Beko Dis 1520 N Manual

							18
1018
45cm_EU2_altsepet_CKS
Silverware basket
(depends on the model)
Silverware basket is designed to wash 
your dishes such as fork, spoon and 
etc. in a cleaner manner. 
Collapsable lower basket 
wires 
(depends on the model)
The two piece foldable wires located 
at the lower basket of the machine are 
designed for an easier placement of 
large pieces such as pans, bowls, etc. 
(1, 2). 



You can create larger spaces by 
folding each wire individually or all of 
them at once. Lay the foldable wires 
down by pressing on the latch (A). 
EN  
						

							19
8000_altsepet_45cm_2&4_
fulyatar_Gurindig_mkz_2013.ai
3
34
4
C
C
B
B
Collapsable lower basket 
wires (2 & 4 pieces)
(depends on the model)
The foldable wires (A) located at 
the lower basket of the machine are 
designed for an easier placement of 
large pieces such as pans, bowls, 
etc. You can create larger spaces by 
folding each wire individually or all 
them at once.
To bring the collapsible wires into 
horizontal position, grab the wire from 
mid position and push them in the 
directions of arrows (B) To bring the 
wires back to vertical position,  just lift 
them up. Collapsible wires will click into 
the latch again
 Bringing the wires to the horizontal 
position byholding them from the tips 
may cause them to bend. Therefore, 
it will be appropriate to bring the wires 
in the middle to horizontal or vertical 
position by holding them from their 
stems and pishing in the direction of 
arrow. 
EN                                                                                                                                                                                                                                                                                            
						

							20
1022 eps
Adjusting the height of empty 
upper basket
(depends on the model)
You can adjust the height of the upper 
basket according to the size of the dish 
to be washed. Use basket rollers to 
change the basket height. 
1. Turn the stoppers on the ends of 
the upper basket rails by turning 
them aside (A). 
2. Take the basket out (B). 
3. Change the position of the rollers, 
place the basket into the rail and 
close the stoppers (C).


 
EN  
						

							21
1065 eps




Adjusting the height of loaded 
upper basket
(depends on the model)
Basket adjustment mechanism on 
the upper basket of the machine is 
designed to allow you create wider 
areas in the upper or lover section 
of the machine based on your 
requirements by adjusting the height 
of the loaded basket in up or down 
directions without removing it from the 
machine. 
To raise the basket:
1. Grab one of the upper basket wires 
(right or left) and lift it up (A).
2. Repeat the same process to raise 
the other side of the basket.
3. Make sure that both sides of 
the basket height adjustment 
mechanism are at the same level 
(down or up).
To lower the basket:
1. Press the latch on the basket 
adjustment mechanism (right or 
left) to lower the basket (B).
2. Repeat the same process to lower 
the other side of the basket. 
3. Make sure that both sides of 
the basket height adjustment 
mechanism are at the same level 
(down or up). 
EN  
						

							22
1. Turn the micro filter (3) and 
coarse filter (2) assembly counter 
clockwise and pull it out from its 
seating (A).
5Maintenance and cleaning
Service life of the product extends and 
frequently faced problems decrease if it 
is cleaned at regular intervals. 
A Unplug the product and turn off the 
tap before attempting any cleaning 
procedures.
C  Do not use abrasive substances for 
cleaning.
C Clean the filters and impellers at 
least once a week.
Cleaning the outer surface of 
the product
Clean the outer surface and door 
gaskets of the product gently with a mild 
cleaning material and damp cloth. Wipe 
the control panel only with a damp cloth.
Cleaning the interior of the 
machine
—  Clean the interior of the machine 
and the tank by running a prewash 
programme without detergent or 
a long washing programme with 
detergent based on the degree of 
soiling.
— If water has remained in the 
machine, drain the water by 
performing the procedures under 
the topic "Canceling a programme". 
If the water cannot be discharged, 
clean any leftover deposits that 
have piled up in the bottom of the 
machine, blocking the water path. 
Cleaning the filters
Clean the filters at least once a week 
in order for the machine operates 
efficiently. Check if food residues are left 
on the filters. If there are food residues 
on filters, take them out and clean well 
under running water.
1031


















2.  Pull out the metal / plastic filter (1) 
(B). 
EN  
						

							23






4.  Clean all three filters under tap 
water by means of a brush.
5. Replace the metal/plastic filter.
6. Place the coarse filter into the 
microfilter. Make sure that it is 
properly seated. Turn the coarse 
filter clockwise until a “click” sound 
is heard. 
A Do not use the dishwasher without 
filter.
C  Incorrect placement of the filters 
will reduce washing efficiency.
Cleaning the hose filter
Damages on the machine that may be 
caused by impurities coming from the 
urban supply water or your own water 
installation (such as sand, dirt, rust, 
etc.) can be prevented by means of the 
filter attached to the water inlet hose. 
Check the filter and the hose regularly 
and clean them if necessary.
1.  Turn off the tap and remove the 
hose.
2. After taking out the filter, clean it 
under running tap water.
3. Place the cleaned filter back to its 
seat in the hose.
4. Install the hose to tap.












3. Press the two pawls on the coarse 
filter inwards and separate the 
coarse filter from the assembly (C).
Cleaning the impellers
Clean the impellers at least once a 
week in order for the machine operates 
efficiently. 
Lower impeller
Check if the holes on the lower impeller 
(1) are clogged. If they are clogged, 
remove and clean the impeller. Pull the 
lower impeller up to remove it (A, B). 
EN  
						

							24
1032
Upper impeller
Check if the holes on the upper 
impeller (2) are clogged. If they 
are clogged, remove and clean the 
impeller. Turn its nut to left to remove 
the upper impeller (C, D).
Make sure that the nut is tightened well 
when installing the upper impeller. 





