ASUS Transformer Book Flip TP550LA User Manual

							101
This information was copied from CETECOM and is supplied without liability. For updates to this table, you may visit http://www.cetecom.de/technologies/ctr_21.html
1 National requirements will apply only if the equipment may use pulse dialling (manufacturers may state in the user guide that the equipment is only intended to support DTMF signalling, which would make any additional testing superfluous).
In The Netherlands additional testing is required for series connection and caller ID facilities.
Federal Communications Commission 
Interference Statement
This device complies with FCC Rules Part 15. Operation is subject to the following two conditions:
•	 This	device	may	not	cause	harmful	interference.
•	 This	device	must	accept	any	interference	received,	including	interference	that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a\н class B digital device, pursuant to Part 15 of the Federal Communications Comm\нission (FCC) rules. These limits are designed to provide reasonable protectio\нn against harmful interference in a residential installation. This equipment gener\нates, uses, and can radiate radio frequency energy and, if not installed and used in\н accordance with the instructions, may cause harmful interference to radio communica\нtions. However, there is no guarantee that interference will not occur in a par\нticular installation. If this equipment does cause harmful interference to radio\н or television reception, which can be determined by turning the equipment off and on\н, the user is encouraged to try to correct the interference by one or more of the f\нollowing measures:
•	 Reorient	or	relocate	the	receiving	antenna.
•	 Increase	the	separation	between	the	equipment	and	receiver.
Notebook PC E-Manual   
						

							102
•	 Connect	the	equipment	into	an	outlet	on	a	circuit	different	from	that	to	which the receiver is connected. 
•	 Consult	the	dealer	or	an	experienced	radio/TV	technician	for	help.
WARNING! The use of a shielded-type power cord is required in order to meet FCC emission limits and to prevent interference to the nearby radio and television reception.  It is essential that only the supplied power cord be used. Use only shielded cables to connect I/O devices to this equipment. You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment.
(Reprinted from the Code of Federal Regulations #47, part 15.193, 1993. Washington DC: Office of the Federal Register, National Archives and Records Administration, U.S. Government Printing Office.)
FCC Radio Frequency (RF) Exposure Caution 
Statement
WARNING! Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. “The manufacture declares that this device is limited to Channels 1 through 11 in the 2.4GHz frequency by specified firmware controlled in the USA.”
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment must be installed and operated in accordance with provided instructions and must not be co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure compliance. 
Notebook PC E-Manual  
						

							103
Declaration of Conformity (R&TTE directive 
1999/5/EC)
The following items were completed and are considered relevant and sufficient:
•	 Essential	requirements	as	in	[Article	3]
•	 Protection	requirements	for	health	and	safety	as	in	[Article	3.1a]
•	 Testing	for	electric	safety	according	to	[EN	60950]
•	 Protection	requirements	for	electromagnetic	compatibility	in	[Article	3.1b]
•	 Testing	for	electromagnetic	compatibility	in	[EN	301	489-1]	&	[EN	301	489-17]
•	 Effective	use	of	the	radio	spectrum	as	in	[Article	3.2]
•	 Radio	test	suites	according	to	[EN	300	328-2]
CE Marking
CE marking for devices without wireless LAN/Bluetooth
The shipped version of this device complies with the requirements of the EEC directives 2004/108/EC “Electromagnetic compatibility” and 2006/95/EC “Low voltage directive”.
CE marking for devices with wireless LAN/ Bluetooth
This equipment complies with the requirements of Directive 1999/5/EC of the European Parliament and Commission from 9 March, 1999 governing Radio and Telecommunications Equipment and mutual recognition of conformity.
Notebook PC E-Manual   
						

