Digital Projection Projector IVision50-series User Manual

							61
8 Technical specifications
Please see www.digitalprojection.com for more technical information.
english  
						

							62iVision50-series  
User Manual - Technical specifications
english  
						

							63
9 Lamp change
The indicator on the keypad will turn RED when lamp life is expired. Change the lamp when 
lifetime expires. Always replace lamp with the same type and rating. USE ORIGINAL LAMPS 
O N LY. The lamp holder employs an electronic lamp timer that is tracking the life time of the 
lamp. Always disconnect the power cord and wait until the projector has cooled down (60 
minutes) before opening the lamp cover. 
Be careful not to touch the protective glass when replacing the lamp,   
this may cause the protective glass to overheat and break while in use.
Be extremely careful when removing the lamp module. In the unlikely event that 
the bulb ruptures, small glass fragments may be generated. The lamp module is 
designed to contain these fragments, but use caution when removing the lamp 
module.
Remove the used lamp:
1.
 
Unscr
 ew the lamp door screw
2.
 
Open the lamp door
3.

 
Unscr
 ew the three screws that hold the lamp in place
4.
 
Pull the lamp out using the handle
Replace with a new lamp in r

everse order:
1.
 
Insert a new lamp. Observe the guide pins and make sur
 e the lamp is fully inserted
2.
 
Fasten the thr
 ee screws securely
3.
 
Close the lamp door
4.

 
T
 ighten the lamp door screw firmlyIn the unlikely event of a lamp rapture, a limited amount of mercury vapour   
may be emitted into the room. To avoid inhaling this mercury vapour (which is 
toxic, and can be harmful for lungs and nervous system) the room should be 
thoroughly ventilated for a period of at least 30 minutes. There are no known 
health hazards from exposure to lamps that are intact and which are used within 
an enclosed fixture. No adverse effects are expected from occasional exposure 
to broken lamps. As a matter of good practise, avoid prolonged or frequent 
exposure to lamps unless there is adequate ventilation. The major hazard from 
broken lamps is the possibility of sustaining glass cuts.
english  
						

							64iVision50-series  
User Manual - Lamp change
english  
						

							601-0347-00
digital projection  locations
North America Corporate Headquarters
Digital Projection, Inc.
55 Chastain Road, NW, Suite 115
Kennesaw, GA 30144
(P) 770.420.1350
(F) 770.420.1360
 
Worldwide Headquarters
Digital Projection Ltd.
Greenside Way,
Middleton,
Manchester
M24 1XX
(P) +44 (0) 161 947 3300
(F) +44 (0) 161 684 7674
 
China Corporate Headquarters
DP China
Rm C1202,Cai Fu Jia Y
uan,No.19
Xiao Ying Street, Chaoyang District,Beijing 100101,PR China
(P) (8610)010-58239771/ 72    
(F) 010-58239770
Asia Corporate Headquarters
DP Asia
16 New Industrial Road
#02-10 Hudson Technocentre
Singapore 536204
(P) 65-6284-1138
(F) 65-6284-1238
www.digitalprojection.com