 
EN  
						

							25
Troubleshooting
Machine does not start.
• Power cable is unplugged. >>> Check if the power cable is plugged in.
• Fuse is blown. >>> Check the fuses in your house.
• Water is cut. >>> Make sure that the water inlet tap is open.
• Door of the machine is open. >>> Make sure that you have closed the door 
of the machine.
• On / Off button is not pressed. >>> Make sure that you have turned on the 
machine by pressing the On / Off button.
Dishes are not washed clean
• Dishes are not placed orderly in the machine. >>> Load the dishes as 
described in the user manual.
• Selected programme is unsuitable. >>> Select a programme with a higher 
temperature and cycle time.
• Impellers are stuck. >>> Prior to starting the programme, turn the lower and 
upper impellers by hand to make sure that they rotate freely.
• Impeller holes are clogged. >>> Lower and upper impeller holes might 
be clogged with food remnants such as lemon pips. Clean the impellers 
regularly as illustrated in section "Cleaning and Care".
• Filters are clogged. >>> Check if the filter system is clean. Clean the filter 
system regularly as illustrated in section "Cleaning and Care".
• Filters are installed incorrectly. >>> Check the filter system and make sure 
that it is installed correctly.
• Baskets are overloaded.  >>> Do not overload the baskets in excess of their 
capacity.
• Detergent is stored under unsuitable conditions. >>> If you are using powder 
detergent, do not store the detergent package in humid places. Keep it i\
n a 
closed container if possible. For ease-of-storing, we recommend you to u\
se 
tablet detergents.
• Detergent is not sufficient. >>> If you are using powder detergent, adjust 
the amount of detergent according to the soiling degree of your dishes a\
nd/
or programme definitions. We recommend you to use tablet detergents for 
optimum results.
• Rinse aid is not sufficient.  >>> Check the rinse aid indicator and add rinse 
aid if necessary. Increase the rinse aid setting if there is enough amount of 
rinse aid in the machine.
• Detergent dispenser lid is left open. >>> Make sure that the detergent 
dispenser lid is closed tightly after adding detergent.
6 
EN  
						

							26
Dishes are not dry at the end of cycle
• Dishes are not placed orderly in the machine. >>> Place your dishes in a 
way that no water will accumulate in them.
• Rinse aid is not sufficient.  >>> Check the rinse aid indicator and add rinse 
aid if necessary. Increase the rinse aid setting if there is enough amount of 
rinse aid in the machine.
• Machine is unloaded right after the programme is over. >>> Do not unload 
your machine right after washing process is completed. Slightly open the\
 
door and wait for evacuation of the steam inside for a while. Unload the\
 
dishes after the pieces cool down to a touchable level. Start unloading \
process from the lower basket. Thus, dropping of water remained on a pie\
ce 
at upper basket onto the pieces at lower basket is prevented.
• Selected programme is unsuitable. >>> Since rinsing temperature is low at 
programmes with short duration, drying performance will also be low. Select 
programmes with longer duration for a higher drying performance.
• Surface quality of the kitchen utensils is deteriorated. >>>  Desired washing 
performance can not be obtained at kitchen utensils with deteriorated 
surfaces and it is not suitable to use such utensils in terms of hygiene\
 
as well. Also, water can not flow easily on deteriorated surfaces. It is not 
recommended to wash such kitchen utensils in dishwasher.
C It is normal that drying complaints can be experienced with Teflon kitchen 
utensils. It is associated with the structure of Teflon. Since the surface 
tensions of Teflon and water are different, water droplets will remain as 
beads on the Teflon surface.
Tea, cafe or lipstick stains remain on dishes.
•  Selected programme is unsuitable. >>> Select a programme with a higher 
temperature and cycle time.
• Surface quality of the kitchen utensils is deteriorated. >>>  Tea and cafe 
stains or other dye spots may not be cleaned in dishwasher when they 
have penetrated in deteriorated surfaces. Desired washing performance 
can not be obtained at kitchen utensils with deteriorated surfaces and i\
t 
is not suitable to use such utensils in terms of hygiene as well. It is \
not 
recommended to wash such kitchen utensils in dishwasher.
• Detergent is stored under unsuitable conditions. >>> If you are using powder 
detergent, do not store the detergent package in humid places. Keep it i\
n a 
closed container if possible. For ease-of-storing, we recommend you to u\
se 
tablet detergents. 
EN  
						

							27
Lime traces remain on dishes and glassware gains a misty appearance
• Rinse aid is not sufficient. >>> Check the rinse aid indicator and add rinse 
aid if necessary. Increase the rinse aid setting if there is enough amount of 
rinse aid in the machine.
• Water hardness setting is low or salt level is insufficient >>> Measure the 
hardness of the supply water appropriately and check the water hardness \
setting.
• Salt leakage exists. >>> Pay attention not to spill salt around the salt filling 
hole while adding salt. Make sure that the salt reservoir lid is tightly\
 closed 
after finishing the filling process. Run the prewash programme to remove\
 the 
salt that spilled inside the machine. Since the salt granules that will \
remain 
under the lid will dissolve during prewash, causing the lid loosen, chec\
k the 
lid once again at the end of the programme. 
There is a different odour in the machine
C A new machine has a peculiar odour. It will fade out after a couple of 
washing.
•  Filters are clogged. >>> Check if the filter system is clean. Clean the filter 
system regularly as illustrated in section "Cleaning and Care".
• Dirty dishes are kept in dishwasher for 2-3 days. >>> If you are not going 
to start the machine right after you have put the dishes into it, remove\
 
the remnants on the dishes and run the Prewash programme without 
detergent every 2 days. In such cases, do not close the door of the mach\
ine 
completely in order to avoid odour build up in machine. You can also use 
commercially available odour removers or machine cleaners. 
EN