Home > Carrier > Thermostat > Carrier Systxccuid01 B Manual

Carrier Systxccuid01 B Manual

Add to Favourites
    Download as PDF

    View the Carrier Systxccuid01 B Manual for free. All the Carrier manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 SYSTXCCUID01 Infinity Control™ Installation and Start-Up Instructions NOTE:Read the entire instruction manual before starting the installation. This symbol→indicates a change since the last issue. TABLE OF CONTENTS SAFETY CONSIDERATIONS .....................................................1 INTRODUCTION ..........................................................................1 INSTALLATION AND START-UP OVERVIEW ......................1 INSTALLATION...
    Page 2 INSTALLATION STEP 1—CHECK EQUIPMENT AND JOB SITE INSPECT EQUIPMENT—File claim with shipping company, prior to installation, if shipment is damaged or incomplete. STEP 2—INFINITY CONTROL™LOCATION AND WIRING CONSIDERATIONS ELECTRICAL SHOCK HAZARD Failure to follow this warning could result in personal injury or possible equipment damage. Disconnect Power before routing control wiring. All wiring must comply with national, local, and state codes. INFINITY CONTROL™LOCATION—The Infinity Control™ is the...
    Page 3 c. Discard or recycle old thermostat. NOTE:Mercury is a hazardous waste andMUSTbe disposed of properly. 3. Select Infinity Control™mounting plastic (recess mount or surface mount and decorative backplate if desired). 4. Route wires through large hole in mounting plastic. Level rear plastic against wall (for aesthetic value only - Infinity Con- trol™need not be level to operate properly) and mark wall through two mounting holes. 5. Drill two 3/16 inch mounting holes in wall where marked. 6. Secure...
    Page 4 ELECTRICAL OPERATION HAZARD Failure to follow this caution will result in equipment damage or improper operation. Improper wiring of the ABCD connector will cause the Infinity Control™to operate improperly. Check to make sure all wiring is correct before proceeding with installation or turning on power. 9. Push any excess wire into the wall. Seal hole in wall to prevent any air leaks. Leaks can affect operation. 10. Attach Infinity Control™to the mounting plastic by lining up the plastic guides on the...
    Start reading Carrier Systxccuid01 B Manual

    Related Manuals for Carrier Systxccuid01 B Manual

    All Carrier manuals