							104
IC Radiation Exposure Statement for Canada
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. To maintain compliance with IC RF exposure compliance requirements, please avoid direct contact to the transmitting antenna during transmitting. End users must follow the specific operating instructions for satisfying RF exposure compliance.
Operation is subject to the following two conditions: 
•	 This	device	may	not	cause	interference	and	
•	 This	device	must	accept	any	interference,	including	interference	that		may	cause undesired operation of the device.
To prevent radio interference to the licensed service (i.e. co-channel Mobile Satellite systems) this device is intended to be operated indoors and away from windows to provide maximum shielding. Equipment (or its transmit antenna) that is installed outdoors is subject to licensing. 
This device complies with Industry Canada licence-exempt RSS standard(s).
CAN ICES-3(B)/NMB-3(B)
Canada, Industry Canada (IC) Notices 
This Class B digital apparatus complies with Canadian ICES-003 and RSS-210. 
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Radio Frequency (RF) Exposure Information 
The radiated output power of the Wireless Device is below the Industry Canada (IC) radio frequency exposure limits(1.6W/Kg). The Wireless Device should be used in such a manner such that the potential for human contact during normal operation is minimized. 
This device has been evaluated for and shown compliant with the IC Specific Absorption Rate (“SAR”) limits(1.6W/Kg) when operated in portable exposure conditions.
Notebook PC E-Manual  
						

							105
Déclaration d’Industrie Canada relative à l’
exposition aux ondes radio 
Cet appareil est conforme aux limites d’exposition aux radiations d’Industrie Canada définies pour un environnement non-contrôlé. Pour maintenir la conformité avec les exigences d’exposition RF d’IC, veuillez éviter tout contact direct avec l’antenne pendant l’émission. Les utilisateurs finaux doivent suivre les instructions de fonctionnement spécifiques pour satisfaire la conformité aux expositions RF. 
Son utilisation est sujette aux deux conditions suivantes : 
•		 Cet	appareil	ne	peut	pas	causer	d’interférence,	et	
•		 Cet	appareil	doit	accepter	toute	interférence,	y	compris	les	interférences	qui pourraient causer un fonctionnement non souhaité de l’appareil. 
Pour éviter les interférences radio avec le service sous licence (c’est à-dire le partage de canal avec les systèmes de téléphonie satellite), cet appareil est destiné à être utilisé en intérieur et loin des fenêtres pour fournir un blindage maximal. Tout appareil (ou son antenne d’émission) qui est installé en extérieur est sujet à cette licence.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. 
CAN ICES-3(B)/NMB-3(B)
Notebook PC E-Manual   
						

							106
Canada, avis d'Industry Canada (IC) 
Cet appareil numérique de classe B est conforme aux normes canadiennes ICES-003 et RSS-210. 
Son fonctionnement est soumis aux deux conditions suivantes : (1) cet appareil ne doit pas causer d'interférence et (2) cet appareil doit accepter toute interférence, notamment les interférences qui peuvent affecter son fonctionnement.
Informations concernant l'exposition aux 
fréquences radio (RF)
La puissance de sortie émise par l’appareil de sans fil est inférieure à la limite(1.6W/Kg) d'exposition aux fréquences radio d'Industry Canada (IC). Utilisez l’appareil de sans fil de façon à minimiser les contacts humains lors du fonctionnement normal.
Ce dispositif a été évalué pour et démontré conforme à la Taux IC d'absorption spécifique ("SAR") des limites(1.6W/Kg) lorsqu'il est utilisé dans des conditions d'exposition portatifs.
Notebook PC E-Manual  
						

							107
France Restricted Wireless Frequency Bands
Some areas of France have a restricted frequency band. The worst case maximum authorized power indoors are: 
•	 10mW	for	the	entire	2.4	GHz	band	(2400	MHz–2483.5	MHz)	
•	 100mW	for	frequencies	between	2446.5	MHz	and	2483.5	MHz
NOTE: Channels 10 through 13 inclusive operate in the band 2446.6 MHz to 2483.5 MHz.
There are few possibilities for outdoor use: on private property or on the private property of public persons, use is subject to a preliminary authorization procedure by the Ministry of Defense, with maximum authorized power of 100mW in the 2446.5–2483.5	MHz	band.	Use	outdoors	on	public	property	is	not	permitted.	
In the departments listed below, for the entire 2.4 GHz band: 
•	 Maximum	authorized	power	indoors	is	100mW	
•	 Maximum	authorized	power	outdoors	is	10mW	
Wireless Operation Channel for Different 
Domains
N. America2.412-2.462 GHz Ch01 through CH11
Japan 2.412-2.484 GHz Ch01 through Ch14
Europe ETSI 2.412-2.472 GHz Ch01 through Ch13
Notebook PC E-Manual   
						

