 
head will gather moisture. If it becomes too damp,...

www.aleratec.com
6
Disc Repair Procedure
The Disc Repair procedure is used to polish scratches, scrapes, and othe\
r 
abrasions. It also adds a protective layer to the disc. 
Open the top cover by pressing the OPEN button.
1. 
Remove both of the circular repair heads from the repair 
2. 
protective kit.
Rotate the repair units in a counterclockwise motion until 
3. 
secure.
Place 3 drops of the repair protective solution on the side of 
4. 
the repair head marked “WET”.
Insert the disc (data-side facing...