Anetsberger Brothers 14Inch Gas Fryer MX14EX 14 high production User Manual CEUK

L20-351- UK Rev. 1 0 8/1 2 
 
 
  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
IMPORTANT FOR FUTURE REFERENCE  
Please complete this information and retain this manual for the life of the equipment: 
Model #:  __________________________   
Serial #:   __________________________   
Da te Purchased:   ___________________   
 
Installation and Operation Manual  
Covering
 
MX14 and 14GS Series
 
 
ENGLISH
  

L20-351- UK Rev. 1 0 8/1 2 
 
THIS MANUAL MUST BE RETAINED FOR FUTURE REFERENCE
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
FOR YOUR SAFETY 
DO NOT store or use gasoline or other 
flammable vapors or liquids in the 
vicinity of this or any other appliance. 
WARNING 
Improper installation, alteration, service 
or maintenance can cause property 
damage, injury  or death. Read the 
installation, operating and maintenance 
instructions thoroughly before 
installing or...

L20-351- UK Rev. 1 0 8/1 2 
 
Table of Contents  
 
 
 
Section            Page 
 
Installation  
 Checking your new Anets Appliance . . . . . . . .  . . . . . . . . . . . . . . . . . . . . . . . .   1 
 Assembly and Leveling  
   Leg and Caster Adjustment . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .  1 
   Gastechnical Information and Specifications . . . . . . . . . . . . . . . . . . . .  2 
   Installation Clearances . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . ....

INSTALLATION 
L20-351- UK Rev. 1 0 8/1 2  1    
     
CHECKING YOUR NEW ANETS APPLIANCE 
 
Your new Anets appliance has been carefully packed into one crate. Every effort has been made to ensure that  
it is delivered to you in perfect condition. As you unpack your new appliance, inspect each of the pieces for 
damage. If something is damaged, DO NOT sign the bill of lading. Contact the shipper immediately; the shipper 
is only responsible for 15 days after delivery. Check the packing list enclosed with...

INSTALLATION 
  2            L20-351- UK Rev. 1 0 8/1 2
     
 
INSTALLATION 
If you have completed the above steps that are applicable to the appliance you purchased, the appliance is now 
ready to be installed. Although it may be possible for you to install and set up your new appliance, it is 
STRONGLY recommended that you have this done by qualified professionals. A qualified professional will 
ensure that the installation is safe and meets local building and fire codes.   
 
Gastechnical Information...

INSTALLATION 
L20-351- UK Rev. 1 0 8/1 2  3        
 
a.  Fill the tank with water. Turn the appliance on  and set the thermostat to 200°F (93°C) Refer to 
the APPLIANCE START UP section of this manual for instructions.  
 
b.   Allow the appliance to heat for 15 minutes. Add Anets cleaner to the water, stirring with the 
cleaning brush to ensure that the cleaner dissolv es thoroughly. 
 
CAUTION 
DO NOT leave the appliance unattended during cleaning. Never let the water level go below the  “Oil Level”...

OPERATION 
  4            L20-351- UK Rev. 1 0 8/1 2
    
 
c.  Once the appliance tank is firmly packed with shortening/oil, the shortening/oil must be melted. 
Melt the shortening/oil  by cycling the burners on for 4 seconds and off for 30 seconds repeatedly, 
using the thermostat knob.   
 
OPERATING INSTRUCTIONS 
To ensure the quality of the food you cook in this appliance, follow the preparation instructions from the food 
manufacturer. Usi ng the best shortening/oil makes the best fried foods. The...

CLEANING AND MAINTENANCE 
L20-351- UK Rev. 1 0 8/1 2  5      
 
DAILY CLEANING 
Your appl iance should be cleaned every day to maintain peak performance, proper sanitation and appearance. 
Perform the following procedures daily.  
 
a.   Wipe up any shortening/oil that spills onto the exterior of the appliance. This should be done with 
a clean soft clot h while the shortening/oil is still warm. DO NOT 
spray or pressure wash the 
appliance!  
 
b.  Use warm water with a mild detergent to clean surfaces....

CLEANING AND MAINTENANCE 
  6            L20-351- UK Rev. 1 0 8/1 2
    
 
Thermostat Calibration Check  
NOTICE 
Thermostat calibration requires that the temperature of the appliance be  raised above 
boiling. If you have water in the tank you will need to drain it, dry it and fill it with  shortening/oil. Follow the filling instructions in this manual.   
 
To check the calibration of your appliance, refer to the following procedure.  
 
a.  Remove  the basket screen from the tank.  
 
b.  Place the...

TROUBLESHOOTING AND CONVERSION 
L20-351- UK Rev. 1 0 8/1 2  7    
 
TROUBLESHOOTING
 
 
Should there be a problem with your appliance, use the following tables to help diagnose possible faults before 
calling your Authorized Service Agent.  
 
 
Check these items before calling your Authorized Service Company. 
ITEM TO CHECK HOW TO CHECK 
Gas Supply  Ensure that gas is supplied to the appliance.  
Gas Supply Pressure  Ensure that gas supply pressure is adequate.  
Hi-Limit reset   Press hi-limit reset...