Bisell BISSELL ProHeat 2X Revolution Carpet Cleaner 18588 User Manual

www.BISSELL.com11
Cleaning with the Bare Floor Tool
21
Turn off and unplug your machine. 
Attach the bare floor tool to the 
foot’s bottom by lining the tool 
to the edge of the nozzle. Rotate 
down until it clicks into place. 
Follow filling instructions on page 
8 using the Wash & Shine Hard 
Floor Cleaner formula and switch 
cleaning mode to Express Clean. When finished, 
unplug the machine 
and remove the 
bare floor tool by 
rotating the tool up 
to unhook from the 
nozzle. Rinse and let 
dry before...

www.BISSELL.com12
Empty Dirty Water Tank (continued)
Clean the red filter 
below the dirty 
tank by wiping off 
any remaining dirt 
or debris.
Quick Empty: 
 
Pull the rubber tab   
(located at the corner 
of the top of the tank) 
and tilt to pour. When 
closing the rubber tab, 
make sure all edges are 
sealed tight.
Final Rinse & Clean: 
Unscrew ring at bottom 
of tank by turning 
counterclockwise. 
Gently remove the float 
stack, rinse and clean. 
Once clean, return float 
stack into the tank by...

Maintenance: Cleaning the Nozzle
21
34
If pet hair or debris 
become clogged in 
the nozzle, it can 
be cleaned out of 
the nozzle with the 
nozzle clean out tool.
Turn off and unplug 
the machine from 
the earthed outlet.Remove the nozzle from the foot by 
flipping the accessory hose door open, 
then lifting the accessory hose door and 
nozzle up and away from the foot.
Return the nozzle back   
onto the foot of the   
machine by lining up the   
three hooks on the   
nozzle to the bottom of   
the...

Replace smaller 
toothed belt by 
wrapping around 
the small metal 
toothed pulley, 
and the gear at 
the end of the 
rear-most brush.
Return belt/brush 
access plate to the 
end of the brush rolls. 
It will “click” in place 
when screws align. 
Use a screwdriver to 
secure the plate with 
the three screws.
Replace and secure the 
brush roll cover, making 
sure brush rolls are 
aligned.
NOTE: It is important 
the brush rolls align on 
both ends of the foot.
Maintenance: Replacing Belts & Brush Roll
6
8...

ProblemPossible causes Remedies
Reduced 
spray OR  
no spray
Clean water tank may be emptyRefill tank
Clean water tank may not be   
seated completely Turn power OFF. Remove and 
 
reseat tank
Pump may have lost prime in 
hose cleaning mode Hold end of hose below water level 
in tank to prime
Loss of   
suction   
power Tanks may not be seated properly
Pick up both tanks and reseat them 
so they fit properly on the unit 
Dirty tank has picked up   
maximum amount of dirty water 
and has reached full line...

©2016 BISSELL Homecare, Inc.
Grand Rapids, Michigan  USA
All rights reserved. Printed in China
Part Number 160-8817  Rev 01/16 RevA
Visit our website at: www.BISSELL.com
Scotchgard is a trademark of 3M
16If your BISSELL product should 
require service or to claim under 
our Limited Six-Year Guarantee, 
please contact us as follows:
 
Website or Email: 
www.BISSELL.com
[email protected]
Call or write: 
Telephone: 0344-888-6644
BISSELL Homecare (Overseas) Inc.
Ground Floor
226 Berwick Avenue
Slough...