Home > Avaya > Communications System > Avaya Partner Pc Card Installation Instructions

Avaya Partner Pc Card Installation Instructions

Add to Favourites
    Download as PDF

    View the Avaya Partner Pc Card Installation Instructions for free. All the Avaya manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Copyright 2002 Avaya Inc. All rights reserved Printed in U.S.A.Document Number 518-457-101 Comcode: 700191323 March 2002 (Issue 5) PARTNER is a registered trademark of Avaya Inc. PARTNER PC CARD Installation Instructions This PC Card is used with a PARTNER® Advanced Communications System (ACS). These instructions are designed for any one of the following types of PC Cards: Backup/Restore Card Software Upgrade Card (for one-time upgrade only) Automatic System Answer/Direct Extension Dialing...
    Page 2 1 Power down the system before inserting or removing a PC Card. A) If you have a Stand-alone or 2-Slot Carrier, disconnect the power cord from the power jack on the carrier and unplug the power cord from the wall outlet. B) If you have a 5-Slot Carrier, move the carrier’s On/Off switch to Off (“O”) and unplug the power cord from the wall outlet. 2 If you do not have a 5-slot carrier or have a system of Release 4.0 or later, go to Step 3. If you have a 5-slot carrier and a system of Release 3.0 or...
    Page 3 4 To insert the PC Card, hold it with the label facing to the right, and slide it gently into one of the PC Card slots on the processor module. When inserted properly, the PC Card projects about 1-5/8” (4 cm) from the module. 5 Power up the system: A) Reconnect the power cord. CAUTION: The power cord should hang straight down from the connector, flush against the plastic case for the entire length of the board. Do not install the power cord at an angle to the case or with a loop in it. B) If you...
    Page 4 8 If you have a 2-Slot Carrier or a stand-alone configuration, you are finished with this procedure. If you have a 5-Slot Carrier, continue with Step 8A. A) Make sure all modules are seated properly. If you have a system of Release 3.0 or earlier: B) To replace the carrier’s cover, grasp it by its upper edges and hold it squarely over the control unit. C) Place the cover over the modules and make sure it fits firmly in place. D) Tighten the screw on the lower front of the cover. 9 If the PC Card you...
    Start reading Avaya Partner Pc Card Installation Instructions

    Related Manuals for Avaya Partner Pc Card Installation Instructions

    All Avaya manuals