Anetsberger Brothers 14Inch Gas Fryer SLG40 14 SilverLine User Manual CEUK

							TROUBLESHOOTING AND CONVERSION 
  8                                              L20 -352- UK Rev. 1 0 8/1 2 
 
f.  Reinstall the burners array into the appliance.  
 
g.   Reinstall the modified pilot assembly into the appliance.  
 
h.   Apply the gas type conversion label, provided with the conversion kit, just below the data plate 
(located on the inside of the appliance door).  
 
i.   Ensure that all steps of this procedure have been executed properly and that ALL gas 
connections are connected and retightened.  
 
j.   Connect a manometer to the pressure test point on the burner manifold.  
 
k.   Turn the gas supply to the appliance on and start the appliance using the Appliance Start U p 
procedure in this manual.  
 
l.   Using leak detector fluid, check ALL gas connections and orifice tips for leakage. If gas leakage 
is detected shut the appliance down using the Appliance Shut Down procedure in this manual, 
turn off the gas supply to the appliance and repair the leak. When the leak has been repaired 
repeat step ‘k’ in this procedure and continue through the procedure.  
 
m.   With the main burners on, ensure that the burner pressure is correct for the gas type to which 
you have converted the appliance.  Adjust the burner pressure, if necessary, by removing the cap 
screw on the gas valve regulator and turning the adjustment screw clockwise to increase burner 
pressure, counter -clockwise to decrease burner pressure. Replace regulator cap screw when 
finished.  
 
 
Gas Conversion Information and Specifications  
 
Model 
Fuel Type  
Gas  
Appliance   Category  
Burner  
Pressure  (mbar) 
Burner Orifice  
Pilot Orifice  Code 
Governor  
SLG40 
NAT G20 I2H 8.7 #31 N22 Yes 
NAT G25 I2L 8.7 3.4 mm N22 Yes 
LP G31 I3P 25.4 1.9 mm LP16 Yes 
SLG100  
NAT G20 I2H 8.7 #34 N22 Yes 
NAT G25 I2L 10.0 #31 N22 Yes 
LP G31 I3P 25.4 #51 LP16 Yes 
 
 
 
 
 
 
 
  
						

							 
 
MAILING ADDRESS – P.O. BOX 501, CONCORD, NH 03302-0501 USA 
SHIPPING ADDRESS – 10 FERRY ST., CONCORD, NH 03301 USA 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 In the event of problems with or questions about 
your equipment, please contact the Anets 
Authorized Service and Parts representative 
(ASAP) covering your area, or contact Anets at the 
number listed to the left.  
 
 
 
In the event of problems with or questions about 
your order, please contact the Anets  factory at:  
1 -603 -225 -6684