Home > Carrier > Thermostat > Carrier Tstatccbac01b Manual

Carrier Tstatccbac01b Manual

Add to Favourites
    Download as PDF

    View the Carrier Tstatccbac01b Manual for free. All the Carrier manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview Comments
    Page 1 Builders Non-Programmable Thermostat Installation, Start-Up, and Operating Instructions NOTE:Read the entire instruction manual before starting the installation. SAFETY CONSIDERATIONS Read and follow manufacturer instructions carefully. Follow all local electrical codes during installation. All wiring must conform to local and national electrical codes. Improper wiring or installa- tion may damage thermostat. Recognize safety information. This is the safety-alert symbol . When you see this symbol on the...
    Page 2 Step 2ÐInstall Thermostat Before installing thermostat, turn off all power to unit. There may be more than 1 disconnect. Electrical shock can cause personal injury or death. 1. Turn OFF all power to unit. 2. If an existing thermostat is being replaced: a. Remove existing thermostat from wall. b. Disconnect wires from existing thermostat, one at a time. Be careful not to allow wires to fall back into wall. c. As each wire is disconnected, record wire color and terminal marking. d. Discard or recycle old...
    Page 3 The numbers can range between -5 and +5. Factory default is 0. AVAILABLE SELECTION: Use UP and DOWN buttons to now move between -5 and +5 in steps of 1. Step 4ÐThermostat Operation TEMPERATURE DISPLAY Thermostat will display room temperature until UP or DOWN button is pressed. The word SET appears when these buttons are pressed and the current set point is displayed. If no buttons are pressed for 5 sec, the display will change back to show room temperature. TIMEGUARD TIMER A 5-minute timeguard is built...
    Page 4 *WIRING DIAGRAM NOTES 1. If power stealing method is used, leave C terminal disconnected between thermostat and equipment and add the supplied 270 ohm load resistor as shown. 2. Power stealing method may not be used with the Two-Zone system. In addition, the supplied 270 ohm load resistor MUST always be connected between Y1 and C at Two-Zone input as shown. Fig. 4ÐTypical Heat Pump A98217 HEAT STAGE 2 FA N 24 VAC HOT 24 VAC COMMW O G R C YW O G R C YW O R C Y HEAT PUMP THERMOSTATSINGLE-SPEED HEAT PUMP...
    Start reading Carrier Tstatccbac01b Manual

    Related Manuals for Carrier Tstatccbac01b Manual

    All Carrier manuals