dell latitude x200 User Manual
Have a look at the manual dell latitude x200 User Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 327 Dell manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.

Battery: Dell Latitude X200 Service Manual Back to Contents Page Battery Dell™ Latitude™ X200 Service Manual Removing the Battery NOTICE: If you choose to replace the battery with the computer in standby mode, you have up to 1 minute to complete the battery replacement before\ the computer shuts down and loses any unsaved data. 1. Ensure that the computer is turned off, suspended in a power management \ mode, or connected to an electrical outlet. 2. If the computer is docked, undock it. 3. Slide the battery lock latch on the bottom of the computer to the unlock\ position. 4. Slide and hold the battery latch release on the bottom of the computer, \ and then remove the battery from the bay. file:///F|/Service%20Manuals/Dell/Latitude/x200/battery.htm (1 of 3) [\ 2/28/2004 8:23:56 AM]

Battery: Dell Latitude X200 Service Manual 1 battery lock latch 2 battery latch release Replacing the Battery CAUTION: Use only Dell™ battery modules that are approved for use with this computer. Use of other types may increase the risk of fire or \ explosion. 1. Slide the battery into the bay until the latch release clicks. 2. Slide the battery lock latch into the lock position. file:///F|/Service%20Manuals/Dell/Latitude/x200/battery.htm (2 of 3) [\ 2/28/2004 8:23:56 AM]

Battery: Dell Latitude X200 Service Manual Back to Contents Page file:///F|/Service%20Manuals/Dell/Latitude/x200/battery.htm (3 of 3) [\ 2/28/2004 8:23:56 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual Back to Contents Page Memory Module and Mini PCI Card Dell™ Latitude™ X200 Service Manual Memory Module Mini PCI Card Memory Module Removing the Memory Module Cover NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. NOTICE: Read Preparing to Work Inside the Computer before performing the following procedure. 1. If the computer is docked, undock it. 2. Turn the computer over, loosen the captive screw from the memory module \ cover, and lift the cover. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (1 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual 1 captive screw 2 memory module cover Removing the Memory Module NOTICE: To prevent damage to the memory module connector, do not use tools to spread the inner metal tabs that secure the memory module. NOTICE: Handle memory modules by their edges, and do not touch the components on a module. 1. Use your fingertips to spread apart the securing clips on each end of th\ e memory module connector. The module should pop up. 2. Remove the module from the connector. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (2 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual 1 memory module 2 securing clips (2) Replacing the Memory Module 1. Ground yourself and install the new memory module: a. Align the notch in the module with the slot in the center of the connect\ or. b. Slide the edge of the module firmly into the connector, and rotate the module down until you hear a click. If you do not hear the click, remove\ the module and reinstall it. NOTE: If the memory module is not installed properly, the computer does not boot. No error message indicates this failure. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (3 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual 2. Replace the memory module cover and tighten the captive screw. NOTICE: If the memory module cover is difficult to close, remove the module and reinstall it. Forcing the cover to close may damage your computer. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (4 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual 1captive screw 2 memory module cover 3. Insert the battery into the battery bay, or connect the AC adapter to yo\ ur computer and an electrical outlet. 4. Turn on the computer. As the computer boots, it detects the additional memory and automaticall\ y updates the system configuration information. Mini PCI Card Removing the Mini PCI Card Cover NOTICE: Disconnect the computer and any attached devices from electrical outlets, and remove any installed batteries. NOTICE: To avoid ESD, ground yourself by using a wrist grounding strap or by touching an unpainted metal surface on the computer. NOTICE: Read Preparing to Work Inside the Computer before performing the following procedure. 1. If the computer is docked, undock it. 2. Turn the computer over, loosen the captive screw from the Mini PCI card \ cover, and lift the cover. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (5 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual 1 captive screw 2 Mini PCI card cover Removing the Mini PCI Card 1. Disconnect the antenna cable from the Mini PCI card. 2. Release the Mini PCI card by spreading the metal securing tabs until the\ card pops up slightly. 3. Lift the Mini PCI card out of its connector. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (6 of 8) \ [2/28/2004 8:23:57 AM]

Memory Module and Mini PCI Card: Dell Latitude X200 Service Manual Replacing the Mini PCI Card 1. Align the Mini PCI card with the connector at a 45-degree angle, and pre\ ss the Mini PCI card into the connector. 2. Connect the antenna cable to the antenna connector on the Mini PCI card.\ NOTICE: The connectors are keyed for correct insertion; do not force the connections. 3. Lower the Mini PCI card toward the inner tabs to approximately a 20-degr\ ee angle. 4. Continue lowering the Mini PCI card until it snaps into the inner tabs o\ f the connector. 5. Replace the cover and tighten the captive screw. file:///F|/Service%20Manuals/Dell/Latitude/x200/upgrades.htm (7 of 8) \ [2/28/2004 8:23:57 AM]