Home > Altek > Calibrator > Altek 434KP Process Loop Calibrator Manual

Altek 434KP Process Loop Calibrator Manual

Add to Favourites
    Download as PDF

    View the Altek 434KP Process Loop Calibrator Manual for free. All the Altek manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 Milliamp Calibrator Model 434-KP ¥ Calibrate with laboratory accuracy ±(0.015% of reading + 0.002 mA) Accurate to 0.005 mA from 4 to 20 mA ¥ All 4 to 20 mA loop functionsSource and read milliamps Simulate 2-wire transmitters Power transmitters & displays transmitter output Measure voltage from -100.0 to +100.0V DC ¥ Full range 1 microamp resolution0.000 to 24.000 mA and -25.00 to 125.00% of 4 to 20 mA ¥ Powers loop or transmitterDrives to 1200 ohm loads Ð enough for any transmitter or loop ¥ Standard...
    Page 2 Fast milliamp calibrationCalibrate the input of a recorder, computer, valve positioner or any other milliamp input device using the Model 434-KP to source milliamps or to simulate a 2-wire transmitter. The source mode uses the batteries of the Model 434-KP to power the loop, or in 2- wire Simulate mode, uses the power supply in the loop. Store the milliamp values corresponding to the Span and Zero of the device being calibrated into the HI and LO Quik-Chek memories (typically 4.000 and 20.000 mA). Press...
    Page 3 General instructions Turn-onEach time you turn on the Model 434-KP the LCD will display all segments for about 1 second. It then displays the most recently selected scaling for the function selected by the selector knob. SOURCE - The three QUIK-CHEK outputs will be the same as previously stored. The same three QUIK-CHEKs are used for the SOURCE & 2 WIRE SIM functions. READ - The 434-KP is ready to measure milliamps or DC Volts and is automatically updating the MAX & MIN readings for recall at any time....
    Page 4 mA, mA % (Percent of 4 to 20 mA)Choose this function to provide an output from 0.000 to 24.000 mA. The compliance voltage is a nominal 24 VDC to provide the driving power to your milliamp receivers or to drive a whole loop. 1) Disconnect one or both input wires from the device to be calibrated. 2) Press the POWER push-button to turn the Model 434-KP on and turn the selector knob to SOURCE MILLIAMPS. 3) Connect the red SOURCE lead of the calibrator to the plus (+) input of the device and the black SOURCE...
    Start reading Altek 434KP Process Loop Calibrator Manual

    Related Manuals for Altek 434KP Process Loop Calibrator Manual

    All Altek manuals