							108
Departments	in	which	the	use	of	the	2400–2483.5	MHz	band	is	permitted	with	an	EIRP of less than 100mW indoors and less than 10mW outdoors:
01  Ain02  Aisne03  Allier
05  Hautes Alpes08  Ardennes09  Ariège
11  Aude12  Aveyron16  Charente
24  Dordogne25  Doubs26  Drôme
32  Gers36  Indre37  Indre et Loire
41  Loir et Cher45  Loiret50  Manche
55  Meuse58  Nièvre59  Nord
60  Oise61  Orne63  Puy du Dôme
64  Pyrénées Atlantique66  Pyrénées Orientales67  Bas Rhin
68  Haut Rhin70  Haute Saône71  Saône et Loire
75  Paris82  Tarn et Garonne84  Vaucluse
88  Vosges89  Yonne90  Territoire de Belfort
94  Val de Marne
This requirement is likely to change over time, allowing you to use your wireless LAN card in more areas within France. Please check with ART for the latest information (www.arcep.fr) 
NOTE: Your WLAN Card transmits less than 100mW, but more than 10mW.
Notebook PC E-Manual  
						

							109
UL Safety Notices
Required for UL 1459 covering telecommunications (telephone) equipment intended to be electrically connected to a telecommunication network that has an operating voltage to ground that does not exceed 200V peak, 300V peak-to-peak, and 105V rms, and installed or used in accordance with the National Electrical Code (NFPA 70).
When using the Notebook PC modem, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons, including the following:
•	 DO	NOT	use	the	Notebook	PC	near	water,	for	example,	near	a	bath	tub,	wash bowl, kitchen sink or laundry tub, in a wet basement or near a swimming pool. 
•	 DO	NOT	use	the	Notebook	PC	during	an	electrical	storm.	There	may	be	a	remote risk of electric shock from lightning.
•	 DO	NOT	use	the	Notebook	PC	in	the	vicinity	of	a	gas	leak.
Required for UL 1642 covering primary (nonrechargeable) and secondary (rechargeable) lithium batteries for use as power sources in products. These batteries contain metallic lithium, or a lithium alloy, or a lithium ion, and may consist of a single electrochemical cell or two or more cells connected in series, parallel, or both, that convert chemical energy into electrical energy by an irreversible or reversible chemical reaction. 
•	 Do	not	dispose	the	Notebook	PC	battery	pack	in	a	fire,	as	they	may	explode. Check with local codes for possible special disposal instructions to reduce the risk of injury to persons due to fire or explosion.
•	 Do	not	use	power	adapters	or	batteries	from	other	devices	to	reduce	the	risk of injury to persons due to fire or explosion. Use only UL certified power adapters or batteries supplied by the manufacturer or authorized retailers.
Notebook PC E-Manual   
						

							110
Power Safety Requirement
Products with electrical current ratings up to 6A and weighing more than 3Kg must use approved power cords greater than or equal to: H05VV-F, 3G, 0.75mm2 or H05VV-F, 2G, 0.75mm2.
TV Notices
Note to CATV System Installer—Cable distribution system should be grounded (earthed) in accordance with ANSI/NFPA 70, the National Electrical Code (NEC), in particular Section 820.93, Grounding of Outer Conductive Shield of a Coaxial Cable	–	installation	should	include	bonding	the	screen	of	the	coaxial	cable	to	the	earth at the building entrance.
REACH
Complying with the REACH (Registration, Evaluation, Authorization, and Restriction of Chemicals) regulatory framework, we publish the chemical substances in our products at ASUS REACH website at http://csr.asus.com/english/REACH.htm. 
Macrovision Corporation Product Notice
This product incorporates copyright protection technology that is protected by method claims of certain U.S.A. patents and other intellectual property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.
Prevention of Hearing Loss
 To prevent possible hearing damage, do not listen at high volume levels for long periods.
Notebook PC E-Manual