Beko Dv 7220 X Manual

11EN
Preparing the machine1. Plug in your machine. 2. Place the laundry in the machine. 3. Press the “On/Off” button.C Pressing the “On/Off” button does not necessarily mean that the programme has started. Press "Start/Pause/Cancel" button of the machine to start the programme.Programme selectionDecide the appropriate programme from the table below which includes drying temperatures in degrees. Select the desired programme with the programme selection button.
Extra dry 
Dry at high temperature...

12EN
Program selection and consumption table
* : Energy Label standard program (AS/NZS 2442)All values given in the table have been fixed according to standard laboratory conditions. These values may deviate from the table according to the laundry type, laundry spin speed, environmental conditions and voltage fluctuations.
EN2
ProgramsCapacity (kg)Spin speed in washing machine (rpm)
Approximate amount of remaining humidity
Drying time (minutes)
Cottons / Coloreds
A Ready to Wear
71200-1000% 60135...

13EN
Auxiliary functionCancel audio warningYour dryer will give an audio warning when the programme comes to an end. If you do not want to hear the audio warning, press “Cancel Audio Warning” button. The relevant light will turn on when this button is pressed and an audio warning will not be given when the programme comes to an end.CYou can select this function either before or after the programme starts. Warning indicatorsCWarning indicators may differ according to the model of your dryer.Filter...

14EN
Child-proof lock of the machine should not be active in order to perform these two operations. If the child-proof lock is active, deactivate it before performing these operations.Adding/removing laundry in standby modeIn order to add or remove laundry after the programme starts:1. Press the “Start/Pause/Cancel” button to switch the dryer to “Pause” mode. Drying process will stop.2. Open the door at “Pause” position and close it again after adding or taking out laundry.3. Press “Start/Pause/Cancel”...

15EN
5    Maintenance and cleaning
Filter Car tridge / Door Inner SurfaceLint and fibres released from the laundry to the air during the drying cycle are collected in the “Filter Cartridge”. 
C Such fibre and lint are generally formed during wearing and washing.C Always clean the filter and the inner surfaces of the cover after each drying process.C You can clean the filter and filter area by vacuum cleaner.To clean the filter:1. Open the loading door.2. Remove the cover filter by pulling it up and open...

16EN
Drying process takes too much time
• The filter mesh may be clogged. Wash with water.
Laundry come out wet at the end of drying.
• The filter mesh may be clogged. Wash with water.• Excessive laundry might have been loaded in. Do not overload the machine.
Machine does not switch on or the program does not start.  Machine is not activated when set.
• It might have not been plugged in. Make sure that the machine is plugged in.• The loading door may be ajar. Make sure that the loading door is properly...