Home > Cobra > Radio > Cobra_18wxst Cb Tranciever_manual

Cobra_18wxst Cb Tranciever_manual

Add to Favourites
    Download as PDF

    View the Cobra_18wxst Cb Tranciever_manual for free. All the Cobra manuals and user’s guides are available for free view without any registration. You can also download the manual as PDF to your computer.

    Overview View all the pages Comments
    Page 1 InstallationLocationPlan the location of the transceiver and microphone bracket before starting the installation. Select a location that is conve- nient for operation and does not interfere with the driver or passengers in the vehicle. In automobiles, the transceiver is usually mounted to the underneath of the dash panel, with the microphone bracket beside it.Mounting and ConnectionsThe transceiver is held in the universal mounting bracket by two thumb screws, permitting adjustment at the most conve-...
    Page 2 Mobile whip antennas utilize the metal body of the vehicle as a ground plane. When mounted at a corner of the vehicle they are slightly directional, in the direction of the body of the vehi- cle. For all practical purposes, however, the radiation pattern is non-directional. The slight directional characteristic will be observed only at extreme distances. Astandard antenna con- nector (Type SO-239) is provided on the transceiver for easy connection to a standard PL-259 cable termination. Cobra load-...
    Page 3 Temporary Mobile OperationTo operate your COBRAtransceiver from a car on a tempo- rary basis, you may want to purchase an additional ciga- rette lighter adapter from your COBRAdealer. This adapter and a magnetic mount antenna allow you to quickly install your transceiver for temporary use.OperationControls and IndicatorsRefer to controls, indicators and connectors as illustrated below:A. Front Panel1.Microphone Connector. Allows for convenient removal of the microphone plug when storage is required. The...
    Page 4 B. Rear Panel1. Antenna Connector. This female connector permits connection of the transmission line cable male connec- tor to the transceiver. 2. External Speaker. The External Speaker Jack is used for remote receiver monitoring. The external speaker should have 8-ohm impedance and be rated to handle at least 4.0 watts. When the external speaker is plugged in, the internal speaker is automatically dis- connected. 3. Power:This cable is permanently attached to the radio. If you wish to remove the radio...
    Start reading Cobra_18wxst Cb Tranciever_manual

    Related Manuals for Cobra_18wxst Cb Tranciever_manual

    All Cobra manuals