Corega Router Broadband Access Bar-SD User Manual

Warranty
Corega International warrants product for two years from date of purchase
against defects in materials and workmanship.  This warranty does not cover
any defects caused by accident, misuse, fair wear and tear, neglect, or an
attempt at repair.  This warranty is offered as an additional benefit to the 
consumer’s statutory rights and does not affect these rights in any way.  
Corega International shall not be held responsible for any special, incidental, 
or consequential damages resulting from...

BROADBAND ACCESS
ROUTER 
HUBS • SWITCHES • ADAPTERS • WIRELESS LAN • USB • KVMs • MEDIA CONVERTERS • ROUTERS • ADSL
BAR-SD
ENGLISH:Pg 1-24
DEUTSCH:Pg 25-48
ITALIANO:Pg 49-72
ESPANOL:Pg 73-96
FRANCAIS:Pg 97-122
	
:Pg 123-144 

1
ENGLISH
Table of Contents
Technical Specification 2
Regulatory Compliance  2
Features 3
Hardware Installation 4
Package Contents4
Front Panel LEDs4
Rear Panel Connections5
Before connecting your Corega BAR-SD Router 5
Computer System Requirements and Setup 6
Installing the Corega BAR-SD Router 6
Internet Access7
Prepare Network Information 7
Web-based User Interface 7
Basic Settings11
PPPoE11
Dynamic IP11
Dynamic IP (Road Runner) 12
Static IP12
PPTP13
DHCP Server13
Change Password14
Virtual Server14...

ENGLISH
2
Interfaces
WAN Port. 10/100BaseTX Fast Ethernet, (Auto MDI)
LAN Ports 4 x 10/100BaseTX Fast Ethernet (Auto MDI)
Indicators
Power (Green)
Status  (Yellow)
WANLink/Activity (Green) Connection and Activity
100M (Green) Port operating at 10 or 100Mbps
LAN (per port)
Link/Activity (Green) Connection and Activity
100M (Green) Port operating at 10 or 100Mbps
Dimensions
153mm x 112.4mm x 31mmWeight
230g
Power Supply
Input 220-250VAC
Output 5V DC, 2A
Temperature and Humidity
Operating 0-40°C, 

3
ENGLISH
Features 
Your Corega BAR-SD Router has the following features:
•Allows multiple users to access the internet at the same time via a single public IP Address using NAT (Network Address Translation).
•Built-in Stateful Inspection Firewall to protect your PCs from outside intruders.
•Integrated four port 10/100Base-TX auto-sensing switch.
•Supports PPPoE allowing users to seamlessly connect to ISPs with the user familiar “dial-up” type connection interface.
•Supports PPTP allowing users to...

Hardware Installation
This chapter describes unpacking, familiarization, and the hardware installation of the Corega BAR-SD Router.
Package Contents
1 x Corega BAR-SD Router 
1 x External Power Adapter
1 x Ethernet Cable
1 x Installation Guide
Front Panel LEDs
The following figure shows the front view of the Corega BAR-SD Router.
PowerGreen Steady on when power is on.
StatusOrange   Flashing in normal operation
WAN (WAN port)
Link/Act Green Steady on when ADSL/Cable modem is properly connected
Flashing...

5
Rear Panel Connections
The following figure shows the rear view of the Corega BAR-SD Broadband Access Router. 
•Init.Press and hold the Initialize button. The Status LED will stop flashing, and then flash 6 times. Then release the button.
•WAN.This port is for connecting to the Wide Area Network using an ADSL or Cable Modem.
•LAN 1-4.These ports are used to connect computers and peripherals to the BAR-SD.
•Power.This socket is used to connect the external power supply to the router.
Before connecting...

Computer System Requirements and Setup
To connect to the internet, an external ADSL or Cable modem and an internet access account from an ISP are required. In order to operate with the Corega BAR-SD Router,
each PC that is to be connected to the Corega BAR-SD Router should have the following installed:
•Ethernet NIC (Network Interface Card: a 10Base-T or 10/100Base-T/TX Ethernet card), or wireless client card for wireless connection.
•System OS: Windows 95, Windows 98, Windows NT4.0, or Windows 2000, or...

7
Internet Access
This chapter describes the procedures necessary too configure the basic functions and to start up your Corega BAR-SD Router. 
Prepare Network Information
Before setting up your Corega BAR-SD Router, Corega suggest that you complete the table below with the necessary information which should be supplied by your ISP. 
This will help when configuring the router.
Provided by some ISPs Host Name:                
Domain Name:               
IP address given by ISP: • Dynamic IP Address
•Fixed...

The “Password” prompt box will appear. Enter the value ‘blank’.
The main Corega BAR-SD Router setup screen offers the user an option to use the setup wizards for the most popular settings of the Corega BAR-SD Router. If you don’t
know which connection type you currently use, call your ISP to get the information.
PPPoE Point to Point Protocol over Ethernet
DHCP Obtain IP automatically or Dynamic IP
Fixed IP or Static IP
PPTP Point to Point Tunnelling Protocol
From the Wizard Screen, select the type of...