Apple eMac User Manual
Have a look at the manual Apple eMac User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 195 Apple manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
18 eMac Take Apart Fan 3. To locate the last fan screw, turn the computer so the anode socket is facing you. You’ll see two screws. Remove the top screw. 4. To remove the fan, turn the computer so the fan is facing you. Grab onto the fan near the AC plug and the bottom right corner of the fan. Gently pull the fan toward you and away from the chassis. Be very careful of the CRT neck.
eMac Take Apart - 19 Faraday Cage Faraday Cage Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps • Place the computer face down on an ESD mat. • Remove the user access door. • Remove the feet. • Remove the rear housing. • Discharge the CRT. • Remove the fan.
20 eMac Take Apart Faraday Cage Procedure 1. Remove the five screws. Important: Push the power button cable inside the Faraday cage so it doesn’t get caught when you remove the Faraday cage. 2. Gently pry the Faraday cage away from the chassis in the direction of the arrows.
eMac Take Apart - 21 Digital Module Assembly Digital Module Assembly Tools This procedure requires the following tools: • Phillips #2 Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat. • Remove the user access door. • Remove the feet. • Remove the rear housing. • Discharge the CRT.
22 eMac Take Apart Digital Module Assembly • Remove the fan. • Remove the Faraday cage. • Remove the AirPort Card if installed.
eMac Take Apart - 23 Digital Module Assembly Procedure 1. With the digital module facing you, remove the four screws on the left side of the digital module. 2. Next, remove the three screws on the right side.
24 eMac Take Apart Digital Module Assembly 3. On the top right side of the digital module, remove one screw. 4. On the top left side of the digital module, remove one screw.
eMac Take Apart - 25 Digital Module Assembly5. Remove one screw on the I/O panel and disconnect the video cable located above the screw. Squeeze the tabs to disconnect the video cable. 6. Note: Remove the AirPort card if it’s installed. Grab onto the digital module at the tabs circled below. Pull in the direction of arrow. The digital module is connected to blind- mate connectors. It’s a tight fit, so pull hard.
26 eMac Take Apart IVAD Cable IVAD Cable Important: Take Apart Note: Replace the IVAD cable if the eMac raster shifts upward from the bottom of the display or the raster is jumpy, otherwise leave the cable alone. Refer to Knowledge Base article 95168 for more information. Tools This procedure requires the following tools: • 2.5 mm hex tool • Phillips #2 screwdriver • Hot-melt glue gun (recommended) • Nylon probe tool (922-5065) Part Location Preliminary Steps Before you begin, do the following: • Place the computer face down on an ESD mat. • Remove the user access door.
eMac Take Apart - 27 IVAD Cable• Remove the feet. • Remove the rear housing. • Discharge the CRT. • Remove the fan. • Remove the Faraday cage. • Remove the AirPort Card if installed. • Remove the digital module assembly.